C .270 [6.86] .190 [4.83] D IA.TH R U (2)PLC S. .650 .400 [10.16] [16.51] .200 [5.08] (2)PLC S. B .437 [11.10] .750 [19.05] .325 [8.26] A .437 [11.10] .500 [12.70] M AX. #6-32 U N C -2A TH D . C O M BIN ATIO N H EAD SC R EW W ITH C LAM P W ASH ER (4)PLC S. TO R Q U E 9 in.lbs. [1.02 N m ]M AX. .810 .040 G R O U N D [1.02] [20.57] PLAN E TYP. .318 [8.08] M AX. .062 X .032 [1.57 X 0.81] TYP. FILTER SLEEVES SO LD ER ED EN C APSU LATED IN SLEEVE TO G R O U N D PLATE .040 [1.02]M AX.FILLET (TYP.) G RO UND PLA N E C IR C U IT (EA C H LIN E) Blocks The components in this catalog are manufactured with ceramic dielectrics. To minimize possible damage to the components during installation, the recommendations below should be followed. For information concerning other installation requirements and/or component modifications, consult TUSONIX Customer Engineering at (520) 7440400. Handling: Excessive force or direct impact to the component may result in breakage. Lead bending or cutting, if necessary, should be done with a support for the lead to prevent mechanical stress to the component. Components with required lead modifications are available from TUSONIX. Lead Soldering: Use a temperature controlled soldering iron with SN60 or SN63 RMA Flux core wire. Maximum soldering temperature to be 500°F(260°C) with a dwell time of 3 seconds maximum. The use of a heat sink between the component body and the solder joint is highly recommended. Flux Removal: Optimum flux removal can be achieved by vapor degreasing the components immediately after the soldering operation. Total immersion of the components is not recommended. 7741 North Business Park Drive Tucson, Arizona 85743 520-744-0400 FAX: 520-744-6155 E-mail: [email protected] Website: www.tusonix.com PRINTED IN USA