EC-Declaration of Conformity Annex Document number: 2010/16 LMS The conformity of the designated product(s) with the provisions of the European Directive 2006/95/EC is given by the compliance with the following European Standard(s). If not elsewhere/otherwise indicated the edition/amendment as referenced below applies. EN 60669-2-1: 2000 Switches for household and similar fixed electrical installations - Part 2-1: Particular requirements - Electronic switches (IEC 60669-2-1:2002, modified) / Corrected and reprinted in 2007-12 The conformity of the designated product(s) with the provisions of the European Directive 1999/5/EC is given by the compliance with the following European Standard(s). If not elsewhere/otherwise indicated the edition/amendment as referenced below applies. EN 55022: 2006 +A1:2007 Information technology equipment - Radio disturbance characteristics Limits and methods of measurement EN 61000-3-2: 2006 Electromagnetic compatibility (EMC) — Part 3-2: Limits — Limits for harmonic current emissions (equipment input current ≤ 16 A per phase) EN 61000-3-3: 2008 Electromagnetic compatibility (EMC) — Part 3-3: Limits — Limitation of voltage changes, voltage fluctuations and flicker in public low voltage supply systems, for equipment with rated current ≤ 16 A per phase and not subjected to conditional connection EN 55024: 1998*A1:2001+A 2:2003 Information technology equipment - Immunity characteristics - Limits and methods of measurement ETSI EN 300 220-1 V2.1.1: Electromagnetic compatibility and Radio spectrum Matters (ERM); Short Range Devices (SRD); Radio equipment to be used in the 25 MHz to 1 000 MHz frequency range with power levels ranging up to 500 mW; Part 1: Technical characteristics and test methods ETSI EN 300 220-2 V2.1.2: Electromagnetic compatibility and Radio spectrum Matters (ERM); Short Range Devices (SRD); Radio equipment to be used in the 25 MHz to 1 000 MHz frequency range with power levels ranging up to 500 mW; Part 2: Harmonized EN covering essential requirements under article 3.2 of the R&TTE Directive ETSI EN 301 489-1 V1.8.1 Electromagnetic compatibility and Radio spectrum Matters (ERM); Electro Magnetic Compatibility (EMC) standard for radio equipment and services; Part 1: Common technical requirements ETSI EN 301 489-3 V1.4.1 Electromagnetic compatibility and Radio spectrum Matters (ERM); Electro Magnetic Compatibility (EMC) standard for radio equipment and services; Part 3: Specific conditions for Short-Range Devices (SRD) operating on frequencies between 9 kHz and 40 GHz The conformity of the designated product(s) with the provisions of the European Directive 2009/125/EC is given by the compliance with the following European Standard(s): EN 50294: 1998 +A1:2001 +A2:2003 Measurement method of total input power of ballast-lamp circuits 2/3 Form_EC_091028 EC-Declaration of Conformity Attached list Document number: 2010/16 LMS Touch DIM RC Switch RC Touch DIM WCU Touch DIM RMC radio receiver 2-ch. 1-channel radio controled load switch wall transmitter 2-ch. handheld transmitter 4-ch. 3/3 Form_EC_091028