74LX1G86 SINGLE EXCLUSIVE OR GATE ■ ■ ■ ■ ■ ■ ■ ■ 5V TOLERANT INPUTS HIGH SPEED: tPD = 5ns (MAX.) at VCC = 3V LOW POWER DISSIPATION: ICC = 1µA (MAX.) at TA = 25°C POWER DOWN PROTECTION ON INPUTS AND OUTPUTS SYMMETRICAL OUTPUT IMPEDANCE: |IOH| = IOL = 24mA (MIN) at VCC = 3V BALANCED PROPAGATION DELAYS: tPLH ≅ tPHL OPERATING VOLTAGE RANGE: VCC(OPR) = 1.65V to 5.5V (1.2V Data Retention) IMPROVED LATCH-UP IMMUNITY DESCRIPTION The 74LX1G86 is a low voltage CMOS SINGLE EXCLUSIVE OR GATE fabricated with sub-micron silicon gate and double-layer metal wiring C2MOS technology. SOT23-5L SOT323-5L ORDER CODES PACKAGE T&R SOT23-5L SOT323-5L 74LX1G86STR 74LX1G86CTR Power down protection is provided on all inputs and 0 to 7V can be accepted on inputs with no regard to the supply voltage. This device can be used to interface 5V to 3V. All inputs and outputs are equipped with protection circuits against static discharge. PIN CONNECTION AND IEC LOGIC SYMBOLS April 2004 1/10 74LX1G86 INPUT EQUIVALENT CIRCUIT PIN DESCRIPTION PIN N° SYMBOL 1 2 4 3 1A 1B 1Y GND VCC 5 TRUTH TABLE NAME AND FUNCTION Data Input Data Input Data Output Ground (0V) A B Y L L H H L H L H L H H L Positive Supply Voltage ABSOLUTE MAXIMUM RATINGS Symbol VCC Parameter Value Unit Supply Voltage -0.5 to +7.0 V VI DC Input Voltage -0.5 to +7.0 V VO DC Output Voltage (VCC = 0V) -0.5 to +7.0 V VO DC Output Voltage (High or Low State) (note 1) IIK DC Input Diode Current IOK IO -0.5 to VCC + 0.5 V - 50 mA DC Output Diode Current (note 2) - 50 mA DC Output Current ± 50 mA ICC or IGND DC VCC or Ground Current per Supply Pin Tstg Storage Temperature TL Lead Temperature (10 sec) ± 50 mA -65 to +150 °C 300 °C Absolute Maximum Ratings are those values beyond which damage to the device may occur. Functional operation under these conditions is not implied 1) IO absolute maximum rating must be observed 2) VO < GND 2/10 74LX1G86 RECOMMENDED OPERATING CONDITIONS Symbol VCC Parameter Supply Voltage (note 1) Value Unit 1.65 to 5.5 V VI Input Voltage 0 to 5.5 V VO Output Voltage (VCC = 0V) 0 to 5.5 V VO Output Voltage (High or Low State) 0 to VCC V IOH, IOL High or Low Level Output Current (VCC = 4.5 to 5.5V) ± 32 mA IOH, IOL High or Low Level Output Current (VCC = 3.0 to 3.6V) ± 24 mA IOH, IOL High or Low Level Output Current (VCC = 2.7 to 3.0V) ± 12 mA IOH, IOL High or Low Level Output Current (VCC = 2.3 to 2.7V) ±8 mA IOH, IOL High or Low Level Output Current (VCC = 1.65 to 2.3V) ±4 mA Top dt/dv Operating Temperature Input Rise and Fall Time (note 2) -55 to 125 °C 0 to 10 ns/V 1) Truth Table guaranteed: 1.2V to 3.6V 2) VIN from 0.8V to 2V at VCC = 3.0V DC SPECIFICATIONS Test Condition Symbol VIH VIL VOH Parameter II Ioff ICC -40 to 85 °C -55 to 125 °C VCC (V) Min. High Level Input Voltage 1.65 to 1.95 0.75VCC 0.75VCC 2.3 to 2.7 0.7VCC 0.7VCC 3.0 to 5.5 0.7VCC Low Level Input Voltage 1.65 to 1.95 High Level Output Voltage Low Level Output Voltage Input Leakage Current Power Off Leakage Current Quiescent Supply Current Max. Min. Unit Max. V 0.7VCC 0.25VCC 0.25VCC 2.3 to 2.7 0.3VCC 0.3VCC 3.0 to 5.5 0.3VCC 0.3VCC V 1.65 to 3.6 IO=-100 µA VCC-0.1 VCC-0.1 1.65 IO=-4 mA 1.2 1.2 2.3 IO=-8 mA 1.9 1.9 2.7 IO=-12 mA 2.2 2.2 IO=-18 mA 2.4 2.4 IO=-24 mA 2.2 2.2 4.5 IO=-32 mA 3.8 3.8 1.65 to 3.6 IO=100 µA 0.1 0.1 1.65 IO=4 mA 0.45 0.45 2.3 IO=8 mA 0.3 0.3 2.7 IO=12 mA 0.4 0.4 3.0 IO=24 mA 0.55 0.55 4.5 IO=32 mA 0.55 0.55 1.65 to 5.5 VI = 0 to 5.5V ± 10 ± 10 µA 0 VI or VO = 5.5V 10 10 µA 3.0 VOL Value V 1.65 to 5.5 VI = VCC or GND 10 10 3.6 VI or VO = 3.6 to 5.5V ± 10 ± 10 V µA 3/10 74LX1G86 AC ELECTRICAL CHARACTERISTICS Test Condition Symbol tPLH tPHL Parameter Propagation