Part No: 4929 - A1/2S Series Tilt Switch - Mercury Features: * Un-Insulated * Form: NO/NC/SPST/Mount dependent * Angles Referenced from Horizontal * Single Electrode * Hermetically Sealed * Small Package Size * Narrow Included Angle * High Current Capability * Low Contact Resistance * Long Life Drawing dimensions in inches. Tilt switches “make” when the electrode is tilted below horizontal and “break” when tilted above the horizontal. Total travel from “make” to “break” is the “Maximum included angle” shown below. The component to which the switch is attached must have a total tilt angle greater than the “Maximum included angle” for proper operation. Must Make / Break Angle * : Maximum included Angle: - 7º / + 7º 14º * Make/break angles are electrode + (above) / - (below) 0° horizontal reference Switch Ratings: Max Switching Voltage Max Switching Current Initial Contact Resistance (Max). Stand Off Voltage (contact to contact) Operating Temperature Storage Temperature Typical number of operations at specified load G-Force Activation G-Level/Range Dimensions: Weight per 100pcs. Lbs / Kgs: Body Length (less leads). Inches / Millimeters: Maximum Diameter. Inches / Millimeters: Materials: Lead Wire Type Lead wire length/skive/termination Finish: © American Electronic Components Inc 2006 Specifications are subject to change without notice. E&OE. 12V DC 0.5 A 2 Ohms Max @ 1 mA (-10º below horizontal) 1kV AC -38º to 220º F / -38º to 105º C -40º to 356º F / -40º to 180º C 10,000,000 N/A 0.33 / 0.15 0.25 / 9.9 0.27 / 6.7 N/A N/A Tin American Electronic Components Inc., 1101 Lafayette Street, Elkhart, Indiana. USA Tel: +1-574-295-6330 Fax: +1-574-293-8013 Email: [email protected] http://www.aecsensors.com 4929 050606