Standard Power Integrated Module flow90PACK1 Features: flow90PACK 1 up to 600V/75A, 1200V/35A x 3 ~ IGBT inverter x Temperature Sensor x Vincotech - power flow through for simple PCB routing x Vincotech - Clip In the reliable interconnection between PCB, module and heatsink x x 600V trench fieldstop 1,2kV trench Fieldstop Dedicated for motor drive applications with a mechanic arrangement of 90° between heat-sink and PCB Module Types Vincotech part number selection data: 600V Trench-Fieldstop 600V / 30A 600V / 50A 600V / 75A 1200V Trench-Fieldstop 1200V / 15A 1200V / 25A 1200V / 35A Copyright by Vincotech V23990-P704-F V23990-P705-F V23990-P706-F V23990-P708-F V23990-P709-F V23990-P700-F 1 Revision: 1 V23990-P70X-A flow90PACK1 V23990-P70X-F-U-01-14 Outline / Pinout Schematics Copyright by Vincotech 2 Revision: 1 flow90PACK1 V23990-P70X-A V23990-P70X-F-U-01-14 Handling Instruction Handling Instructions... … to the PCB x The module must be fixed to the PCB by clipping into the adequate holes before pin soldering. See below x After fixing all pins must be soldered into the PCB. x During assembly, at a max. module temperature of 25°C, the pins should not be drawn or pushed more than ±0.2 mm or loaded with a higher force than 35N. x At a maximum substrate-temperature of 100°C the load of the pin should not exceed ±5N. x Vibration stress on pins is not allowed ...to the heat sink x the heat sink surface must be clean and particle less. x the flatness must be < 0.05 mm for 100 mm continuous. x the surface roughness should be less than RZ = 0.01 mm. ...to the thermal paste x homogenous applying of the thermal conducting paste over the whole module plate with a thickness of max. 0.05 mm. x Thicker thermal paste can raise the value of the Rth. ...to the fastening screws to the heat sink if plain washer is used and optional with a spring lock washer Important parameter screw flat washer spring washer mounting torque Copyright by Vincotech M4 DIN 7985 DIN 125 or DIN 433 DIN 127 or DIN 128 Ma =2.0-2.2Nm 3 Revision: 1