710-0004-01 Instructions This 8 Bit Microchip PIC® Microcontroller Development SchmartModule supports over 100 different PIC® Microcontrollers. This board is fully populated except for the PIC®. You hand solder the PIC using our "EZ" technology, configure the jumpers for you PIC® part number and start programming. At a suggested retail of only $15, no other PIC® development board can come close to giving you the flexibility and low cost as this product. This one board supports almost all of the 8 Bit PICs available in an SOIC package type. Go to: http://www.schmartboard.com/index.asp?page=products_populate d&id=203 It will show you how to configure the board for your specific PIC® Step one: Download the “8 Bit PIC® A Configuration” document at the address above. Step two: Solder your PIC onto the board using SchmartBoard’s “EZ” technology. Instructions are included. Step three: Solder the headers (included) into the “1 to 1 pin-out mapping” and “ICSP” sections of the board. Step four: Configure your jumpers Step five: Power Up and program.