PS600R THRU PS608R FAST SWITCHING RECOVERY RECTIFIER VOLTAGE - 50 to 800 Volts CURRENT - 6.0 Amperes P600 FEATURES l Low cost l Diffused junction l l Low forward voltage drop High current capability l Fast switching for high efficiency The plastic meterial carries U/L recognition 94V-O l Exceeds environmental standards of MIL-S-19500/228 MECHANICAL DATA Case: Molded plastic, P600 Terminals: Axial leads, solderable per MIL-STD-202, Method 208 Polarity: Color Band denotes cathode Mounting Position: Any Weight: 0.07 ounce, 2.1 gram MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS Ratings at 25 ¢J ambient temperature unless otherwise specified. Single phase, half wave, 60 Hz, resistive or inductive load. For capacitive load, derate current by 20%. PS600R PS601R Maximum Recurrent Peak Reverse Voltage 50 100 Maximum RMS Voltage 35 70 Maximum DC Blocking Voltage 50 100 Maximum Average Forward Rectified Current @TA=55 ¢J Peak Forward Surge Current 8.3ms single half sine-wave IFSM superimposed on rated load (JEDEC method) Maximum Forward Voltage at 6.0A DC Maximum DC Reverse Current at Rated TJ=25 ¢J DC Blocking Voltage TJ=100 ¢J Maximum Reverse Recovery Time(Note 1) Typical Junction capacitance (Note 2) Typical Thermal Resistance at 0.375"(9.5mm) lead length R £KJA Operating and Storage Temperature Range TJ ¡BTA Reverse Recovery Test Conditions: IF=.5A, IR=1A, Irr=.25A Measured at 1 MHz and applied reverse voltage of 4.0 Volts PS606R 600 420 600 PS608R 800 560 800 UNITS V V V A 300 A 1.3 10.0 1000 10.0 V £g A £g A ns PF ¢J /W -55 TO +150 ¢J 150 140 NOTES: 1. 2. PS602R PS604R 200 400 140 280 200 400 6.0 250 500 300 RATING AND CHARACTERISTIC CURVES PS600R THRU PS608R trr +0.5A 0 -0.25 -1.0 NOTE:1.Rise Time = 7ns max. Input Impedance = 1 megohm. 22pF 2.Rise Time = 10ns max. SET TIME BASE FOR 50 ns/cm Source Impedance = 50 Ohms 1cm Fig. 1-REVERSE RECOVERY TIME CHARACTERISTIC AND TEST CIRCUIT DIAGRAM 6 PEAK FORWARD SURGE CURRENT AMPERES AVERAGE FORWARD RECTIFIED CURRENT, AMPERES 500 SINGLE PHASE HALF WAVE 60Hz RESISTIVE OR INDUCTIVE LOAD 5 4 3 2 1 0 20 40 60 80 100 120 140 160 180 300 8.3ms SINGLE HALF SINE-WAVE TJ = 25 ¢J 200 100 10 1 2 200 AMBIENT TEMPERATURE, ¢J 100 NUMBER OF CYCLES AT 60Hz Fig. 2-FORWARD CHARACTERISTICS INSTANTANEOUS FORWARD CURRENT AMPERES 400 Fig. 3-FORWARD CURRENT DERATING CURVE 100 10 1.0 TJ = 25 ¢J PULSE WIDTH = 300uS 0.1 0.6 0.8 1.0 1.2 1.4 1.6 1.8 2.0 INSTANTANEOUS FORWARD VOLTAGE, VOLTS Fig. 4-TYPICAL FORWARD CHARACTERISTIC