NETKEY NetKey Category 5e, 6 & 6A Jack Modules NETWORK COMPONENTS Part Number: NKP5E88M**, NK688M**, NK6X88M** CONTRACTOR GRADE INSTALLATION INSTRUCTIONS © Panduit Corp. 2013 NK406C Retention Cap 1 Orient jack as shown Label Notch Puck (NKSPB) 2 3 CWST T568B T568A P4 P3 P4 P2 P1 P2 P1 P3 1.5" (38.1mm) Trim pair separator and/or filler if present. 4 Option 1 Option 2 5 (T568B shown) T568 BA BA T568 BA BA PDT110 Tool Do not untwist more then 1/8" from the IDC tower (T568B shown) ** Denotes color. For Technical Support: www.panduit.com/resources/install_maintain.asp Page 1 of 2 © Panduit Corp. 2013 INSTALLATION INSTRUCTIONS NK406C 7 T568 BA BA 8 9 10 11 Depress latch on jack and gently tilt out. Notes: 1. For specified performance, follow TIA/EIA 568-B installation guidelines. 2. Jack Modules can terminate PVC or Plenum rated 22-26 AWG solid or stranded IWC cable with 0.048 inch (1.2 mm) maximum insulated conductor outside diameter. 3. Jack Modules may be re-terminated a minimum of 20 times. 4. For technical and performance information, consult PANDUIT Technical Support. As with all Communication Components, the following statements apply: 1. Never install communications wiring during a lightning storm. 2. Never install communications wiring in wet locations unless the jack is specifically designed for use in wet locations. 3. Never touch uninsulated communications wiring or terminals unless the communication line has been disconnected at the network interface. 4. Use caution when installing or modifying communication wiring. E-mail: [email protected] For Instructions in Local Languages and Technical Support: www.panduit.com/resources/install_maintain.asp www.panduit.com Page 2 of 2 Phone: 866-405-6654