4.075 9.638 9.947 9.627 9.350 9.277 9.094 9.202 R0.150 8.072 R0.511 4.485 4.794 4.959 5.266 5.573 R1.206 6.526 6.938 DETAIL "C" (4 PLCS.) DETAIL "B" (2 PLCS.) "KEEP OUT" AREAS ON BOTTOM OF PCB DUE TO PCB STANDOFFS (8 PLCS.) 2.603 PCB THICKNESS 0.063 8.583 8.699 8.215 8.137 8.242 8.141 7.710 DETAIL "A" (2 PLCS.) 4.752 5.266 5.381 5.844 6.232 6.376 6.830 0.093 0.093 0.050 0.154 135° DETAIL "A" 0.050 DETAIL "B" DETAIL "C" 8) TO BE USED ON THE FOLLOWING PRODUCTS...HH3501, HH3502, HH3503, HH3504, HH3505 6) RUBBER BUTTONS HAVE CONDUCTIVE PILLS ON THE BOTTOM SIDE OF BUTTON. WHEN BUTTON IS DEPRESSED IT CLOSES THE CIRCUIT OF INTERLOCKING FINGERS TRACED ON THE TOP OF THE PCB. REFER TO ADDITIONAL "BUTTON CIRCUIT" DRAWING FOR MORE INFORMATION REGARDING THE CIRCUIT TRACES. 7) DIMENSIONS SUBJECT TO CHANGE. 9.028 8.951 APPROX 0.01" CLEARANCE FROM PCB TO SIDEWALL 8.798 8.583 8.368 8.681 NOTES: 1) MAX PCB DIMENSIONS SHOWN 2) SUGGESTED LED: ALLIED P/N: 679-0027 THRU 679-0036 3) SUGGESTED BATTERY TYPE: 20MM COIN CELL TYPE 4) SUGGESTED BATTERY HOLDER: KEYSTONE P/N: 3002 OR 3003 5) SUGGESTED ORDER OF ASSEMBLY: A) PLACE RUBBER KEYPAD INTO RING B) PLACE RING W/KEYPAD INTO CASE C) WHILE HOLDING UPSIDE DOWN PLACE PCB INTOCASE D) SNAP BASE INTO CASE R0.054 (2 PLCS.) 5.964 R0.329 6.235 6.462 6.672 R3.886 5.412 R2.864 DOTTED CIRCLES REPRESENT LOCATION OF BOTTONS ON KEYPAD LOCATION OF LIGHT PIPE 11.600 0.050