24-Lead Side Brazed Ceramic DIP for Hybrid [SBDIP_H] (DH-24A) Dimensions shown in inches and (millimeters) a (SEE NOTE 5) 0.098 (2.49) MAX 0.005 (0.13) MIN 13 1 12 PIN 1 (SEE NOTE 1) (SEE NOTE 3) 0.075 (1.91) 0.015 (0.38) 1.212 (30.78) MAX 0.225 (5.72) MAX 0.200 (5.08) 0.120 (3.05) 0.023 (0.58) 0.014 (0.36) 0.100 (2.54) BSC 0.070 (1.78) 0.030 (0.76) (SEE NOTE 4, 7) (SEE NOTE 2) 0.180 (4.57) MIN SEATING PLANE 0.610 (15.49) 0.585 (14.86) 0.085 (2.16) MIN 0.015 (0.38) 0.008 (0.20) 0.620 (15.75) 0.590 (14.99) (SEE NOTE 6) NOTES: 1. INDEX AREA; A NOTCH OR A LEAD ONE IDENTIFICATION MARK IS LOCATED ADJACENT TO LEAD ONE. 2. THE MINIMUM LIMIT FOR DIMENSION MAY BE 0.023” (0.53 mm) FOR ALL FOUR CORNER LEADS ONLY. 3. DIMENSION SHALL BE MEASURED FROM THE SEATING PLANE TO THE BASE PLANE. 4. THE BASIC PIN SPACING IS 0.100" (2.54 mm) BETWEEN CENTERLINES. 5. APPLIES TO ALL FOUR CORNERS. 6. THE DEMENSION SHALL BE MEASURED AT THE CENTERLINE OF THE LEADS. 7. TWENTY TWO SPACES. 8. CONTROLLING DIMENSIONS ARE IN INCHES. MILLIMETER DIMENSIONS (IN PARENTHESES) ARE ROUNDED-OFF INCH EQUIVALENTS FOR REFERENCE ONLY AND ARE NOT APPROPRIATE FOR USE IN DESIGN. 012507-A 24