CS TM MHA

M
ICROWAVE
A Division of Crystek Corporation
NOTE: Distance from end of cable
center conductor to Ref. Pl is 0.455
NOTES:
1.0 Materials
1.1 Body, Coupling, and Clamp Nuts: Steel. Corrosion Resistant per ASTM-A582.
UNS No. S30300.
1.2 Center Conductor: Beryllium Copper per ASTM-B196. UNS C17300.
1.3 Solder Ferrule: Brass per ASTM-B16. UNS C36000.
1.4
1.5
1.6
1.7
Lock Ring: Beryllium Copper per ASTM-B197. UNS C17200.
Gasket and O-Ring: Silicone Rubber per A-A-59588.
Insulator: PTFE Fluorocarbon per ASTM-D1710.
Dielectric Beads: Polyetherimide Thermoplastic (ULTEM 1000) per ASTM-D5205.
2.0 Finishes
2.1 Center Contact and Solder Ferrule: Gold Plate per ASTM-B488 50 Microinches Min. thickness
over Electrolytic Nickel Plate per ASTM-B689 50 Microinches Min. thickness.
2.2 Body, Coupling, and Clamp Nuts: Passivated per SAE-AMS-2700.
2.3 Gasket, O-Ring, Lock Ring, and Dielectrics: None.
3.0 Interface: TNCA Plug per MIL-STD-348. Figure 313-3.
Page 1 of 3
CRYSTEK
CORPORATION
12730 Commonwealth Drive • Fort Myers, Florida 33913
Phone: 239-561-3311 • 800-237-3061
Fax: 239-561-1025 • www.crystek.com
M
ICROWAVE
A Division of Crystek Corporation
Step 1
1.1 Trim Cable as shown.
Step 2
2.1 Slide clamp nut over cable as shown.
2.2 Insert cable into solder ferrule until forward braid seats then solder both cable braids where
shown.
2.3 Trim cable dielectric flush to solder ferrule.
Step 3
3.1 Slide Ultem dielectric stop over cable center conductor against solder ferrule as shown.
3.2 Solder contact flush against stop to dimension shown.
Page 2 of 3
CRYSTEK
CORPORATION
12730 Commonwealth Drive • Fort Myers, Florida 33913
Phone: 239-561-3311 • 800-237-3061
Fax: 239-561-1025 • www.crystek.com
M
ICROWAVE
A Division of Crystek Corporation
Step 4
4.1 Slide bushing. Forward Ultem stop and forward teflon insulator over contact as shown.
(Note: orient bushing with deeper smaller diameter c’bore toward solder ferrule. Orient forward
TFE insulator with shoulder toward stop.)
Step 5
5.1 Insert cable/contact sub-assembly into connector until seated and tighten clamp nut
to 35-45 in-lbs.
Product Control:
Crystek Part Number:
CS-TM-MHA
Release Date:
04-Jan-11
Revision Level:
A
Responsible:
K. Piotrowicz
CRYSTEK
CORPORATION
Page 3 of 3
12730 Commonwealth Drive • Fort Myers, Florida 33913
Phone: 239-561-3311 • 800-237-3061
Fax: 239-561-1025 • www.crystek.com