TA75W01FU TOSHIBA Bipolar Linear Integrated Circuit Silicon Monolithic TA75W01FU Dual Operational Amplifier Features z In the linear mode the input common mode voltage range includes ground. z The internally compensated operational amplifier is small package. z Low power dissipation and power drain suitable for battery operation. z Differential input voltage range equal to the power supply voltage. z Large output voltage swing : 0VDC to 3.4VDC (VCC = 5VDC) z Wide power supply voltage range and single power supply is possible. z Single supply 3VDC to 12VDC or dual supplies ± 1.5VDC to ± 6VDC. Weight: 0.021g (typ.) Marking (Top View) Pin Connection (Top View) 1 2007-11-01 TA75W01FU Equivalent Circuit Absolute Maximum Ratings (Ta = 25°C) Characteristic Supply voltage Differential input voltage Symbol Rating Unit VCC, VEE ±6 or 12 V DVIN ±12 V VIN −0.3 ~VCC V Input voltage Power dissipation PD 250 mW Operating temperature Topr −40~85 °C Storage temperature Tstg −55~125 °C Note: Using continuously under heavy loads (e.g. the application of high temperature/current/voltage and the significant change in temperature, etc.) may cause this product to decrease in the reliability significantly even if the operating conditions (i.e. operating temperature/current/voltage, etc.) are within the absolute maximum ratings and the operating ranges. Please design the appropriate reliability upon reviewing the Toshiba Semiconductor Reliability Handbook (“Handling Precautions”/“Derating Concept and Methods”) and individual reliability data (i.e. reliability test report and estimated failure rate, etc). Electrical Characteristics (VCC = 5V, VEE = GND, Ta = 25°C) Symbol Test Circuit Input offset voltage VIO 1 Input offset current IIO 2 ― II 2 CMVIN Supply current Voltage gain Characteristic Min Typ. ― ― ― 3 ICC 4 GV ― Maximum output voltage swing Vop-p 5 Common mode rejection ratio CMRR 3 Supply voltage rejection ratio SVRR ― Source current Isource Input bias current Common mode input voltage Sink current Unity gain cross frequency Test Condition Max Unit 2 7 mV 5 50 nA ― 45 250 nA ― 0 ― VCC−1.5 V ― ― 0.7 1.2 mA RL≥2kΩ 86 100 ― dB RL=2kΩ 0 ― 3.4 V 65 85 ― dB Rg=10kΩ 65 100 ― dB 6 IN (−) = 0V, IN (+) = 1V 20 40 ― mA Isink 7 IN (−) = 1V, IN (+) = 0V 10 20 ― mA fT ― ― ― 0.3 ― MHz Rg≤10kΩ ― 2 2007-11-01 TA75W01FU Test Circuit (1) VIO (2) II, IIO (3) CMVIN, CMRR (4) ICC (5) VOP-P (6) Isource (7) Isink 3 2007-11-01 TA75W01FU 4 2007-11-01 TA75W01FU Package Dimensions SSOP8-P-0.65 Unit: mm Weight: 0.021g (typ.) 5 2007-11-01 TA75W01FU RESTRICTIONS ON PRODUCT USE 20070701-EN GENERAL • The information contained herein is subject to change without notice. • TOSHIBA is continually working to improve the quality and reliability of its products. Nevertheless, semiconductor devices in general can malfunction or fail due to their inherent electrical sensitivity and vulnerability to physical stress. It is the responsibility of the buyer, when utilizing TOSHIBA products, to comply with the standards of safety in making a safe design for the entire system, and to avoid situations in which a malfunction or failure of such TOSHIBA products could cause loss of human life, bodily injury or damage to property. In developing your designs, please ensure that TOSHIBA products are used within specified operating ranges as set forth in the most recent TOSHIBA products specifications. Also, please keep in mind the precautions and conditions set forth in the “Handling Guide for Semiconductor Devices,” or “TOSHIBA Semiconductor Reliability Handbook” etc. • The TOSHIBA products listed in this document are intended for usage in general electronics applications (computer, personal equipment, office equipment, measuring equipment, industrial robotics, domestic appliances, etc.).These TOSHIBA products are neither intended nor warranted for usage in equipment that requires extraordinarily high quality and/or reliability or a malfunction or failure of which may cause loss of human life or bodily injury (“Unintended Usage”). Unintended Usage include atomic energy control instruments, airplane or spaceship instruments, transportation instruments, traffic signal instruments, combustion control instruments, medical instruments, all types of safety devices, etc.. Unintended Usage of TOSHIBA products listed in his document shall be made at the customer’s own risk. • The products described in this document shall not be used or embedded to any downstream products of which manufacture, use and/or sale are prohibited under any applicable laws and regulations. • The information contained herein is presented only as a guide for the applications of our products. No responsibility is assumed by TOSHIBA for any infringements of patents or other rights of the third parties which may result from its use. No license is granted by implication or otherwise under any patents or other rights of TOSHIBA or the third parties. • Please contact your sales representative for product-by-product details in this document regarding RoHS compatibility. Please use these products in this document in compliance with all applicable laws and regulations that regulate the inclusion or use of controlled substances. Toshiba assumes no liability for damage or losses occurring as a result of noncompliance with applicable laws and regulations. 6 2007-11-01