maxiFLOWTM Cross Cut High Performance Heat Sinks with Plastic Push Pin ATS PART # ATS-1043-C1-R0 Features & Benefits »» For larger heat sinks and higher pre-loads, push pins with compression springs are an effective mounting choice. The push pin has a flexible barb at the end that is designed to engage with a pre-drilled hole in a PWB. The compression spring adds the necessary force to hold the assembly together. Provides better thermal performance than comparable size straight fin and pin fin heat sinks. HOLE PATTERN B »» Features proven high performance maxiFLOW™ heat sink spread fin array to maximize cooling surfaces. »» Ideal for tight spaced components where wider heat sinks can’t be used. 20.02 .788 »» Provided with pre-assembled thermal interface material centered on base. »» Nylon pushpin with steel compression spring. »» Reccomended through hole size in PCB is 3.00 mm. 50.8 2.0 *Image above is for illustration purposes only. Thermal Performance Thermal Resistance (°c/w UNDUCTED) Air Velocity FT/MIN M/S AIR FLOW STRAIGHT AIR FLOW SIDEWAYS 200 1.0 1.9 3.6 300 1.5 1.6 2.8 400 2.0 1.3 2.1 500 2.5 1.1 1.6 600 3.0 1.0 1.3 Product Details DIMENSION DIMENSION A A 41 mm DIMENSION B BDIMENSION C DIMENSION D INTERFACE MATERIAL INTERFACE MATERIAL DIMENSION DIMENSION C DIMENSION D 45 mm 25 mm 79 mm CHOMERICS T766 FINISH FINISH GREEN ANODIZED Notes: 1) 2) 3) 4) Dimension C = heat sink height from bottom of the base to the top of the fin field. Thermal performance data are provided for reference only. Actual performance may vary by application. ATS reserves the right to update or change its products without notice to improve the design or performance. Contact ATS to learn about custom options available. For more information, to find a distributor or to place an order, visit www.Qats.com or call: 781.769.2800 (North America); +31 (0) 3569 84715 (Europe). REV3_052912