Section Part Page Date Dimension Prints for Above NEMA Motors ANSS-60000-0403 1.3 2 7 04/03 Type CGG – Horizontal – Totally Enclosed Water to Air Cooled Sleeve Bearing – Direct Connected Frames 1122 / 1124 – 4 Pole & Slower Standard Dimensions in Inches SHAFT TYPE 11 I II III IV V 2 KEY 4 U R N-W V 6.5 7.0 7.5 8.0 8.5 5.662 6.014 6.521 6.873 7.381 11.00 11.75 12.50 13.25 14.00 10.60 11.35 12.10 12.85 13.60 S 3 1122 FRAME ES 1.50 1.75 1.75 2.00 2.00 9.00 9.75 10.50 10.75 11.50 BA 17.25 17.25 19.00 19.00 19.00 B C 2F 88.0 88.0 88.0 88.0 88.0 121.0 121.7 125.8 126.6 127.3 76.0 76.0 76.0 76.0 76.0 1124 FRAME Approx. Ship Wt. (Lbs.) 32,000 32,000 32,000 32,000 32,000 B C 2F 96.0 96.0 96.0 96.0 96.0 129.0 129.7 133.8 134.6 135.3 84.0 84.0 84.0 84.0 84.0 Notes 1. 2. 3. 4. 5. 6. See Section 3 for selection of main terminal box. R = Bottom of key to opposite side of shaft. S = Width of keyseat. V = Length of shaft available for coupling. Jackscrew holes and dowel holes are provided at each foot. Shims may be necessary under motor feet for direct connection. 7. 8. 9. 10. 11. All machines may rotate in one direction only. Rotor end float = 0.5” End float of LEF coupling = 0.19” For motors equipped with provisions for proximity probes use print in Part 3 of this section. Some shaft types are not available for all HP combinations. Consult factory. Lubrication Per Bearing 4 Pole & Slower 290-350 SUS @ 100ºF Oil capacity per bearing 8.5 qt. for Shaft Types I & II 13.7 qt. for Shaft Types III, IV, & V Certification Customer HP P.O. RPM Rotation Facing Shaft Extension S.O. PH/HZ/Volts 3-60- FRAME CW CCW By Not for construction, installation or application purposes unless certified. Item Either Date Approx. Ship Wt. (Lbs.) 38,400 38,400 38,400 38,400 38,400