Plastic Packages for Integrated Circuits Thin Plastic Quad Flatpack Package with Top Exposed Pad (TQFP-TEP) 5 D1 Q64.10x10E 7 64 LEAD THIN PLASTIC QUAD FLATPACK PACKAGE WITH TOP EXPOSED PAD (TQFP-TEP) D1/2 ACD SYMBOL 7 E1 D2 13 4X NOM. MAX A E1/2 5 MIN 0.20 H A-B D E2 13 1.20 A1 0.05 A2 0.95 A -H- 0.05 2 / / 0.10 C ccc -C- SIDE VIEW SEE DETAIL "B" 4 D 1.00 12 1.05 12.00 BSC 4 D1 10.00 BSC 7, 8 D2 7.49 BSC 13 E 12.00 BSC 4 E1 10.00 BSC 7, 8 L 11/13° 0.15 D E2 TOP VIEW NOTES 7.49 BSC 0.45 13 0.60 N 64 e 0.50 BSC 0.75 b 0.17 0.22 0.27 b1 0.17 0.20 0.23 ccc 0.08 ddd 0.08 9 D/2 -D- Rev. 1 7/11 3 NOTES: -A- 3 4 E -Be 3 E/2 N/4 TIPS 0.20 C A-B D 4X SEE DETAIL "A" 8 PLACES BOTTOM VIEW 0° MIN. - 0.05 S 0.08/0.20 R. DATUM A2 PLANE -HA1 0.08 R. MIN. 0.20 MIN. 0.25 0-7° GAUGE PLANE L 1.00 REF. DETAIL "B" ddd M C A -B S D S 9 b WITH LEAD FINISH 1. All dimensions and tolerances per ANSI Y14.5-1982. 2. Datum plane -H- located at mold parting line and coincident with lead, where lead exits plastic body at bottom of parting line. 3. Datums A-B and -D- to be determined at center line between leads where leads exit plastic body at datum plane -H- . 4. To be determined at seating plane -C- . 5. Dimensions D1 and E1 do not include mold protrusion. Allowable mold protrusion is 0.254 mm on D1 and E1 dimensions. 6. "N" is the total number of terminals. 7. These dimensions to be determined at datum plane -H- . 8. The top of package is smaller than the bottom of package by 0.15 millimeters. 9. Dimension b does not include dambar protrusion. allowable dambar protrusion shall be 0.08mm total in excess of the b dimension at maximum material condition. Dambar cannot be located on the lower radius or the foot. 10. Controlling dimension: millimeter. 11. This outline conforms to jedec publication 95 registration MS-026, variations ACB, ACC, ACD & ACE. 12. A1 is defined as the distance from the seating plane to the lowest point of the package body. 13. Dimension D2 and E2 represent the size of the exposed pad. 14. Exposed pad shall be coplanar with bottom of package within 0.05. 15. JEDEC variation. -A,B, OR De/2 3 b 3 0.09/0.16 0.09/0.20 9 -A,B, OR DBASE METAL b1 1 DETAIL "A"