Product family datasheet HTI Metal halide lamps, single-ended __ Product benefits _ High luminance _ High luminous efficacy and efficiency June 23, 2016, 12:05:33 HTI © 2016, OSRAM GmbH. All rights reserved. Page 1 of 4 Product family datasheet Product line drawing Product line drawing Product line drawing Product line drawing Product line drawing __ June 23, 2016, 12:05:33 HTI © 2016, OSRAM GmbH. All rights reserved. Page 2 of 4 Product family datasheet Technical data Electrical data Dimensions & weight Lifespan Additional product data Capabilities Product description Nominal voltage Nominal current Luminance Color temperature Length Light center length (LCL) Lifespan Base (standard designation) Burning position HTI 150 W 1) 95.0 V 1.6 A 5000 cd/cm² 6500 K 46.0 mm 30.0 mm 750 h GY9.5 Any HTI 152 W 90.0 V 1.7 A 4200 cd/cm² 5000 K 48.0 mm 30.0 mm 2000 h GY9.5 Any 70.0 V 10.0 A 30000 cd/cm² 5500 K 85.0 mm 39.0 mm 500 h GY9.5 p45 95.0 V 13.8 A 26000 cd/cm² 5400 K 135.0 mm 59.0 mm 750 h GY22 HTI 705 W/SE XS 2) HTI 1200 W/SE XS 2) HTI 2500 W/SE XS __ Photometrical data 3) 105 V 23.8 A 30000 cd/cm² 6000 K 180.0 mm 85.0 mm 600 h G22 5) 6) s135 4) 4) s135 Certificates & standards Product description EEI – Energy Label HTI 150 W 1) B HTI 152 W B HTI 705 W/SE XS 2) B 2) B HTI 2500 W/SE XS 3) B HTI 1200 W/SE XS 1) Horizontal arc 2) SE = Single ended/XS = eXtreme Seal (maximum permissible foil temperature 450 °C) 3) Special GY22 base. The ignition voltage may be applied only to the thin pin/XS = eXtreme Seal (maximum permissible foil temperature 450 °C)/Important: The contact pins of the base are short-circuited; the electrode farthest from the base is connected via cable 4) Current strap underneath 5) Special GY22 base. The ignition voltage may be applied only to the thin pin 6) Important: The contact pins of the base are short-circuited; the electrode farthest from the base is connected via cable June 23, 2016, 12:05:33 HTI © 2016, OSRAM GmbH. All rights reserved. Page 3 of 4 Product family datasheet Safety advice Because of their high luminance, UV radiation and high internal pressure during operation, HTI lamps may only be operated in enclosed lamp casings specially constructed for the purpose. Appropriate filters must ensure that UV radiation is reduced to an acceptable level. Mercury is released if the lamp breaks. Special safety precautions must be taken. Information on safety and handling is available on request or can be found in the leaflet included with the lamp or in the operating instructions. Application advice For more detailed application information and graphics please see product datasheet. Disclaimer Subject to change without notice. Errors and omission excepted. Always make sure to use the most recent release. __ June 23, 2016, 12:05:33 HTI © 2016, OSRAM GmbH. All rights reserved. Page 4 of 4