1 2 4 3 REVISIONS REV DESCRIPTION 1 Initial Release Per ECO 14-17860 DATE APPROVED Mar-19-14 J.Tichy A A SEATING PLANE HEIGHT .500±.025 [12,7±0,63] 1.536 [39,014] 1.030 [26,162] PIN EXTENSION .180 [4,57] SEE NOTE 6 13 14 15 16 17 18 12 11 B B 10 1.740 [44,2] 1.860 [47,24] 2.386 [60,6] 9 1.540 [39,12] 8 1.340 [34,04] 7 1.140 [28,96] .940 [23,88] .740 [18,8] 6 .540 [13,72] .060±.020 [1,52±0,5 ] C 5 4 3 2 C 1 .150 [3,81] .085±.020 [2,16±0,5 ] D M3 THREADED INSERT SEE NOTE 1 (4 PLCS) .450 [11,43] .600 [15,24] .750 [19,05] NOTES: 1. APPLIED TORQUE PER M3 SCREW 5in-lb RECOMMENDED (6in-lb LIMIT). SCREW SHOULD NOT EXCEED 0.100" (2.54mm) DEPTH BELOW THE SURFACE OF THE BASEPLATE. 2. BASEPLATE FLATNESS TOLERANCE IS 0.004" (.10mm) TIR FOR SURFACE. 3. PINS 1-5 AND 13-18 ARE 0.040" (1.02mm) DIA. WITH .080 (2.03mm) DIA. STANDOFF SHOULDERS 4. PINS 6-12 ARE 0.062" (1.57mm) DIA. WITH 0.100" (2.54mm) DIA. STANDOFF SHOULDERS 5. ALL PINS: MATERIAL: COPPER ALLOY FINISH: MATTE TIN OVER NICKEL PLATE 6. ALTERNATIVE PIN LENGTHS MAYBE AVAILABLE. CHECK WITH FACTORY 7. WEIGHT: SEE PRODUCT DATASHEET 8. ALL DIMENSIONS IN INCHES(mm) TOLERANCES: X.XXin +/- 0.02 (X.Xmm +/- 0.5mm) X.XXXin +/- 0.010 (X.XXmm +/- 0.25mm) 1 .300 [7,62] 1.225 [31,12] TOLERANCES: Unless otherwise specified: All dimensions in inches .X +/- .025 .XX +/- .010 .XXX +/- .005 Angles +/- 1° Third Angle Projection THIS DRAWING IS THE PROPERTY OF SYNQOR LLC. It is not to be reproduced or copied, in whole or in part, or used for furnishing information to others, or for any purpose detrimental to the interests of SynQor. The information shown herein may be protected by patents owned or controlled by SynQor. 2 3 155 Swanson Road Boxborough, MA 01719-1316 NiQor Quad Output Mechanical Drawing Threaded Inserts SOURCE: PRO/E NIQOR3UP-ASSY SIZE B DATE DWG. NO. Mar-19-14 SCALE: 1.000 DRAWN: JT REV 020-0000265 CHECK: 4 SHEET 1 of 1 1 D