Introducing Abracon’s Sync’n-Go 10 MHZ Portable Precision-Frequency-Reference Most professional test and measurement equipment offering high accuracy and precision; has an input for an external 10MHz frequency reference. Test Labs and Design facilities often have their 10MHz reference signals distributed from a common standard, or they have bulky bench devices, which makes them unsuitable for portable use. ABRACON offers a pocket-size portable solution – SYNC-n-Go How it Works…. Ensure that the Sync’n-Go is charged via the mini USB connectorized wall charger Synchronize the Sync’n Go’s internal Stratum-III oscillator to a more accurate reference (e.g. GPSDO, Rubidium standard, etc.) at the push of a button. To Sync the device up to an external reference, the reference signal must be connected to the ‘Ref In’ connector. Next, press the ‘Synchronize’ button. If the reference signal is stable, the Sync’n Go will synchronize, and the ‘Lock’ LED will turn yellow then • Standalone precision 10MHz Synchronized reference green & then turn itself off indicating that the Sync-n-Go • Fully automated synchronization to an external is now locked to the external reference. reference at the press of a button. • Excellent Portability - 89 x 36mm for bench or field In case the LED starts to flash red, the Sync’n Go could • Very low Phase Noise not synchronize to the external signal, due to excessive (-122dBc/Hz at 100Hz offset),< -160dBc/Hz floor jitter or incorrect input frequency (other than 10MHz). • Frequency drift < +/-25ppb over (25°C +/-10°C) • Typical stability <+/-100ppb over (0°C to +60°C) Connect the ‘Out’ SMA connector to your test • LED’s for lock, battery status and output equipment or measurement system and press the • Typical 8dBm Sine wave O/P (min 6dBm). ‘power’ button and the ‘On’ LED will turn green • 10 hour minimum standalone operation indicating 10MHz reference is available. • Rechargeable via mini USB connector from PC or charger Watch more about Sync’n-Go on YouTube • Robust construction (Machined Aluminium Enclosure) www.youtube.com/user/AbraconCorp Key Features: Typical Phase Noise @ Offset from Carrier 1Hz offset -60dBcHz 10Hz offset -93dBc/Hz 100Hz offset -122dBc/Hz 1KHz offset -143dBc/Hz 10KHz offset -153dBc/Hz 1MHz offset -157dBc/Hz 5MHz offset -162dBc/Hz Applications: • Mobile testing – Reference for mobile equipment • Convenient hand-held reference when 10MHz standards locally unavailable • Field reference for testing at remote sites • Very low phase noise reference for in-circuit bench testing Links and Resources: http://www.abracon.com/Precisiontiming/SYNC-10MHz.pdf In-Stock @: Farnell & Abracon. LL C