Advanced Thermal Solutions, Inc PRODUCT DESIGN REQUEST (PDR) FORM 89-27 Access Road | Norwood, MA 02062 | 781-949-2521 [email protected] Request Date: ______________________ Customer: ______________________ Request for NEW DESIGN Request for DESIGN MODIFICATION (state existing PN: ___________________) See Attached Sheet for Additional Information/Specifications REQUIREMENTS BY PRODUCT TYPE: 1. HEAT SINK Original Requirements (state unit of measurement) Comments/ NEW Requirements *Maximum heat sink height (H) *Maximum heat sink length (L) *Maximum heat sink width (W) *Component Length *Component Width *Component Height from surface of PCB Is Component Overhang allowed (Y/N) *Available Airflow Velocity – Default 200 LFM *Power Dissipation (W) Desired Device Case Temperature (0C?) - Default 105°C Ambient Air Temperature? – Default 55°C Maximum Ambient Required Thermal Resistance (0C /W) - Calculated Interface Material Type, Vendor, PN Anodization/surface finish?– Default Black Anodized Mechanical Attach? – spring-clip, screw set, compression spring Component Type, Vendor, PN Other Special Requirements – BGA? HEAT SPREADER? 2. HEAT SINK CLIP Original Requirements (state unit of measurement) Comments/ NEW Requirements Specify ATS heat sink PN that clip will be designed for Component Type, Vendor, PN Component Length, Width, Height (LWH) Any Material Requirements Other Special Requirements 3. FAN TRAY SYSTEM Original Requirements (state unit of measurement) Comments/ NEW Requirements Fan manufacturer’s name and part number Number of fans Surface finish requirements of fan shroud Other Requirements – Attach separate sheet(s) w/ detailed requirements and manufacturing assembly See attached sheet(s) See attached sheet(s) 4. INSTRUMENTATION PRODUCT – Attach Sheet(s) with requested customization For ATS internal use: Form 7001F-R1 PN Assigned: RAD Number: Form 7001F-R1