maxiFLOW™ Cross Cut High Performance Heat Sinks with Plastic Push Pin ATS PART # ATS-1042-C1-R0 Features & Benefits » For larger heat sinks and higher pre-loads, push pins with compression springs are an effective mounting choice. The push pin has a flexible barb at the end that is designed to engage with a pre-drilled hole in a PWB. The compression spring adds the necessary force to hold the assembly together. Provides better thermal performance than comparable size straight fin and pin fin heat sinks » Features proven high performance maxiFLOW™ heat sink spread fin array to maximize cooling surfaces » Ideal for tight spaced components where wider heat sinks can’t be used » Provided with pre-assembled thermal interface material centered on base » Nylon push pin with steel compression spring » Reccomended through hole size in PCB is 3.00 mm Thermal Performance *Image above is for illustration purposes only. Thermal Resistance (°c/w UNDUCTED) Air Velocity FT/MIN M/S AIR FLOW STRAIGHT AIR FLOW SIDEWAYS 200 1.0 3.3 5.6 300 1.5 2.5 4.3 400 2.0 2 3.4 500 2.5 1.8 2.6 600 3.0 1.7 2.2 Product Details DIMENSION A DIMENSION B DIMENSION C DIMENSION D INTERFACE MATERIAL FINISH 41 mm 45 mm 15 mm 64 mm CHOMERICS T-766 GREEN ANODIZED Notes: 1) 2) 3) 4) Dimension C = heat sink height from bottom of the base to the top of the fin field. Thermal performance data are provided for reference only. Actual performance may vary by application. ATS reserves the right to update or change its products without notice Contact ATS to learn about custom options available For more information, to find a distributor or to place an order, visit www.qats.com or call: 781.769.2800 (North America); +31 (0) 3569 84715 (Europe). REV1_0908