Order this document by MC13146/D 3 LOW POWER DC – 2.0 GHz TRANSMITTER The MC13146 is an integrated RF transmitter targeted at ISM band applications. It features a 50 Ω linear Mixer with linearity control, voltage controlled oscillator, divide by 64/65 dual modulus Prescaler and Exciter. Together with the receiver chip (MC13145) and the baseband chip (MC33410), a complete 900 MHz cordless phone system can be implemented. This device may be used in applications within 2 GHz since its RF bandwidth is greater than 2.4 GHz. • Low Distortion Exciter: Pout_1 dB Compression Point 8 dBm • • • • • • • • • SEMICONDUCTOR TECHNICAL DATA HIgh Mixer Linearity: IIP3 = 10 dBm 50 Ω Mixer Input Impedance Differential Open Collector Mixer Output 24 1 20 dB Power Conversion Gain FTA SUFFIX PLASTIC PACKAGE CASE 977 (LQFP–24) Low Power 64/65 Dual Modulus Prescaler (MC12054 type) 2.7 to 6.5 V Operation, Low Current Drain (25 mA @ 2.0 GHz) Powerdown Mode: <1.0 µA 2.4 GHz RF Bandwidth 1.8 GHz IF Bandwidth ORDERING INFORMATION Device Operating Temperature Range Package XC13146FTA TA = –40 ° to +85°C LQFP–24 PIN CONNECTIONS V EE V CC PA In V EE V EE PAOut LQFP–24 24 23 22 21 20 19 VCC 1 18 VEE Amp VEE 2 Mxr/Buf Out 3 Mx Lin 4 Mxr/Buf In 5 Control 16 MC PRSC 15 VEE 14 PRSC Out 13 VCC 7 8 9 10 11 12 V EE V CC Base V EE Emitter Collector VEE 6 This document contains information on a product under development. Motorola reserves the right to change or discontinue this product without notice. MOTOROLA RF/IF DEVICE DATA 17 Enable Motorola, Inc. 1998 Rev 0 1 MC13146 MAXIMUM RATINGS ÁÁÁÁÁÁÁÁÁÁÁÁÁÁ ÁÁÁÁ ÁÁÁÁÁ ÁÁÁ ÁÁÁÁÁÁÁÁÁÁÁÁÁÁ ÁÁÁÁ ÁÁÁÁÁ ÁÁÁ ÁÁÁÁÁÁÁÁÁÁÁÁÁÁ ÁÁÁÁ ÁÁÁÁÁ ÁÁÁ ÁÁÁÁÁÁÁÁÁÁÁÁÁÁ ÁÁÁÁ ÁÁÁÁÁ ÁÁÁ Symbol Value Unit Power Supply Voltage Rating VCC(max) 7.0 Vdc Junction Temperature TJ(max) 150 °C Tstg –65 to +150 °C Storage Temperature Range NOTE: ESD data available upon request. RECOMMENDED OPERATING CONDITIONS Characteristic Symbol Min Typ Max Unit VCC VEE 2.7 – – 0 6.5 – Vdc Vdc Power Supply Voltage (TA = 25°C) RF Frequency Range fRF 1.0 – 2500 MHz Ambient Temperature Range TA –40 – 85 °C Maximum Input Signal Level PIF – – –10 15 – – dBm dBm – with no damage – with minor performace degradation TRANSMITTER DC ELECTRICAL CHARACTERISTICS (TA = 25°C, VCC = 3.0 Vdc, no input signal, unless otherwise noted) Characteristic Symbol Min Typ Max Unit Total Supply Current (Enable = VCC) Itotal - 25 - mA Power Down Current (Enable = VEE) Itotal - 0.1 - µA TRANSMITTER AC ELECTRICAL CHARACTERISTICS (TA = 25°C, VCC = 3.0 Vdc, Enable = 3.0 Vdc, unless otherwise noted) Characteristics Symbol Min Typ Max Unit PA_PO – 0 – dBm Distortion (@ 820 MHz = fIF_out) (Note 1) P1dBC.Pt. – 8.0 – dBm Mixer/Buffer (@ 900 MHz = fosc) (Note 1) PMx/Buf_out – –18 – dBm PA – 2f PA – 3f – – –25 –35 – – dBc dBc VCO Phase Noise (@ 10 kHz offset) (Note 1) – –80 – dBc/Hz Mixer/Buffer Output Impedance – 50 – Ω Prescalar Output Level (10 k || 8.0 pF load) – 0.5 – Vpp MC Current Input (optional) – 200 – µApp Output Power (with external matching) Output Harmonics (with external matching @ 820 MHz) 2nd 3rd NOTE: 2 Tests run during test system/device characterization. MOTOROLA RF/IF DEVICE DATA MC13146 Figure 1. Test Circuit RF In 2.2 p 100 n 8.2 nH 6.8 nH 200 2.2 p RF Out 24 23 22 21 20 19 1 18 Amp 100 p 2 Control 3 50 Mixer RF In 17 100 p IF Out 1.0 n 16 PRSC 4 18 k MC 15 100 p 1.0 n 5 14 6 13 PRSC Out 270** 7 8 9 100 p 10 11 12 4.7 nH 3.3 p 4.7 p 100 n 2.2 p D1* 100 k 1.0 µ * MMBV809L ** Must be removed for Mixer Function. 470 nH VCC Tuning Volts MOTOROLA RF/IF DEVICE DATA 3 MC13146 OUTLINE DIMENSIONS FTA SUFFIX PLASTIC PACKAGE CASE 977–01 (LQFP–24) ISSUE O 4X 9 NOTES: 1 DIMENSIONING AND TOLERANCING PER ANSI Y14.5M, 1982. 2 CONTROLLING DIMENSION: MILLIMETER. 3 DATUM PLANE –AB– IS LOCATED AT BOTTOM OF LEAD AND IS COINCIDENT WITH THE LEAD WHERE THE LEAD EXITS THE PLASTIC BODY AT THE BOTTOM OF THE PARTING LINE. 4 DATUMS –T–, –U–, AND –Z– TO BE DETERMINED AT DATUM PLANE –AB–. 