HS-2212M-03-0300 HS-2212M-03-0300 Unipolar 3 - Wire Hall Effect Sensor M12 thread Product image serves as example only. Features Block Diagram VSUP Reverse Voltage & ESD Protection Temperature Dependent Bias Hall Plate Hysteresis Control › Compact size › Various switching sensivity › Customized types aviable Short Circuit Overtemperature ESD Protection Comperator Out Output Switch (open drain) Approvals Functional Safety Features GND Absolute Maximum Ratings Stresses beyond those listed in the “Absolute Maximum Ratings“ may cause permanent damage to the device Functional operation of the device at these conditions is not implied. Exposure to the absolute rating conditions for extended periods will affect device reliability Symbol Parameter VSUP Supply voltage wire colour Min. red Max. Unit - 18 Conditions V t < 1000 h 1) - 28 V t < 96 h 1) - 32 V t < 5 min 1) - 40 V t < 5 x 400 ms 1) with series resistor RV > 100 Ohm VOUT Output voltage V t < 1000 h 1) - 28 V t < 96 h 1) - 32 V t < 5 min 1) - 40 V t < 5 x 400 ms 1) white - 65 mA white - 50 white - 0.5 with series resistor RV > 100 Ohm Output current IO IOR Reverse output current 1) No cumulative stress mA All voltages listed are referenced to ground (GND) Dimensions Wire Assignment Name Function Cable colour VSUP Supply voltage red OUT Output white GND Ground black HS-2212M-03-0300 wire length [mm] Material Information Material Environmental Characteristics Operating temperature Page 1 of 3 Rev. 1.1, 12.02.2016, (006, 009, 008) hs2212m_03_0300_ds_e_1.1 °C - 20 to + 85 PIC Proximity Instrumentation Controls Kontaktbauelemente GmbH Colour Housing Nickel plated brass nickel Cable UL1007/1569, AWG 24 red, white, black Potting compound Epoxy black Nibelungenstr. 5A 90530 Wendelstein, Germany Phone +49 911 99 59 06-0 Fax +49 911 99 59 06-99 [email protected] pic-gmbh.com HS-2212M-03-0300 HS-2212M-03-0300 Unipolar 3 - Wire Hall Effect Sensor M12 thread Characteristics At recommended operation conditions if not otherwise specified in the column "Conditions". Typical characteristics for TJ = 25 °C and VSUP = 12 V Symbol Parameter wire colour Min. Typ. Max. Unit Conditions 1.6 2.4 mA 1 mA Supply ISUP Supply current ISUPhi Reverse current red for VSUP = - 18 V Output VoI Port low output voltage tf Output fall time1) tf Output rise time td Delay time 1) tsamp Output refresh period ten white 0.13 0.4 V Io = 20 mA 0.5 V Io = 25 mA 1 µs 1) µs RL = 820; CL = 20 pF 1 16 1.6 Enable time of output after settling of VSUP VSUP = 12 V; µs 2 2.66 50 µs µs VSUP = 12 V B > Bon + 2 mT or B < Boff - 2 mT Power-on-self-test Self test can be triggered externally; details on request 1) Guaranteed by design Recommended Operating Conditions Symbol Parameter VSUP Supply voltage red VOUT Output voltage white 24 V IOUT Output current white 25 mA Page 2 of 3 Rev. 1.1, 12.02.2016, (006, 009, 008) hs2212m_03_0300_ds_e_1.1 wire colour PIC Proximity Instrumentation Controls Kontaktbauelemente GmbH Min. Max. Unit 2.7 24 V Nibelungenstr. 5A 90530 Wendelstein, Germany Conditions Phone +49 911 99 59 06-0 Fax +49 911 99 59 06-99 [email protected] pic-gmbh.com HS-2212M-03-0300 HS-2212M-03-0300 Unipolar 3 - Wire Hall Effect Sensor M12 thread Magnetic Characteristics Overview Symbol Parameter wire colour BONth ON threshold range 1) 1) - - 30 - - 30 BOOth OFF threshold range Bth Adjustable step size 2) - TC Temperatur compensation of - magnetic thresholds Min. Typ. Max. Unit 30 mT 30 0.5 0 Conditions mT mT - 3000 ppm/K 3) 1) Avaible range 2) Small steps at small values, bigger steps at higher values. May not be undercut 3) Different temperature compensation avaible on request Magnetic Characteristics Switching Type bipolar 1) Temp. koeff. of magnetic thresh. On point BON Off point BOFF TC [ppm/K] Min. [mT] Typ. Max. Min. [mT] Typ. Max. 0 tbd. 5.5 tbd. tbd. 3.5 tbd. A B C D E F Hysteresis BHYS 1) Min. [mT] Typ. Max. - 2.0 - The hysteresis is the difference between the switching points BHYS = BON - BOFF Magnetic Approach (for example) Page 3 of 3 Rev. 1.1, 12.02.2016, (006, 009, 008) hs2212m_03_0300_ds_e_1.1 PIC Proximity Instrumentation Controls Kontaktbauelemente GmbH Nibelungenstr. 5A 90530 Wendelstein, Germany Phone +49 911 99 59 06-0 Fax +49 911 99 59 06-99 [email protected] pic-gmbh.com