Datasheet

UNISONIC TECHNOLOGIES CO., LTD
U74LVC2G241
CMOS IC
DUAL BUFFER/LINE DRIVER
WITH 3-STATE OUTPUT

DESCRIPTION
The U74LVC2G241 is designed specifically to improve both the
performance and density of 3-state memory-address drivers, clock
drivers, and bus-oriented receivers and transmitters.
The U74LVC2G241 is organized as two 1-bit line drivers with
SOP-8
separate output-enable(1 OE , 2OE) intputs, When 1 OE is low and
2OE is high, the device passes data from the A inputs to the Y
output. When 1 OE is high and 2OE is low, the output are in the
high-impedance state.
To ensure the high-impedance state during power up or power
down, OE should be tied to VCC through a pull up resistor, and OE
should be tied to GND through a pull down resistor, the minimum
value of the resistor is determined by the current-sinking or the
current-sourcing capability of the driver.

FEATURES
* Wide supply voltage range from 1.65V to 5.5V
* Inputs accept voltages up to 5.5V
* IOFF supports partial-power-down mode
* Low static power consumption; ICC=10μA (Max.)

ORDERING INFORMATION
Ordering Number
U74LVC2G241G-S08-R

Package
SOP-8
Packing
Tape Reel
MARKING
www.unisonic.com.tw
Copyright © 2016 Unisonic Technologies Co., Ltd
1 of 5
QW-R126-035.A
U74LVC2G241

PIN CONFIGURATION

FUNCTION TABLE
CMOS IC
INPUT( OE )
INPUT(1A)
OUTPUT(1Y)
INPUT(2OE)
INPUT(2A)
L
H
H
H
H
L
L
L
H
L
H
X
Z
L
X
H = High voltage level；L = Low voltage level；X = Don’t care；Z = High-impedance OFF-state

OUTPUT(2Y)
H
L
Z
LOGIC DIAGRAM (positive logic)
Logic symbol
UNISONIC TECHNOLOGIES CO., LTD
www.unisonic.com.tw
2 of 5
QW-R126-035.A
U74LVC2G241

CMOS IC
ABSOLUTE MAXIMUM RATING
PARAMETER
Supply Voltage
Input Voltage
Output Voltage
SYMBOL
VCC
VIN
VOUT
CONDITIONS
Output in the high or low state
Output in the power-off state
RATINGS
-0.5 ~ +6.5
-0.5 ~ +6.5
-0.5 ~ VCC +0.5
-0.5 ~ +6.5
UNIT
V
V
V
V
Continuous VCC or GND
ICC
±100
mA
Current
Continuous Output Current
IOUT
VOUT=0V ~ VCC
±50
mA
Input Clamp Current
IIK
VIN<0V
-50
mA
Output Clamp Current
IOK
VOUT>VCC or VOUT<0V
-50
mA
Storage Temperature Range
TSTG
-65 ~ +150
°C
Note: Absolute maximum ratings are those values beyond which the device could be permanently damaged.
Absolute maximum ratings are stress ratings only and functional device operation is not implied.

RECOMMENDED OPERATING CONDITIONS
PARAMETER
SYMBOL
TEST CONDITIONS
Operating
Data retention only
Supply Voltage
VCC
Input Voltage
Output Voltage
Operating Temperature
VIN
VOUT
TA
High or low state
Input Transition Rise or Fall
Rate
∆t/∆v
VCC=1.8V±0.15V, 2.5V±0.2V
VCC=3.3V±0.3V
VCC=5V±0.5V

MIN
1.65
1.5
0
0
-40
TYP
MAX
5.5
5.5
VCC
85
20
10
5
UNIT
V
V
V
V
°C
ns/V
ns/V
ns/V
ELECTRICAL CHARACTERISTICS (TA =25°C , unless otherwise specified)
PARAMETER
High-level Input Voltage
Low-level Input Voltage
High-Level Output Voltage
Low-Level Output Voltage
SYMBOL
VIH
VIL
VOH
VOL
TEST CONDITIONS
VCC=1.8±0.15V
VCC=2.5±0.2V
VCC=3.3±0.3V
VCC=5±0.5V
VCC=1.8±0.15V
VCC=2.5±0.2V
VCC=3.3±0.3V
VCC=5±0.5V
VCC=1.65 ~ 5.5V, IOH=-100μA
VCC=1.65V, IOH=-4mA
VCC=2.3V, IOH=-8mA
IOH=-16mA
VCC=3.0V
IOH=-24mA
VCC=4.5V, IOH=-32mA
VCC=1.65 ~ 5.5V, IOH=100μA
VCC=1.65V, IOH=4mA
VCC=2.3V, IOH=8mA
IOH=16mA
VCC=3.0V
IOH=24mA
VCC=4.5V, IOH=32mA
UNISONIC TECHNOLOGIES CO., LTD
www.unisonic.com.tw
MIN
0.65×VCC
1.7
2
0.7×VCC
TYP
MAX
0.35×VCC
0.7
0.8
0.3×VCC
VCC-0.1
1.2
1.9
2.4
2.3
3.8
0.1
0.45
0.3
0.4
0.55
0.55
UNIT
V
V
V
V
V
V
V
V
V
V
V
V
V
V
V
V
V
V
V
V
3 of 5
QW-R126-035.A
U74LVC2G241

ELECTRICAL CHARACTERISTICS (Cont.)
PARAMETER
Input Leakage Current
Power OFF Leakage Current
OFF-state output current
Quiescent Supply Current
Additional Quiescent Supply
Current Per Input Pin
Input Capacitance
Output Capacitance