5 DIMENSIONS S AND V TO BE DETERMINED AT DATUM PLANE –AC–. 6 DIMENSIONS A AND B DO NOT INCLUDE MOLD PROTRUSION. ALLOWABLE PROTRUSION IS 0.250 (0.010) PER SIDE. DIMENSIONS A AND B DO INCLUDE MOLD MISMATCH AND ARE DETERMINED AT DATUM PLANE –AB–. 7 DIMENSION D DOES NOT INCLUDE DAMBAR PROTRUSION. DAMBAR PROTRUSION SHALL NOT CAUSE THE D DIMENSION TO EXCEED 0.350 (0.014). 8 MINIMUM SOLDER PLATE THICKNESS SHALL BE 0.0076 (0.0003). 9 EXACT SHAPE OF EACH CORNER IS OPTIONAL. 0.200 (0.008) AB T–U Z A A1 24 –T– DETAIL Y 19 1 18 –U– V B V1 13 6 7 B1 12 –Z– S1 S 4X 0.200 (0.008) AB T–U Z DETAIL AD DIM A A1 B B1 C D E F G H J K M N P Q R S S1 V V1 W X MILLIMETERS MIN MAX 4.000 BSC 2.000 BSC 4.000 BSC 2.000 BSC 1.400 1.600 0.170 0.270 1.350 1.450 0.170 0.230 0.500 BSC 0.050 0.150 0.090 0.200 0.500 0.700 12_REF 0.090 0.160 0.250 BSC 1_ 5_ 0.150 0.250 6.000 BSC 3.000 BSC 6.000 BSC 3.000 BSC 0.200 REF 1.000 REF INCHES MIN MAX 0.157 BSC 0.079 BSC 0.157 BSC 0.079 BSC 0.055 0.063 0.007 0.011 0.053 0.057 0.007 0.009 0.020 BSC 0.002 0.006 0.004 0.008 0.020 0.028 12 _REF 0.004 0.006 0.010 BSC 1_ 5_ 0.006 0.010 0.236 BSC 0.118 BSC 0.236 BSC 0.118 BSC 0.008 REF 0.039 REF –AB– –AC– 0.080 (0.003) AC M_ TOP & BOTTOM –T–, –U–, –Z– J R C E AE AE ÇÇÇ ÉÉÉ ÉÉÉ ÇÇÇ ÉÉÉ ÇÇÇ N F D 0.080 (0.003) W H K X DETAIL AD 4 Q_ GAUGE PLANE 0.250 (0.010) P S AC T–U S Z S SECTION AE–AE G DETAIL Y MOTOROLA RF/IF DEVICE DATA MC13146 Motorola reserves the right to make changes without further notice to any products herein. Motorola makes no warranty, representation or guarantee regarding the suitability of its products for any particular purpose, nor does Motorola assume any liability arising out of the application or use of any product or circuit, and specifically disclaims any and all liability, including without limitation consequential or incidental damages. “Typical” parameters which may be provided in Motorola data sheets and/or specifications can and do vary in different applications and actual performance may vary over time. All operating parameters, including “Typicals” must be validated for each customer application by customer’s technical experts. Motorola does not convey any license under its patent rights nor the rights of others. Motorola products are not designed, intended, or authorized for use as components in systems intended for surgical implant into the body, or other applications intended to support or sustain life, or for any other application in which the failure of the Motorola product could create a situation where personal injury or death may occur. Should Buyer purchase or use Motorola products for any such unintended or unauthorized application, Buyer shall indemnify and hold Motorola and its officers, employees, subsidiaries, affiliates, and distributors harmless against all claims, costs, damages, and expenses, and reasonable attorney fees arising out of, directly or indirectly, any claim of personal injury or death associated with such unintended or unauthorized use, even if such claim alleges that Motorola was negligent regarding the design or manufacture of the part. Motorola and are registered trademarks of Motorola, Inc. Motorola, Inc. is an Equal Opportunity/Affirmative Action Employer. Mfax is a trademark of Motorola, Inc. How to reach us: USA / EUROPE / Locations Not Listed: Motorola Literature Distribution; P.O. Box 5405, Denver, Colorado 80217. 1–303–675–2140 or 1–800–441–2447 JAPAN: Nippon Motorola Ltd.: SPD, Strategic Planning Office, 141, 4–32–1 Nishi–Gotanda, Shagawa–ku, Tokyo, Japan. 03–5487–8488 Customer Focus Center: 1–800–521–6274 Mfax: [email protected] – TOUCHTONE 1–602–244–6609 ASIA/PACIFIC: Motorola Semiconductors H.K. Ltd.; 8B Tai Ping Industrial Park, Motorola Fax Back System – US & Canada ONLY 1–800–774–1848 51 Ting Kok Road, Tai Po, N.T., Hong Kong. 852–26629298 – http://sps.motorola.com/mfax/ HOME PAGE: http://motorola.com/sps/ MOTOROLA RF/IF DEVICE DATA◊ MC13146/D 5