UNISONIC TECHNOLOGIES CO., LTD DTB123Y PNP SILICON TRANSISTOR DIGITAL TRANSISTORS (BUILT- IN BIAS RESISTORS) 3 2 FEATURES 1 SOT-23 (JEDEC TO-236) * Built-in bias resistors that implies easy ON/OFF applications. * The bias resistors are thin-film resistors with complete isolation to allow positive input. 3 2 1 SOT-323 EQUIVALENT CIRCUIT 1 TO-92 ORDERING INFORMATION Ordering Number Lead Free Halogen Free DTB123YG-AE3-R DTB123YG-AL3-R DTB123YL-T92-K DTB123YG-T92-K DTB123YL-T92-B DTB123YG-T92-B Note: Pin assignment: G: GND I: IN O: OUT Package SOT-23 SOT-323 TO-92 TO-92 1 G G G G Pin Assignment 2 I I O O 3 O O I I Packing Tape Reel Tape Reel Bluk Tape Box MARKING SOT-23 / SOT-323 TO-92 BC3Y www.unisonic.com.tw Copyright © 2014 Unisonic Technologies Co., Ltd 1 of 3 QW-R220-019.D DTB123Y PNP SILICON TRANSISTOR ABSOLUTE MAXIMUM RATINGS (TA=25°C, unless others specified) PARAMETER SYMBOL VCC VIN IC RATINGS UNIT -50 V -12 ~ +5 V -500 mA SOT-23/ SOT-323 200 mW Power Dissipation PD TO-92 625 mW Junction Temperature TJ +150 °C Storage Temperature TSTG -55 ~ +150 °C Note Absolute maximum ratings are those values beyond which the device could be permanently damaged. Absolute maximum ratings are stress ratings only and functional device operation is not implied. Supply Voltage Input Voltage Output Current ELECTRICAL SPECIFICATIONS (TA=25°C, unless others specified) PARAMETER OFF CHARACTERISTICS Input Voltage SYMBOL VIN(OFF) VIN(ON) VOUT(ON) IIN IOUT(OFF) Output Voltage Input Current Output Current ON CHARACTERISTICS DC Current Gain hFE SMALL SIGNAL CHARACTERISTICS Input Resistance R1 Resistor Ratio R2/R1 Transition Frequency (Note) fT Note: Transition frequency of the device TEST CONDITIONS VCC =-5V, IOUT =-100μA VOUT =-0.3V, IOUT =-20mA IOUT/IIN =-50mA/-2.5mA VIN=-5V VCC =-50V, VIN =0V VOUT =-5V, IOUT =-50mA VCE =-10V, IE =50mA, f=100MHz TYP MAX -0.3 -2 UNIT V -0.1 -0.3 -3.0 -0.5 V mA μA 2.2 4.5 200 2.86 5.5 KΩ 56 1.54 3.6 UNISONIC TECHNOLOGIES CO., LTD www.unisonic.com.tw MIN MHz 2 of 3 QW-R220-019.D DTB123Y PNP SILICON TRANSISTOR TYPICAL CHARACTERISTICS UTC assumes no responsibility for equipment failures that result from using products at values that exceed, even momentarily, rated values (such as maximum ratings, operating condition ranges, or other parameters) listed in products specifications of any and all UTC products described or contained herein. UTC products are not designed for use in life support appliances, devices or systems where malfunction of these products can be reasonably expected to result in personal injury. Reproduction in whole or in part is prohibited without the prior written consent of the copyright owner. The information presented in this document does not form part of any quotation or contract, is believed to be accurate and reliable and may be changed without notice. UNISONIC TECHNOLOGIES CO., LTD www.unisonic.com.tw 3 of 3 QW-R220-019.D