1 2 4 3 REVISIONS REV 1 A DESCRIPTION Initial Release Per ECO 14-17860 DATE APPROVED Mar-19-14 J.Tichy 2.200 [55,88] A SEATING PLANE HEIGHT .500±.025 [12,7±0,63] 2.000 [50,8] 1.536 [39,014] PIN EXTENSION .180 [4,57] SEE NOTE 6 13 14 15 16 17 18 12 11 B B 10 1.740 [44,2] 1.300 2.066 [33,02] [52,48] 2.386 [60,6] 9 1.540 [39,12] 8 1.340 [34,04] 7 1.140 [28,96] .940 [23,88] .740 [18,8] 6 .540 [13,72] .340±.020 [8,64±0,5 ] C 5 .400±.020 [10,16±0,5 ] D 3 2 C 1 .150 [3,81] .130 [3,3] SEE NOTE 1 (6 PLCS) .300 [7,62] .450 [11,43] NOTES: 1. APPLIED TORQUE PER M3 OR 4-40 SCREW 4in-lb RECOMMENDED (5in-lb LIMIT) 2. BASEPLATE FLATNESS TOLERANCE IS 0.004" (.10mm) TIR FOR SURFACE. 3. PINS 1-5 AND 13-18 ARE 0.040" (1.02mm) DIA. WITH .080 (2.03mm) DIA. STANDOFFS. 4. PINS 6-12 ARE 0.062" (1.57mm) DIA. WITH 0.100" (2.54mm) DIA. STANDOFFS 5. ALL PINS: MATERIAL: COPPERS ALLOY FINISH: MATTE TIN OVER NICKEL PLATE 6. ALTERNATIVE PIN LENGTH MAYBE AVAILABLE. CHECK WITH FACTORY 7. WEIGHT: SEE PRODUCT DATASHEET 8. ALL DIMENSIONS IN INCHES(mm) TOLERANCES: X.XXin +/- 0.02 (X.Xmm +/- 0.5mm) X.XXXin +/- 0.010 (X.XXmm +/- 0.25mm) 1 4 2 .600 [15,24] .750 [19,05] 1.225 [31,12] TOLERANCES: Unless otherwise specified: All dimensions in inches .X +/- .025 .XX +/- .010 .XXX +/- .005 Angles +/- 1° Third Angle Projection THIS DRAWING IS THE PROPERTY OF SYNQOR LLC. It is not to be reproduced or copied, in whole or in part, or used for furnishing information to others, or for any purpose detrimental to the interests of SynQor. The information shown herein may be protected by patents owned or controlled by SynQor. 3 155 Swanson Road Boxborough, MA 01719-1316 NiQor Quad Output Mechanical Drawing Flanged SOURCE: PRO/E NIQOR3UP-ASSY-FLANGED SIZE B DATE DWG. NO. Mar-19-14 SCALE: 1.000 DRAWN: JT 020-0000285 CHECK: 4 SHEET 1 of 1 REV 1 D