DATASHEET To request the full datasheet, please visit www.intersil.com/products/TW8824 LCD Video Processor with Built-in Decoder, TTL Inputs, BT.656 Output and LVDS Panel Interface TW8824 Features The TW8824 is a highly integrated LCD video processor that incorporates many of the key features required to create a multipurpose LCD display system into a single package. This includes a high quality 2D comb NTSC/PAL/SECAM video decoder, which supports both single-ended and differential CVBS signals, a digital RGB input interface, high quality scaler and deinterlacer, a Font OSD engine and LVDS, TTL or TCON output panel interfaces. The TW8824 can support input resolutions up to 1080p and can drive LCD panels at resolutions up to 1366x768. The TW8824’s video processing capability includes arbitrary H/V scaling, panoramic scaling, image mirroring, image adjustment and enhancement, black and white stretch, etc. This device can support fast boot system requirements and provides stability and reliability to the system due to the fact that it is a hardwired solution that can sync to the video source and display an image on the LCD in less than 0.5 seconds from start-up. The feature set and versatility of this device makes it an ideal solution for in-car LCD display applications. Analog Video Decoder Applications • Digital horizontal PLL and advanced synchronization processing for VCR playback and weak signal performance • Automotive display systems • High quality horizontal and vertical filtered down scaling with arbitrary scale down ratio • NTSC (M, 4.43) and PAL (B, D, G, H, I, M, N, N combination), PAL (60), SECAM with automatic format detection • 10-bit ADC and analog clamping circuit • Fully programmable static gain or automatic gain control for CVBS channel • Programmable white peak control for the CVBS channel • High quality adaptive 2D comb filter for both NTSC and PAL inputs • PAL delay line for color phase error correction • Image enhancement with 2D dynamic peaking/CTI • Digital sub-carrier PLL for accurate color decoding • Programmable hue, brightness, saturation, contrast, sharpness • Selectable differential or single-ended CVBS input • Up to 3-CH differential or 6-CH single-ended CVBS input FIGURE 1. FUNCTIONAL BLOCK DIAGRAM February 26, 2015 FN8667.1 1 CAUTION: These devices are sensitive to electrostatic discharge; follow proper IC Handling Procedures. 1-888-INTERSIL or 1-888-468-3774 | Copyright Intersil Americas LLC 2014, 2015. All Rights Reserved Intersil (and design) is a trademark owned by Intersil Corporation or one of its subsidiaries. All other trademarks mentioned are the property of their respective owners. TW8824 Features Image Processing (Continued) Digital Inputs Support • High quality scaler with both up/down and panorama/water-glass scaling support • Supports RGB 24-bit input up to 1080p resolution at either 1.8V or 3.3V logic level • Built-in 2D de-interlacing function • Supports both BT.656 and 601 video formats with H/VSYNC • Programmable brightness, contrast, saturation, hue and sharpness TFT Panel Support • Programmable color transient improvement control • Built-in programmable timing controller • Supports programmable cropping of input video and graphics • Supports 3, 4, 6 or 8 bits per pixel up to 16.8 million colors with built-in dithering engine • Independent RGB gain and offset controls • Supports digital panels (TTL) or single channel LVDS panels up to WXGA (1366x768) resolution, 85MHz • Programmable 8-bit Gamma correction for each color • Supports serial (8-bit) RGB panel • DTV hue adjustment • Black/White Stretch Clock Generation Timing Controller (TCON) • Supports programmable interface signals for control • Spread spectrum profile based on triangular modulation with center spread • Column (source) driver/row (gate) driver • Programmable modulation frequency and spread width BT.656 Output Miscellaneous • Independent ITU-R 656 compatible YCbCr(4:2:2) output format • Supports Fast Mode I2C interface up to 400Kbps • ITU-R 656 output generated from decoder, DRGB and post scaling path • Max 148.5MHz with 3.3V, 74MHz with 1.8V • Short Diagnostics: - Short-to-battery - Short-to-ground Font Based On Screen Display • Up to 3 PWM outputs • Four window font OSD with bordering/shadow • GPIOs • 6912B programmable font RAM and 512 display RAM • 1.8V internal operation • 1/2/3/4 bits/pixel • 1.8V/3.3V DTV input support • Supports variable width (12/16), height (2~32) • 1.8V/3.3V BT.656 output support • Hardware mute pin • Single 27MHz crystal • 100 pin TQFP • TW8824AT-TA1-GR is AEC-Q100 qualified For additional products, see www.intersil.com/en/products.html Intersil products are manufactured, assembled and tested utilizing ISO9001 or TS16949 quality systems as applicable noted in the quality certifications found at www.intersil.com/en/support/qualandreliability.html Intersil products are sold by description only. Intersil Corporation reserves the right to make changes in circuit design, software and/or specifications at any time without notice. Accordingly, the reader is cautioned to verify that data sheets are current before placing orders. Information furnished by Intersil is believed to be accurate and reliable. However, no responsibility is assumed by Intersil or its subsidiaries for its use; nor for any infringements of patents or other rights of third parties which may result from its use. No license is granted by implication or otherwise under any patent or patent rights of Intersil or its subsidiaries. For information regarding Intersil Corporation and its products, see www.intersil.com Submit Document Feedback 2 FN8667.1 February 26, 2015