TOSHIBA MT4S03A

MT4S03A
TOSHIBA Transistor Silicon NPN Epitaxial Planar Type
MT4S03A
VHF~UHF Band Low Noise Amplifier Applications
•
Low noise figure: NF = 1.4dB (f = 2 GHz)
•
High gain: Gain = 9dB (f = 2 GHz)
Unit: mm
Absolute Maximum Ratings (Ta = 25°C)
Characteristics
Symbol
Rating
Unit
Collector-base voltage
VCBO
10
V
Collector-emitter voltage
VCEO
5
V
Emitter-base voltage
VEBO
2
V
Base current
IC
40
mA
Collector current
IB
10
mA
Collector power dissipation
PC
150
mW
Junction temperature
Tj
125
°C
Tstg
−55~125
°C
Storage temperature range
Note: Using continuously under heavy loads (e.g. the application of high
JEDEC
―
temperature/current/voltage and the significant change in
JEITA
―
temperature, etc.) may cause this product to decrease in the
reliability significantly even if the operating conditions (i.e.
TOSHIBA
2-3J1C
operating temperature/current/voltage, etc.) are within the
Weight: 0.012 g (typ.)
absolute maximum ratings.
Please design the appropriate reliability upon reviewing the
Toshiba Semiconductor Reliability Handbook (“Handling Precautions”/“Derating Concept and Methods”) and
individual reliability data (i.e. reliability test report and estimated failure rate, etc).
Marking
Microwave Characteristics (Ta = 25°C)
Characteristics
Transition frequency
Insertion gain
Noise figure
Symbol
Test Condition
Min
Typ.
Max
fT (1)
VCE = 1 V, IC = 5 mA
2
4.5
⎯
fT (2)
VCE = 3 V, IC = 10 mA
7
10
⎯
2
VCE = 1 V, IC = 5 mA, f = 2 GHz
3.5
5.5
⎯
2
⎪S21e⎪ (2)
VCE = 3 V, IC = 20 mA, f = 2 GHz
7
9
⎯
NF (1)
VCE = 1 V, IC = 5 mA, f = 2 GHz
⎯
1.7
3
NF (2)
VCE = 3 V, IC = 7 mA, f = 2 GHz
⎯
1.4
2.2
⎪S21e⎪ (1)
1
Unit
GHz
dB
dB
2007-11-01
MT4S03A
Electrical Characteristics (Ta = 25°C)
Characteristics
Symbol
Test Condition
Min
Typ.
Max
Unit
Collector cut-off current
ICBO
VCB = 5 V, IE = 0
⎯
⎯
0.1
μA
Emitter cut-off current
IEBO
VEB = 1 V, IC = 0
⎯
⎯
1
μA
DC current gain
hFE
VCE = 1 V, IC = 5 mA
80
⎯
160
Reverse transfer capacitance
Cre
VCB = 1 V, IE = 0, f = 1 MHz
⎯
0.7
1.05
(Note)
pF
Note: Cre is measured by 3 terminal method with capacitance bridge.
Caution
This device is sensitive to electrostatic discharge. Please handle with caution.
2
2007-11-01
MT4S03A
RESTRICTIONS ON PRODUCT USE
20070701-EN
• The information contained herein is subject to change without notice.
• TOSHIBA is continually working to improve the quality and reliability of its products. Nevertheless, semiconductor
devices in general can malfunction or fail due to their inherent electrical sensitivity and vulnerability to physical
stress. It is the responsibility of the buyer, when utilizing TOSHIBA products, to comply with the standards of
safety in making a safe design for the entire system, and to avoid situations in which a malfunction or failure of
such TOSHIBA products could cause loss of human life, bodily injury or damage to property.
In developing your designs, please ensure that TOSHIBA products are used within specified operating ranges as
set forth in the most recent TOSHIBA products specifications. Also, please keep in mind the precautions and
conditions set forth in the “Handling Guide for Semiconductor Devices,” or “TOSHIBA Semiconductor Reliability
Handbook” etc.
• The TOSHIBA products listed in this document are intended for usage in general electronics applications
(computer, personal equipment, office equipment, measuring equipment, industrial robotics, domestic appliances,
etc.).These TOSHIBA products are neither intended nor warranted for usage in equipment that requires
extraordinarily high quality and/or reliability or a malfunction or failure of which may cause loss of human life or
bodily injury (“Unintended Usage”). Unintended Usage include atomic energy control instruments, airplane or
spaceship instruments, transportation instruments, traffic signal instruments, combustion control instruments,
medical instruments, all types of safety devices, etc.. Unintended Usage of TOSHIBA products listed in his
document shall be made at the customer’s own risk.
• The products described in this document shall not be used or embedded to any downstream products of which
manufacture, use and/or sale are prohibited under any applicable laws and regulations.
• Please contact your sales representative for product-by-product details in this document regarding RoHS
compatibility. Please use these products in this document in compliance with all applicable laws and regulations
that regulate the inclusion or use of controlled substances. Toshiba assumes no liability for damage or losses
occurring as a result of noncompliance with applicable laws and regulations.
3
2007-11-01