CMOS IC
SYMBOL
TEST CONDITIONS
II(LEAK)
VCC=0 ~ 5.5V, VIN=5.5V or GND
Ioff
VCC=0V, VIN or VOUT=5.5V
VCC=3.6V, VIN = VIH or VIL,
IOZ
VOUT=5.5V or GND
VCC=1.65 ~ 5.5V,
ICC
VIN=VCC or GND, IOUT=0
VCC=3 ~ 5.5V, One input at
VCC-0.6V, Other inputs at VCC or
∆ICC
GND
CI
VCC=3.3V, VIN=VCC or GND
CO
VCC=3.3V, VOUT=VCC or GND
TYP
MAX
±5
±10
UNIT
μA
μA
10
μA
10
μA
500
μA
3.5
6.5
pF
pF
SWITCHING CHARACTERISTICS (TA =25°C , unless otherwise specified)
PARAMETER
SYMBOL
Propagation delay from
inputs (A) to output(Y)
tPD
Propagation delay from input
( OE ) to output(Y)
ten
Propagation delay from input
( OE ) to output(Y)
tdis
Propagation delay from input
(OE) to output(Y)
ten
Propagation delay from input
(OE) to output(Y)
tdis

MIN
TEST CONDITIONS
VCC=1.8±0.15V,CL=30pF, RL=1kΩ
VCC=2.5±0.2V,CL=30pF, RL=500Ω
VCC=3.3±0.3V,CL=50pF, RL=500Ω
VCC=5±0.5V,CL=50pF, RL=500Ω
VCC=1.8±0.15V,CL=30pF, RL=1kΩ
VCC=2.5±0.2V,CL=30pF, RL=500Ω
VCC=3.3±0.3V,CL=50pF, RL=500Ω
VCC=5±0.5V,CL=50pF, RL=500Ω
VCC=1.8±0.15V,CL=30pF, RL=1kΩ
VCC=2.5±0.2V,CL=30pF, RL=500Ω
VCC=3.3±0.3V,CL=50pF, RL=500Ω
VCC=5±0.5V,CL=50pF, RL=500Ω
VCC=1.8±0.15V,CL=30pF, RL=1kΩ
VCC=2.5±0.2V,CL=30pF, RL=500Ω
VCC=3.3±0.3V,CL=50pF, RL=500Ω
VCC=5±0.5V,CL=50pF, RL=500Ω
VCC=1.8±0.15V,CL=30pF, RL=1kΩ
VCC=2.5±0.2V,CL=30pF, RL=500Ω
VCC=3.3±0.3V,CL=50pF, RL=500Ω
VCC=5±0.5V,CL=50pF, RL=500Ω
MIN
3.3
1.5
1.4
1
4
1.9
1.2
1.2
1.5
1
1.4
1
3.2
1.5
1.6
1.1
1.7
1
1
1
TYP
MAX
8.8
4.8
4.3
3.7
9.9
5.6
4.7
3.8
11.6
5.8
4.4
3.4
8.8
4.7
4.1
3.3
12.5
5.2
4.2
3.3
UNIT
ns
ns
ns
ns
ns
ns
ns
ns
ns
ns
ns
ns
ns
ns
ns
ns
ns
ns
ns
ns
MAX
UNIT
pF
pF
pF
pF
pF
pF
pF
pF
OPERATING CHARACTERISTICS (f=10MHz, TA =25°C , unless otherwise specified)
PARAMETER
SYMBOL
Output enabled
Power
Dissipation
Capacitance
CPD
Output disabled
TEST CONDITIONS
VCC=1.8V
VCC=2.5V
VCC=3.3V
VCC=5V
VCC=1.8V
VCC=2.5V
VCC=3.3V
VCC=5V
UNISONIC TECHNOLOGIES CO., LTD
www.unisonic.com.tw
MIN
TYP
19
19
20
22
2
2
2
3
4 of 5
QW-R126-035.A
U74LVC2G241

CMOS IC
TEST CIRCUIT AND WAVEFORMS
Note: CL includes probe and jig capacitance.
VCC
1.8V±0.15V
2.5V±0.2V
3.3V±0.3V
5V±0.5V
VIN
VCC
VCC
3V
VCC
t R / tF
≤2ns
≤2ns
≤2.5ns
≤2.5ns
VM
VCC/2
VCC/2
1.5V
VCC/2
VLOAD
2×VCC
2×VCC
6V
2×VCC
CL
30pF
30pF
50pF
50pF
V△
0.15V
0.15V
0.3V
0.3V
RL
1KΩ
500Ω
500Ω
500Ω
VIN
Timing
Input
VM
0V
tSU
th
tW
VIN
VIN
Data
Input
Input
VM
VM
VM
VM
0V
0V
VIN
Input
VM
VM
tPLH
tPHL
VIN
Input
0V
VM
VM
tPZL
0V
tPLZ
VLOAD/2
VOH
Output
VM
VM
Output
VM
VOL+VΔ
VOL
tPLH
tPHL
VOH
Output
VM
VM
VOL
Output
VOL
tPHZ
tPZH
VM
VOH-VΔ
VOH
0V
Notes: 1. CL includes probe and jig capacitance.
2. All input pulses are supplied by generators having the following characteristics: PRR ≤10MHz, ZO = 50Ω.
UTC assumes no responsibility for equipment failures that result from using products at values that
exceed, even momentarily, rated values (such as maximum ratings, operating condition ranges, or
other parameters) listed in products specifications of any and all UTC products described or contained
herein. UTC products are not designed for use in life support appliances, devices or systems where
malfunction of these products can be reasonably expected to result in personal injury. Reproduction in
whole or in part is prohibited without the prior written consent of the copyright owner. The information
presented in this document does not form part of any quotation or contract, is believed to be accurate
and reliable and may be changed without notice.
UNISONIC TECHNOLOGIES CO., LTD
www.unisonic.com.tw
5 of 5
QW-R126-035.A