The following document contains information on Cypress products. CM71-10146-3ET1 Errata This errata sheet is for MB91660 Series Hardware Manual Rev. 3 (CM71-10146-3E). FR80 32-BIT MICROCONTROLLER MB91660 Series HARDWARE MANUAL 2011.12.16 :Corrected part Date 2011/ 12/16 Page 975 Item 28.16.1 Description The following <Notes> was corrected as indicated by the shading below. ・When the reload value is even-numbered, the "H" and "L" widths of the serial clock are as shown below, depending on the SCINV bit settings. When the reload value is odd-numbered,the "L" width is the same as the "H" width. - When SPI is set to "0" and SCINV is set to "0", the "H" width of the serial clock is one peripheral clock (PCLK) cycle longer. - When SPI is set to "0" and SCINV is set to "1", the "L" width of the serial clock is one peripheral clock (PCLK) cycle longer. - When SPI is set to "1" and SCINV is set to "0", the "L" width of the serial clock is one peripheral clock (PCLK) cycle longer. - When SPI is set to "1" and SCINV is set to "1", the "H" width of the serial clock is one peripheral clock (PCLK) cycle longer. [mcu_doc1144] 1/1