Plastic Packages for Integrated Circuits Package Outline Drawing L16.4x4G 16 LEAD THIN QUAD FLAT NO-LEAD PLASTIC PACKAGE Rev 0, 4/10 4X 1.95 4.00 12X 0.65 A B 13 6 PIN 1 INDEX AREA 6 PIN #1 INDEX AREA 16 1 4.00 12 2 . 10 ± 0 . 10 9 (4X) 4 0.15 8 TOP VIEW 5 0.10 M C A B 16X 0 . 50 ± 0 . 1 4 0.30 ± 0.05 BOTTOM VIEW SEE DETAIL "X" 0.10 C 0.75 C BASE PLANE SEATING PLANE 0.08 C SIDE VIEW ( 3 . 6 TYP ) ( ( 12X 0 . 65 ) 2 . 10 ) C 0 . 2 REF 5 ( 16X 0 . 30 ) 0 . 00 MIN. 0 . 05 MAX. ( 16 X 0 . 70 ) TYPICAL RECOMMENDED LAND PATTERN DETAIL "X" NOTES: 1. Dimensions are in millimeters. Dimensions in ( ) for Reference Only. 2. Dimensioning and tolerancing conform to ASME Y14.5m-1994. 3. Unless otherwise specified, tolerance : Decimal ± 0.05 4. Dimension applies to the metallized terminal and is measured between 0.15mm and 0.30mm from the terminal tip. 5. Tiebar shown (if present) is a non-functional feature. 6. The configuration of the pin #1 identifier is optional, but must be located within the zone indicated. The pin #1 identifier may be 7. JEDEC reference drawing: MO220K. either a mold or mark feature. 1