UF600 THRU UF608 ULTRAFAST SWITCHING RECTIFIER VOLTAGE - 50 to 800 Volts CURRENT - 6.0 Amperes FEATURES l Plastic package has Underwriters Laboratory Flammability Classification 94V-O utilizing Flame Retardant Epoxy Molding Compound l Void-free Plastic in P600 package l 6.0 ampere operation at TA=55 ¢J with no thermal runaway l l P600 Exceeds environmental standards of MIL-S-19500/228 Ultra fast switching for high efficiency MECHANICAL DATA Case: Molded plastic, P600 Terminals: Axial leads, solderable per MIL-STD-202, Method 208 Polarity: Band denotes cathode Mounting Position: Any Weight: 0.07 ounce, 2.1 gram MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS Ratings at 25 ¢J ambient temperature unless otherwise specified. Single phase, half wave, 60Hz, resistive or inductive load UF600 UF601 Peak Reverse Voltage, Pepetitive ; VRM 50 100 Maximum RMS Voltage 35 70 DC Blocking Voltage; VR 50 100 Average Forward Current, Io @TA=55 ¢J 3.8” lead length, 60Hz, resistive or inductive load Peak Forward Surge Current IFM (surge) 8.3msec. single half sine-wave superimposed on rated load (JEDEC method) 1.00 Maximum Forward Voltage VF @6.0A, 25 ¢J Maximum Reverse Current, @ Rated TJ=25 ¢J Reverse Voltage TJ=100 ¢J Typical Junction capacitance (Note 1) CJ Typical Junction Resistance (Note 2) R £KJA Reverse Recovery Time 50 50 IF=.5A, IR=1A, Irr=.25A Operating and Storage Temperature Range UF602 200 140 200 UF604 400 280 400 6.0 UF606 600 420 600 UF608 800 560 800 300 50 1.10 10.0 1000 300 10.0 50 UNITS V V V A A 1.70 75 -55 TO +150 NOTES: 1. Measured at 1 MHz and applied reverse voltage of 4.0 VDC 2. Thermal resistance from junction to ambient and from junction to lead length 0.375”(9.5mm) P.C.B. mounted V £g A £g A PF ¢J /W ns ¢J RATING AND CHARACTERISTIC CURVES UF600 THRU UF608 trr +0.5A 0 -0.25 -1.0 NOTE:1.Rise Time = 7ns max. Input Impedance = 1 megohm. 22pF 2.Rise Time = 10ns max. 1cm SET TIME BASE FOR 50 ns/cm Source Impedance = 50 Ohms AVERAGE FORWARD CURRENT, AMP Fig. 1-REVERSE RECOVERY TIME CHARACTERISTIC AND TEST CIRCUIT DIAGRAM 10 UF600 TYPICAL IFM, Apk 1 UF608 TJ = 25 ¢J 0.1 0.01 0 .2 .4 .6 .8 1.0 1.2 1.4 1.6 FORWARD VOLTAGE-VFM(Vpk) 5 4 3 2 1 SINGLE PHASE HALF WAVE 60Hz RESISTIVE OR INDUCTIVE LOAD .375" LEAD LENGTHS 0 25 50 75 100 125 150 175 AMBIENT TEMPERATURE, ¢J Fig. 2-FORWARD CHARACTERISTICS Fig. 3-FORWARD CURRENT DERATING CURVE 100 10 TJ = 125 ¢J PEAD FORWARD SURGE CURRENT, AMPERES INSTANTANEOUS REVERSE LEAKAGE CURRENT, MICROAMPERES 6 TJ = 100 ¢J 1 TJ = 25 ¢J 0.1 0.01 0 20 40 60 80 100 120 140 PERCENT OF RATED PEAK REVERSE VOLTAGE, % Fig. 4-TYPICAL REVERSE LEAKAGE CHARACTERISTICS 500 400 8.3ms SINGLE HALF SINE-WAVE TJ = 25 ¢J 300 200 100 1 2 4 6 8 10 20 40 60 80 100 NUMBER OF CYCLES AT 60Hz Fig. 5-PEAK FORWARD SURGE CURRENT