CRYSTEKMICROWAVE CS-NM-MSD

M
ICROWAVE
A Division of Crystek Corporation
NOTE: Distance from end of cable
center conductor to Ref. Pl is 0.735
NOTES:
1.0 Materials
1.1 Body, Coupling, and Clamp Nuts: Steel. Corrosion Resistant per ASTM-A582.
UNS No. S30300.
1.2 Center Conductor: Beryllium Copper per ASTM-B196. UNS C17300.
1.3 Solder Ferrule: Brass per ASTM-B16. UNS C36000.
1.4
1.5
1.6
1.7
Lock Ring: Beryllium Copper per ASTM-B197. UNS C17200.
Gasket: Silicone Rubber per A-A-59588.
Insulator: PTFE Fluorocarbon per ASTM-D1710.
Cable Stop: Polyetherimide thermoplastic (ULTEM 1000) per ASTM-D5205.
2.0 Finishes
2.1 Center Contact and Solder Ferrule: Gold Plate per ASTM-B488 50 Microinches Min. thickness
over Electrolytic Nickel Plate per ASTM-B689 50 Microinches Min. thickness.
2.2 Body, Coupling, and Clamp Nuts: Passivated per SAE-AMS-2700.
2.3 Gasket, Lock Ring, and Dielectrics: None.
3.0 Interface: Type N plug per Crystek interface specification CC-PNP-TL.
Page 1 of 2
CRYSTEK
CORPORATION
12730 Commonwealth Drive • Fort Myers, Florida 33913
Phone: 239-561-3311 • 800-237-3061
Fax: 239-561-1025 • www.crystek.com
M
ICROWAVE
A Division of Crystek Corporation
Step 1
1.1 Trim Cable as shown.
2.1
2.2
2.3
2.4
Step 2
Step 3
Slide clamp nut over cable as shown.
Insert cable into solder ferrule until cable dielectric is flush with solder face of ferrule.
Solder both cable braids where shown.
Slide dielectric stop over cable center conductor and solder contact flush against stop to
dimension shown.
3.1 Insert forward insulator into connector in orientation shown.
3.2 Insert cable/contact sub-assembly into connector until seated and tighten clamp nut to
35-45 in-lbs.
Product Control:
Crystek Part Number:
CS-NM-MSD
Release Date:
04-Jan-11
Revision Level:
A
Responsible:
K. Piotrowicz
CRYSTEK
CORPORATION
Page 2 of 2
12730 Commonwealth Drive • Fort Myers, Florida 33913
Phone: 239-561-3311 • 800-237-3061
Fax: 239-561-1025 • www.crystek.com