The following document contains information on Cypress products. FUJITSU SEMICONDUCTOR FACT SHEET NP706-00026-1v0-E 32-bit Microcontrollers FM3 Family MB9A130N Series MB9A130N series are highly integrated 32-bit microcontrollers dedicated for embedded controllers with low power consumption mode and competitive cost. MB9A130N series are based on the ARM Cortex-M3 Processor with on-chip Flash memory and SRAM, and has peripheral functions such as Motor Control Timers, ADCs, DACs and Communication interfaces. ■PRODUCT LINEUP ■ FEATURES 32bit ARM Cortex-M3 Core Part number MB9AF MB9AF 131M/N 132M/N Processor version：r2p1 Parameter Clock：Maximum clock frequency：20MHz Flash 64K 128K Base Timer：8 channels (Max.) (Byte) Multi-function Timer：1 unit (Max.) SRAM 12K 16K (Byte) 16-bit free-run timer ×3channels Input capture ×4channels Output compare ×6channels ■ORDERING INFORMATION A/D activating compare ×3channels Waveform generator ×3channels Part number Package 16-bit PPG timer ×3channels Watchdog Timer：1 channel(SW) + 1 channel(HW) MB9AF131MPMC Plastic・LQFP(0.5mm pitch),80-pin Multi-function Serial Interface：8 channels (Max.) (FPT-80P-M37) MB9AF132MPMC Selectable from UART/CSIO/I2C MB9AF131MPMC1 Plastic・LQFP(0.65mm pitch),80-pin Real-time clock：1 unit (FPT-80P-M40) MB9AF132MPMC1 HDMI-CEC / Remote control：2 channels (Max.) MB9AF131NPMC Plastic・LQFP(0.5mm pitch),100-pin External Interrupt Controller Unit (FPT-100P-M23) MB9AF132NPMC - Up to 16 external interrupt input pin - Include one non-maskable interrupt(NMI) MB9AF131NPF Plastic・QFP(0.65mm pitch),100-pin 12-bit A/D Converter MB9AF131M/132M：12 channels (1 units) MB9AF131N/132N：16 channels (1 units) 10-bit D/A Converter：2 channel (Max.) MB9AF132NPF (FPT-100P-M06) MB9AF131NBGL Plastic・PFBGA(0.8mm pitch),112-pin (BGA-112P-M04) MB9AF132NBGL Low Power Consumption Mode 6 low power consumption modes supported SLEEP mode/TIMER mode/RTC mode/STOP mode /Deep stand-by RTC mode/Deep stand-by STOP mode General Purpose I/O port： MB9AF131M/132M：67 (Max.) MB9AF131N/132N：84 (Max.) ■PACKAGE EXAMPLE OF REFERENCE Internal OSC Debug -Serial Wire JTAG Debug Port (SWJ-DP) Low Voltage Detector Clock Super Visor Power Supply: 1.8V to 5.5V Plastic ・ LQFP, 100-pins (FPT-100P-M23) ARM and Cortex are the trademarks of ARM Limited in the EU and other countries. December 2012 1/2 Copyright©2012 FUJITSU SEMICONDUCTOR LIMITED All rights reserved MB9A130N Series ■ BLOCK DIAGRAM MB9AF131/132 ROM Table SWJ-DP Cortex-M3 Core @20MHz(Max) Flash I/F I Multi-layer AHB (Max 20MHz) TRSTX,TCK, TDI,TMS TDO D Sys AHB-APB Bridge: APB0 (Max 20MHz) NVIC Watchdog Timer (Software) Clock Reset Generator INITX Watchdog Timer (Hardware) Security On-Chip Flash 64/128Kbyte SRAM1 12/16Kbyte CSV RST CLK X0 X1 X0A X1A AVCC, AVSS,AVRH Main Osc Sub Osc PLL CR 4MHz CR 100kHz A/D Converter × 1 Deep Standby Ctrl ANxx WKUPx Power On Reset 12-bit A/D Converter ADTGx LVD Ctrl LVD C Regulator IRQ-Monitor TIOBx A/D Activation Compare 3ch. IC0x FRCK0 16-bit Input Capture 4ch. 16-bit FreeRun Timer 3ch. AHB-APB Bridge : APB2 (Max 20MHz) Base Timer 16-bit 8ch./ 32-bit 4ch. TIOAx AHB-APB Bridge : APB1 (Max 20MHz) 10-bit D/A Converter 2ch. DAx HDMI-CEC/ Remote Receiver Control RTCCO SUBOUT Real Time Clock External Interrupt Controller 16-pin + NMI INTxx NMIX MODE-Ctrl MD1, MD0 16-bit Output Compare 6ch. DTTI0X RTO0x CECx P0x, P1x, GPIO PIN-Function-Ctrl Waveform Generator 3ch. Pxx Multi-Function Timer ×1 SCKx SINx SOTx Multi-Function Serial IF 8ch. 16-bit PPG 3ch. IGTRG . . . CTS4 RTS4 HW flow control(ch.4)* ■ STARTER KIT A starter kit for FM3 family is on sale respectively from IAR Systems and KEIL. IAR Systems With IAR Systems starter kit, a high performance board can be used for evaluation. KEIL With KEIL starter kit, a simple board can be used for evaluation. NP706-00026-1v0-E December 2012 2/2 Copyright©2012 FUJITSU SEMICONDUCTOR LIMITED All rights reserved