CY3280-BBM UNIVERSAL CAPSENSE® PROTOTYPING MODULE KIT QUICK START GUIDE 1 2 Introduction Board Setup 1. The CY3280-Bread Board module kit connects to any CY3280 Universal CapSense Controller (UCC) board, such as the latest CY3280-20x66 DVK. This helps in evaluating the various PSoC features. 1. Connect the CY3280-BBM board to the P2 connector of any Universal CapSense Controller (UCC) board such as the CY3280-20x34 (to be purchased separately). 3 4 A B H C G D F E Board Setup Module Description 2. The CY3280-BBM provides access to every pin routed to the 44-pin connector on the attached UCC board. 1. The vertical holes on the bread board from A to H, B to C, G to F, and D to E are shorted; the horizontal holes from A to B, H to C, G to D, and F to E are isolated from each other. 3. Use the prototyping area (described in Step 4) to evaluate the PSoC features. 2. To bring out port pins, connect the port pin headers on to the bread board with wires. CY3280-BBM UNIVERSAL CAPSENSE® PROTOTYPING MODULE KIT QUICK START GUIDE CY3280-BBM Board Details Prototype Area Optional Regulator Footprint Optional I2C EEPROM Port Pins Footprint Optional Second Connector (J2) 44-Pin Connector (J1) Port Pins For the latest information about this kit, visit www.cypress.com/go/CY3280-BBM © 2011 Cypress Semiconductor Corporation. All rights reserved. All trademarks or registered trademarks referenced herein are the properties of their respective owners. DOC#: 001-43368 REV. *A