225 KB

The following document contains information on Cypress products.
FUJITSU SEMICONDUCTOR
FACT SHEET
NP706-00011-1v0-E
32-bit Microcontrollers
FM3 Family MB9B210T Series
MB9B210T series are highly integrated 32-bit microcontrollers dedicated for embedded controllers with high-performance
and competitive cost. MB9B210T series are based on the ARM Cortex-M3 Processor with Flash memory and SRAM, and has
peripheral functions such as Motor Control timers, ADCs, and Communication interfaces.
■ FEATURES
 32bit ARM Cortex-M3 Core
■PRODUCT LINEUP
Part number
MB9BF216S/T
MB9BF217S/T
MB9BF218S/T
Flash
(Byte)
512K
768K
1M
RAM
(Byte)
64K
96K
128K
Processor version:r2p1
Parameter
 Clock
Maximum clock frequency:144MHz
 Base Timer:16 channels(Max.)
 Multi-function Timer:3 units(Max.)
16-bit free-run timer ×3channels/unit
Input capture ×4channels/unit
Output compare ×6channels/unit
A/D activating compare ×3channels/unit
Waveform generator ×3channels/unit
16-bit PPG timer ×3channels/unit
QPRC:3 channels(Max.)
Dual Timer:1 unit
Watch dog Timer:1 channel(SW) + 1 channel(HW)
USB2.0(Function/Host):2 channels(Max.)
■ORDERING INFORMATION
Part number




 Ethernet-MAC
1 channel(Max.) MII:1ch(Max.)/RMII:1ch(Max.)
 Multi-function Serial Interface:8 channels(Max.)
Selectable from UART/CSIO/LIN/I2C
MB9BF216SPMC
MB9BF217SPMC
MB9BF218SPMC
MB9BF216TPMC
MB9BF217TPMC
MB9BF218TPMC
MB9BF216TBGL
MB9BF217TBGL
MB9BF218TBGL
Package
Plastic・LQFP(0.5mm pitch),144-pin
(FPT-144P-M08)
Plastic・LQFP(0.5mm pitch),176-pin
(FPT-176P-M07)
Plastic・PFBGA(0.8mm pitch),192-pin
(BGA-192P-M06)
■PACKAGE EXAMPLE OF REFERENCE
 External Bus Interface
 DMA Controller:8 channels
 External Interrupt Controller Unit
- Up to 32 external vectors
- Include one non-maskable interrupt(NMI)
 12-bit A/D Converter:
MB9BF216S/217S/218S:24 channels(3 units)
MB9BF216T/217T/218T:32 channels(3 units)
 Low Power Mode
Sleep mode/Timer mode/Stop mode supported
Plastic ・ LQFP, 176-pins
(FPT-176P-M07)
 General Purpose I/O port
MB9BF216S/217S/218S:122(Max.)
MB9BF216T/217T/218T:154(Max.)
 Debug
-Serial Wire JTAG Debug Port (SWJ-DP)
-Embedded Trace Macrocells (ETM)
 Low Voltage Detector
 Clock Super Visor
 Power Supply:2.7V to 5.5V
ARM and Cortex are the trademarks of ARM Limited in the EU and other countries.
April 2012
1/2
Copyright©2011-2012 FUJITSU SEMICONDUCTOR LIMITED All rights reserved
MB9B210T Series
■ BLOCK DIAGRAM
MB9BF216/217/218
TDO
TRACED [3:0],
TRACECLK
SWJ -DP
ETM
TPIU
ROM
Table
SRAM 0
32/48/64Kbyte
Cortex -M3 Core
144MHz (Max .)
I
Multi-layer AHB (Max.144MHz)
TRST X,TCK
TDI,TMS
D
MPU NVIC
Sys
AHB-APB Bridge:
APB0(Max.72MHz)
Dual -Timer
WatchDog Timer
(Software )
Clock Reset
Generator
INITX
WatchDog Timer
(Hardware )
On-chip Flash
512Kbyte /
768Kbyte /
1024 Kbyte
Flash I /F
Security
Trace Buffer
(16Kbyte )
SRAM 1
32/48/64Kbyte
USB 2.0
(Host /
Func )
USB 2.0
(Host/
Func )
PHY
USBVCC 0
UDP 0,UDM 0
UHCONX 0
PHY
USBVCC 1
UDP 1,UDM 1
UHCONX 1
CSV
X1
X0A
X1A
AVCC ,
AVSS ,AVRH
AHB-AHBBridge
(Slave)
Main
Osc
Sub.
Osc
X0
DMAC
8ch
RST
CLK
PLL
CR
4MHz
CR
100 KHz
A/D Converter x 3
Slave
Master
12bit A /D Converter
Ethernet
MAC
AN[31:0]
MAD[24:00]
12bit A /D Converter
External Bus IF
ADTG [8:0]
MADATA[15:00]
12bit A /D Converter
AIN[2:0]
QPRC
3ch
BIN[2:0]
ZIN[2:0]
A/D Activation
Compare
3ch
IC0[3:0]
16-bit Input Capture
4ch
IC1[3:0]
IC2[3:0]
16-bit Free -run Timer
3ch
FRCK [2:0]
USB-Ethernet Clk Ctrl
AHB-APB Bridge : APB2 ( Max.72MHz)
T IOB[15:00]
AHB-APB Bridge : APB1 (Max.72MHz)
Base Timer
16-bit 16ch/
32-bit 8ch
TIOA [15:00]
PLL
LVD Ctrl
Power On
Reset
MCSX [7:0],
MOEX ,MWEX ,
MNALE ,
MNCLE ,
MNWEX ,
MNREX ,
MDQM [1:0]
LVD
Regulator
C
IRQ-Monitor
CRC
Accelerator
Watch Counter
External Interrupt
Controller
32-pin + NMI
INT[31:00]
NMIX
MODE -Ctrl
16-bit Output
Compare
6ch
DTTI [2:0]X
RTO 0[5:0]
RTO 1[5:0]
RTO 2[5:0]
MII or
RMII
MD[1:0]
P0[F:0],
P1[F:0],
GPIO
Waveform Generator
3ch
PIN -Function -Ctrl
Px[x:0]
Multi Serial IF
8ch
(with FIFO ch .4-ch.7)
16-bit PPG
3ch
HW flow control (ch.4)
Multi Function Timer x 3
SCK [7:0]
SIN[7:0]
SOT[7:0]
CTS 4
RTS 4
Note: The following items vary depending on the package.
A) External bus address
B) 12bit A/D converter channel
■ STARTER KIT
A starter kit for FM3 family is on sale respectively from IAR Systems and KEIL.
 IAR Systems
With IAR Systems starter kit, a high performance board can be used for evaluation.
 KEIL
With KEIL starter kit, a simple board can be used for evaluation.
NP706-00011-1v0-E
April 2012
2/2
Copyright©2011-2012 FUJITSU SEMICONDUCTOR LIMITED All rights reserved