Order this document by MRFIC2406/D SEMICONDUCTOR TECHNICAL DATA The MRFIC Line Designed primarily for use in Industrial, Scientific, Medical (ISM) frequency band applications, the MRFIC2406 is an active GaAs upmixer in a low–cost SOIC 16–lead, surface mount package. The integrated circuit has internal active Baluns and requires minimal off-chip matching. In STANDBY mode, the device draws less than 0.6 mA for low battery drain. 2.4 GHz INTEGRATED UPMIXER GaAs MONOLITHIC INTEGRATED CIRCUIT • Usable Frequency Range = 2 to 3 GHz • Single Voltage Supply = 3 to 5 Volts • Low Current Drain = 15 mA Max Supply Current • IF to RF Conversion Gain = 6 dB Typical • STANDBY Mode for Low Current Consumption • No External Baluns Required • Simple Off-Chip Matching for Maximum Flexibility • Order MRFIC2406R2 for Tape and Reel. R2 Suffix = 2,500 Units per 16 mm, 13 inch Reel. CASE 751B–05 (SO–16) • Device Marking = M2406 IF IN 1 16 VDD GND 2 15 GND LO IN 3 14 RF OUT GND 4 13 GND GND 5 12 GND GND 6 11 GND GND 7 10 GND VDD 8 9 VSTANDBY Pin Connections and Functional Block Diagram MOTOROLA RF DEVICE DATA Motorola, Inc. 1997 MRFIC2406 1 MAXIMUM RATINGS (TA = 25°C unless otherwise noted) Rating Supply Voltage Standby Voltage Symbol Limit Unit VDD 7 Vdc VSTANDBY 7 Vdc IF Input Power IF IN +10 dBm LO Input Power LO IN +10 dBm Tstg – 65 to +125 °C TA – 35 to +85 °C Symbol Value Unit RF Frequency fRF 2.4 to 2.5 GHz IF Frequency fIF 100 to 370 MHz LO Frequency fLO 2.03 to 2.4 GHz VDD 3 to 5 Vdc VSTANDBY 0 to 3 Vdc Storage Temperature Range Ambient Operating Temperature RECOMMENDED OPERATING RANGES Parameter Supply Voltage Standby Voltage ELECTRICAL CHARACTERISTICS (VDD = 3 V, TA = 25°C, fRF = 2.45 GHz, fIF = 237 MHz, IF IN = –15 dBm, fLO = 2.213 GHz, LO IN = –5 dBm, VSTANDBY = 0 V, Tested in Circuit Shown in Figure 1) Characteristic Min Typ Max Unit IF to RF Conversion Gain 4 6 — dB LO to RF Isolation 10 12 — dB Return Loss, All Ports, (Matching as shown in Figure 1) –10 –12 — dB Spurious Output @ 2.4 – 2.5 GHz — — –55 dBc Output 1dB Gain Compression — –10 — dBm — 15 mA ON State Current, (VSTANDBY = 0 V) OFF State Current, (VSTANDBY = 3 V) — — 0.6 mA VSTANDBY Voltage (ON State) — — 0.1 V VSTANDBY Voltage (STANDBY State) 2.8 — — V On/Off Switching Time — 1 — µsec MRFIC2406 2 MOTOROLA RF DEVICE DATA C1 IF IN 1 16 2 15 3 14 4 13 5 12 6 11 7 10 8 9 C2 C3 C7 VDD L1 LO IN VDD RF OUT C1 240 pF C2 1000 pF C3, C4, C5, C8 15 pF C6 100 pF C7 10,000 pF L1 2.2 nH VSTANDBY C4 C5 C6 Figure 1. 2.45 GHz Applications Circuit Configuration MOTOROLA RF DEVICE DATA MRFIC2406 3 PACKAGE DIMENSIONS –A– 16 9 1 8 –B– P NOTES: 1. DIMENSIONING AND TOLERANCING PER ANSI Y14.5M, 1982. 2. CONTROLLING DIMENSION: MILLIMETER. 3. DIMENSIONS A AND B DO NOT INCLUDE MOLD PROTRUSION. 4. MAXIMUM MOLD PROTRUSION 0.15 (0.006) PER SIDE. 5. DIMENSION D DOES NOT INCLUDE DAMBAR PROTRUSION. ALLOWABLE DAMBAR PROTRUSION SHALL BE 0.127 (0.005) TOTAL IN EXCESS OF THE D DIMENSION AT MAXIMUM MATERIAL CONDITION. 8 PL 0.25 (0.010) M B S G R K F X 45 _ C –T– SEATING PLANE M D J 16 PL 0.25 (0.010) M T B S A S DIM A B C D F G J K M P R MILLIMETERS MIN MAX 9.80 10.00 3.80 4.00 1.35 1.75 0.35 0.49 0.40 1.25 1.27 BSC 0.19 0.25 0.10 0.25 0_ 7_ 5.80 6.20 0.25 0.50 INCHES MIN MAX 0.386 0.393 0.150 0.157 0.054 0.068 0.014 0.019 0.016 0.049 0.050 BSC 0.008 0.009 0.004 0.009 0_ 7_ 0.229 0.244 0.010 0.019 CASE 751B–05 ISSUE J Motorola reserves the right to make changes without further notice to any products herein. Motorola makes no warranty, representation or guarantee regarding the suitability of its products for any particular purpose, nor does Motorola assume any liability arising out of the application or use of any product or circuit, and specifically disclaims any and all liability, including without limitation consequential or incidental damages. “Typical” parameters which may be provided in Motorola data sheets and/or specifications can and do vary in different applications and actual performance may vary over time. All operating parameters, including “Typicals” must be validated for each customer application by customer’s technical experts. Motorola does not convey any license under its patent rights nor the rights of others. Motorola products are not designed, intended, or authorized for use as components in systems intended for surgical implant into the body, or other applications intended to support or sustain life, or for any other application in which the failure of the Motorola product could create a situation where personal injury or death may occur. Should Buyer purchase or use Motorola products for any such unintended or unauthorized application, Buyer shall indemnify and hold Motorola and its officers, employees, subsidiaries, affiliates, and distributors harmless against all claims, costs, damages, and expenses, and reasonable attorney fees arising out of, directly or indirectly, any claim of personal injury or death associated with such unintended or unauthorized use, even if such claim alleges that Motorola was negligent regarding the design or manufacture of the part. Motorola and are registered trademarks of Motorola, Inc. Motorola, Inc. is an Equal Opportunity/Affirmative Action Employer. Mfax is a trademark of Motorola, Inc. How to reach us: USA / EUROPE / Locations Not Listed: Motorola Literature Distribution; P.O. Box 5405, Denver, Colorado 80217. 1–303–675–2140 or 1–800–441–2447 JAPAN: Nippon Motorola Ltd.: SPD, Strategic Planning Office, 4–32–1, Nishi–Gotanda, Shinagawa–ku, Tokyo 141, Japan. 81–3–5487–8488 Customer Focus Center: 1–800–521–6274 Mfax: [email protected] – TOUCHTONE 1–602–244–6609 ASIA/PACIFIC: Motorola Semiconductors H.K. Ltd.; 8B Tai Ping Industrial Park, Motorola Fax Back System – US & Canada ONLY 1–800–774–1848 51 Ting Kok Road, Tai Po, N.T., Hong Kong. 852–26629298 – http://sps.motorola.com/mfax/ HOME PAGE: http://motorola.com/sps/ MRFIC2406 4 ◊ MOTOROLA RF DEVICE DATA MRFIC2406/D