Non-contact Vital & Motion Sensor Module PDF(188KB)

Sensor
NON-CONTACT VITAL & MOTION SENSOR MODULE /
IONIZING RADIATION SENSOR MODULE
☆ New
■ Non-contact
product
Vital & Motion Sensor Module
♦Features
(1) Measures heart and breathing rate without contact using the Doppler effect.
(2) The module can be embedded in products as sensing is possible through obstructions
(except in cases where the obstructions are metal or metal plated).
(3) Enables stable measurement without being affected by factors such as temperature,
direct sunlight, or reflector color.
DC6M4JN3000
♦Standard
Specifications
☆DC6M4JN3000
Model No.
Output frequency (GHz)
24.05 to 24.5
Output interface
UART interface (baud rate: 115 200; data bit length: 8 bits)
Applications
Heart rate / Breathing rate / Body motion
Measurable distance (m)
MAX. 1 (heart rate and breathing rate)
Antenna
Planar antenna with 8 patch Tx / Rx antenna elements
Antenna pattern (deg.)
30 (azimuth), 26 (elevation)
Power supply (V)
3.3
Dissipation current (mA)
100 (including signal processing)
RF module: 31 × 47.5 × 14.5
Signal processer: 30.0 × 46.5 × 5.0
Outline dimensions (W)×(D)×(H) (mm)
■ Ionizing
Radiation Sensor Module
♦Features
(1) Low-noise amplifier to efficiently amplify weak currents
(2) Built-in circuit to eliminate noise caused by vibration and shock
(3) Compact module size thanks to a newly developed dedicated IC
(25 × 20 × 2.5 mm)
(4) Low power consumption (7.5 mW at normal operation)
QM1H0M0058
♦Standard
Specifications
Model No.
Object to be detected
Measuring range (µSv/h)
0.05 to 20
Output interface
I2C output
Power supply voltage
78
QM1H0M0058
Gamma ray (γ-ray) (Detector: PIN photodiode)
DC 5 V (Photodiode), 2.75 V (Analog), 1.8 V (Digital)
Power consumption (mW)
7.5 (at normal operation)
Outline dimensions (mm)
25 × 20 × 2.5
Notice
In the absence of confirmation by device specification sheets, SHARP takes no responsibility for any defects that may occur in equipment
using any SHARP devices shown in catalogs, data books, etc. Contact SHARP in order to obtain the latest device specification sheets
before using any SHARP device.