LM146 LM246 - LM346 PROGRAMMABLE QUAD BIPOLAR OPERATIONAL AMPLIFIERS . .. .. .. . . PROGRAMMABLE ELECTRICAL CHARACTERISTICS BATTERY POWERED OPERATION LOW SUPPLY CURRENT (250µA/amplifier) GAIN-BANDWIDTH PRODUCT : 1MHz LARGE DC VOLTAGE GAIN : 120dB LOW NOISE VOLTAGE : 28nV/VHz WIDE POWER SUPPLY RANGE : ±1.5V to ±22V CLASSE AB OUTPUT STAGE. NO CROSSOVER DISTORTION OVERLOAD PROTECTION FOR INPUTS AND OUTPUTS N DIP16 (Plastic Package) D SO16 (Plastic Micropackage) ORDER CODES Part Number DESCRIPTION The LM346 consists of four independent, high gain, internally compensated, low power programmable amplifiers. Two external resistors (Rset) allow the user to program the gain-bandwith product, slew rate, supply current, input bias current, input offset current and input noise. For example the user can trade-off supply current for bandwidth or optimize noise figure for a given source resistance. In a similar way other amplifier characteristics can be tailored to the application. Except for the two programming pins at the end of the package the LM346 pin out is the same as the LM324 and LM348. PROGRAMMING EQUATIONS : Total supply current = 1mA (Iset = 10µA) Gain-bandwidthproduct = 1MHz (Iset = 10µA) Slew rate = 0.5V/µs (Iset = 10µA) Input bias current ≈30 nA (Iset = 10µA) Iset = current into pin 8 and pin 9 (see schematic diagram) Iset = Package Temperature Range N D LM146 –55oC, +125oC • • LM246 –40 C, +105 C o • • 0 C, +70 C • • o o LM346 o Example : LM246N PIN CONNECTIONS (top view) Output1 Inverting input 1 Non-invertinginput 1 V + CC Non-invertinginput 2 Inverting input 2 Output2 Set 1 16 Output4 2 15 Inverting input 4 3 14 Non-invertinginput 4 4 13 VCC 5 12 Non-invertinginput 3 6 11 Inverting input 3 7 10 Output 3 8 9 Set VCC + − VCC − − 0.6V Rset November 1997 1/9 LM146 - LM246 - LM346 SCHEMATIC DIAGRAM (1/4 LM146) V CC Q15 Q16 Q10 R1 30Ω Q12 Inverting input Q1 Noninverting input Q2 Output Q14 CC 8pF Q11 V CC V CC Q13 Q9 VCC V CC R set Q6 I set Q5 SET R set To other op amps I set SET Q20 Q17 Q8 Q3 Q4 Q21 Q7 R2 1kΩ Q18 Q19 V CC V CC or ABSOLUTE MAXIMUM RATINGS Symbol LM146 LM246 LM346 Unit Supply Voltage ±22 ±22 ±22 V Vi Input Voltage - (note 1) ±15 ±15 ±15 V Vid Differential Input Voltage ±30 ±30 ±30 V VCC Parameter Output Short-circuit Duration - (note 2) Ptot Toper Tstg Infinite Power Dissipation N/D Suffix Operating Free-air Temperature Range Storage Temperature Range mW 500 –55 to +125 –65 to +150 –40 to +105 –65 to +150 0 to +70 o –65 to +150 o Notes : 1. For suppl y voltages l ess than ±15V, the absolute maximum input vol tage is equal to the supply vol tage. 2. Any of t he amplifi er out puts can be shorted to ground indef initl y ; however more than one should not be simultaneously shorted as the maximum junction temperature wil l be exceeded. 