Delay Time VCC (V) 1.65 to 1.95 2.3 to 2.7 3.0 to 3.6 4.5 to 5.5 1.65 to 1.95 2.3 to 2.7 2.7 3.0 to 3.6 4.5 to 5.5 CL (pF) RL (Ω) Value ts = tr (ns) 15 1M 3.0 30 30 50 50 50 1000 500 500 500 500 2.0 2.0 2.5 2.5 2.5 -40 to 85 °C -55 to 125 °C Min. Max. Min. Max. 2.0 2.0 1.0 1.0 2 2 1 1 1 9.0 5.0 4.8 3.6 9.9 5.5 5.2 5 4 2.0 2.0 1.0 1.0 2 2 1 1 1 9.0 5.0 4.8 3.6 9.9 5.5 5.2 5 4 Unit ns CAPACITIVE CHARACTERISTICS Test Condition Symbol Parameter Value TA = 25 °C VCC (V) Min. CIN Input Capacitance CPD Power Dissipation Capacitance (note 1) 0 1.8 2.5 3.3 fIN = 10MHz Typ. Unit Max. 4 pF 21 24 26 pF 1) CPD is defined as the value of the IC’s internal equivalent capacitance which is calculated from the operating current consumption without load. (Refer to Test Circuit). Average operating current can be obtained by the following equation. ICC(opr) = CPD x VCC x fIN + ICC 4/10 74LX1G86 TEST CIRCUIT RT = ZOUT of pulse generator (typically 50Ω) TEST CIRCUIT AND WAVEFORM SYMBOL VALUE VCC Symbol 1.65 to 1.95V 2.3 to 2.7V 2.7 to 5.5V CL 15/30pF 15/30pF 15/50pF RL 1MΩ/1000Ω 1M/500Ω 1M/500Ω VIH VCC VCC VCC VM VCC/2 VCC/2 VCC/2 tr = tr <2.0ns <2.0ns <2.5ns WAVEFORM: PROPAGATION DELAY (f=1MHz; 50% duty cycle) 5/10 74LX1G86 SOT23-5L MECHANICAL DATA mm. mils DIM. MIN. TYP MAX. MIN. TYP. MAX. A 0.90 1.45 35.4 57.1 A1 0.00 0.10 0.0 3.9 A2 0.90 1.30 35.4 51.2 b 0.35 0.50 13.7 19.7 C 0.09 0.20 3.5 7.8 D 2.80 3.00 110.2 118.1 E 1.50 1.75 59.0 68.8 e 0.95 37.4 H 2.60 3.00 102.3 118.1 L 0.10 0.60 3.9 23.6 . 7049676C 6/10 74LX1G86 SOT323-5L MECHANICAL DATA mm. mils DIM. MIN. TYP MAX. MIN. TYP. MAX. A 0.80 1.10 31.5 43.3 A1 0.00 0.10 0.0 3.9 A2 0.80 1.00 31.5 39.4 b 0.15 0.30 5.9 11.8 C 0.10 0.18 3.9 7.1 D 1.80 2.20 70.9 86.6 E 1.80 2.40 70.9 94.5 E1 1.15 1.35 45.3 53.1 e 0 .65 25.6 e1 1.3 51.2 L 0.10 0.30 3.9 11.8 7/10 74LX1G86 Tape & Reel SOT23-xL MECHANICAL DATA mm. inch DIM. MIN. TYP A MIN. TYP. 180 13.0 13.2 MAX. 7.086 C 12.8 D 20.2 0.795 N 60 2.362 T 8/10 MAX. 0.504 0.512 14.4 0.519 0.567 Ao 3.13 3.23 3.33 0.123 0.127 0.131 Bo 3.07 3.17 3.27 0.120 0.124 0.128 Ko 1.27 1.37 1.47 0.050 0.054 0.0.58 Po 3.9 4.0 4.1 0.153 0.157 0.161 P 3.9 4.0 4.1 0.153 0.157 0.161 74LX1G86 Tape & Reel SOT323-xL MECHANICAL DATA mm. inch DIM. MIN. TYP MAX. MIN. TYP. MAX. A 175 180 185 6.889 7.086 7.283 C 12.8 13 13.2 0.504 0.512 0.519 D 20.2 N 59.5 0.795 60 T 60.5 2.362 14.4 0.567 Ao 2.25 0.088 Bo 2.7 0.106 Ko 1.2 0.047 Po 3.9 4 4.1 0.153 0.157 0.161 P 3.8 4 4.2 0.149 0.157 0.165 9/10 74LX1G86 Information furnished is believed to be accurate and reliable. However, STMicroelectronics assumes no responsibility for the consequences of use of such information nor for any infringement of patents or other rights of third parties which may result from its use. No license is granted by implication or otherwise under any patent or patent rights of STMicroelectronics. Specifications mentioned in this publication are subject to change without notice. This publication supersedes and replaces all information previously supplied. STMicroelectronics products are not authorized for use as critical components in life support devices or systems without express written approval of STMicroelectronics. The ST logo is a registered trademark of STMicroelectronics All other names are the property of their respective owners © 2004 STMicroelectronics - All Rights Reserved STMicroelectronics GROUP OF COMPANIES Australia - Belgium - Brazil - Canada - China - Czech Republic - Finland - France - Germany - Hong Kong - India - Israel - Italy - Japan Malaysia - Malta - Morocco - Singapore - Spain - Sweden - Switzerland - United Kingdom - United States. http://www.st.com 10/10