CY8CKIT-016 PSOC® 1 THERMAL MANAGEMENT KIT QUICK START GUIDE Prerequisites for CY8CKIT-016 CY8CKIT-001 CY8CKIT-036 CY8CKIT-036 Board CY8CKIT-001 Board with CY8C28 Family Processor Module USB Cable Connecting Wires MiniProg3 Power Adapter 1 2 Download the CY8CKIT-016 Kit Setup executable file from http://www.cypress.com/go/ CY8CKIT-016. If you already have PSoC Designer and PSoC Programmer installed, download CY8CKIT-016 Kit Only. Run the executable file to start the installation process. Set VDD DIG and VDD ANLG to 3.3 V using SW3, J7, and J6 on the CY8CKIT-001. During the installation process, continue with the hardware setup. Attach the LCD included with the PSoC DVK and set the LCD power jumper (J12) to ON. CY8CKIT-016 PSOC® 1 THERMAL MANAGEMENT KIT QUICK START GUIDE 3 4 Connect VR to P0_7 and SW1 to P1_7on the CY8CKIT-001; set J11 with a jumper. On the CY8CKIT-036, set jumpers as follows: J2 to SINGLE, J3 to 3.3 V, and J9 to 12V_DVK. Plug the CY8C28 family processor module into CY8CKIT-001. 5 6 Connect the MiniProg3 to the CY8C28 family processor module. After programming, remove MiniProg3 and insert the CY8CKIT-036 into Port A of the CY8CKIT-001; power the CY8CKIT-001. Launch PSoC Programmer; load CY8CKIT_016_Example_Project.hex, located at C:\Program Files\Cypress\CY8CKIT-016\1.0\ Firmware\Hex_File. In PSoC Programmer, use the following settings: Programming Mode: Power Cycle, Auto Detection: ON, Protocol: ISSP, Voltage: 5.0. Click on Program to program the device. The LCD will display Zone 1 temperature, set fan speed, and actual fan speed Pressing SW1 will display the same for Zone 2. Pressing SW1 again will display Zone temperature and individual temperature sensor readings. See the example project in the kit guide for details. For the latest information about this kit, visit http://www.cypress.com/go/CY8CKIT-016 © 2012 Cypress Semiconductor Corporation. All rights reserved. All trademarks or registered trademarks referenced herein are the properties of their respective owners. Doc.#: 001-80792 Rev. **