2/9 C C LM146 - LM246 - LM346 ELECTRICAL CHARACTERISTICS VCC = ±15V, Iset = 10µA, Tamb = +25oC (unless otherwise specified) Symbol Vio Iio Iib Avd SVR ICC Parameter LM146 Min. Typ. Max. 0.5 Input Offset Current T amb = 25oC T min. ≤ Tamb ≤ Tmax. Input Bias Current T amb = 25oC T min. ≤ Tamb ≤ Tmax. Input Offset Voltage (R S ≤ 10kΩ) o T amb = 25 C T min. ≤ Tamb ≤ Tmax. Typ. Max. 3 5 0.5 5 6 2 20 25 2 100 100 30 100 100 30 250 250 nA Large Signal Voltage Gain (Vo = ±10V, RL = 10kΩ) T amb = 25oC T min. ≤ Tamb ≤ Tmax. 100 50 1000 50 25 1000 Supply Voltage Rejection Ratio (RS ≤ 10kΩ) o T amb = 25 C T min. ≤ Tamb ≤ Tmax. 80 80 110 80 80 110 V/mV dB Supply Current, all Amp, no Load o T amb = 25 C T min. ≤ Tamb ≤ Tmax. mA 1 CMR Common Mode Rejection Ratio (RS ≤ 10kΩ) o T amb = 25 C T min. ≤ Tamb ≤ Tmax. 80 70 110 Output Short-circuit Current o T amb = 25 C T min. ≤ Tamb ≤ Tmax. 10 4 20 Output Voltage Swing (RL = 10kΩ) o T amb = 25 C T min. ≤ Tamb ≤ Tmax. 12 12 Slew Rate (VI = ±10V, R L = 10kΩ, CL = 100pF, unity Gain) 0.3 SR Unit nA Input Common Mode Voltage Range T amb = 25oC T min. ≤ Tamb ≤ Tmax. ± Vopp Min. mV Vicm IOS LM246 - LM346 2 2 ±13.5 ±13.5 1 2 2 V ±13.5 ±13.5 dB 80 70 110 10 4 20 14 12 12 14 0.5 0.3 0.5 mA 30 35 30 35 V V/µs RI Input Resistance 1 1 MΩ CI Input Capacitance 2 2 pF 120 120 dB Vo1/Vo2 GBP THD en Channel Separation (RL = 10kΩ, Vo = 12Vpp) Gain Bandwidth Product (VI = 10 mV, RL = 10kΩ, CL = 100pF f = 100kHz) Total Harmonic Distortion (f = 1kHz, Av = 20dB, RL = 10kΩ CL = 100pF, vo = 2Vpp) Equivalent Input Noise Voltage (f = 1kHz, Rs = 100Ω) MHz 0.8 1 0.5 1 % 0.015 0.015 28 28 nV √ Hz 3/9 LM146 - LM246 - LM346 4/9 LM146 - LM246 - LM346 5/9 LM146 - LM246 - LM346 6/9 LM146 - LM246 - LM346 INPUT (mV) OUTPUT (mV) VOLTAGE FOLLOWER TRANSIENT RESPONSE = 10 µA 50 I 0 VC C = 1 5V Ta mb = +25 ° C s et TRANSIENT RESPONSE TEST CIRCUIT -50 eI 50 C L = 100pF R L = 10kΩ 0 G 1/4 LM146 RL CL -50 0 1 2 TIME ( 3 4 5 µs) 7/9 LM146 - LM246 - LM346 PM-DIP16.EPS PACKAGE MECHANICAL DATA 16 PINS - PLASTIC DIP a1 Min. 0.51 B 0.77 Millimeters Typ. Min. 0.020 1.65 0.030 Inches Typ. Max. 0.065 b 0.5 0.020 b1 0.25 0.010 D 20 0.787 E 8.5 0.335 e 2.54 0.100 e3 17.78 0.700 F 7.1 0.280 i 5.1 0.201 L Z 8/9 Max. 3.3 0.130 1.27 0.050 DIP16.TBL Dimensions LM146 - LM246 - LM346 PM-SO16.EPS PACKAGE MECHANICAL DATA 16 PINS - PLASTIC MICROPACKAGE (SO) Min. Millimeters Typ. A a1 0.1 a2 Max. 1.75 Min. 0.2 0.004 Inches Typ. Max. 0.069 0.008 1.6 0.063 b 0.35 0.46 0.014 0.018 b1 0.19 0.25 0.007 0.010 C 0.5 0.020 o 45 (typ.) c1 D 9.8 10 0.386 0.394 E 5.8 6.2 0.228 0.244 e 1.27 0.050 e3 8.89 0.350 F 3.8 4.0 0.150 0.157 G 4.6 5.3 0.181 0.209 SO16.TBL Dimensions Information furnished is believed to be accurate and reliable. However, SGS-THOMSON Microelectronics assumes no responsibility for the consequences of use of such information nor for any infringement of patents or other rights of third parties which may result from its use. No license is granted by implication or otherwise under any patent or patent rights of SGS-THOMSON Microelectronics. Specification mentioned in this publ ication are subject to change without notice. This publication supersedes and replaces all information previously supplied. SGS-THOMSON Microelectronics products are not authorized for use as critical components in life support devices or systems without express written approval of SGS-THOMSON Microelectronics. ORDER CODE : 1997 SGS-THOMSON Microelectronics – Printed in Italy – All Rights Reserved SGS-THOMSON Microelectronics GROUP OF COMPANIES Australia - Brazil - Canada - China - France - Germany - Hong Kong - Italy - Japan - Korea - Malaysia - Malta - Morocco The Netherlands - Singapore - Spain - Sweden - Switzerland - Taiwan - Thailand - United Kingdo m - U.S.A. 9/9