Part No: A1/2-003 – A1/2 Series Tilt Switch - Mercury Features: * Insulated * Form: NO/NC/SPST/Mount dependent * Angles Referenced from Horizontal * Single Electrode * Hermetically Sealed * Small Package Size * Narrow Included Angle * High Current Capability * Low Contact Resistance * Long Life Drawing dimensions in inches. Tilt switches “make” when the electrode is tilted below horizontal and “break” when tilted above the horizontal. Total travel from “make” to “break” is the “Maximum included angle” shown below. The component to which the switch is attached must have a total tilt angle greater than the “Maximum included angle” for proper operation. Maximum included Angle* : 15º * Switching occurs when body axis is near horizontal Switch Ratings: Max Switching Voltage Max Switching Current Initial Contact Resistance (Max). Stand Off Voltage (contact to contact) (contact to ground) Operating Temperature Storage Temperature Typical number of operations at specified load G-Force Activation G-Level/Range Dimensions: Weight per 100pcs. Lbs / Kgs: Body Length (less leads). Inches / Millimeters: Maximum Diameter. Inches / Millimeters: Materials: Lead Wire Type Lead wire length/skive/termination Finish: Clip: © American Electronic Components Inc 2006 Specifications are subject to change without notice. E&OE. 240V 120VAC / 1A: 240VAC / 0.4A, 120VDC /0.5A: 240VDC / 0.4A. Tungsten 120V / 60W 80 milli Ohms 1250V 1500V -38º to 220º F / -38º to 105º C -40º to 356º F / -40º to 180º C 10,000,000 N/A 0.99 / 0.45 0.96 / 24.4 0.38 / 9.5 #26AWG PVC Insulated 11 inches, spade terminals #6 screw Case: PBT (30% Glass Filled) Use P/N 0164 Mounting Clip American Electronic Components Inc., 1101 Lafayette Street, Elkhart, Indiana. USA Tel: +1-574-295-6330 Fax: +1-574-293-8013 Email: [email protected] http://www.aecsensors.com A1/2-003 200606