UTC BA6208 LINEAR INTEGRATED CIRCUIT REVERSIBLE MOTOR DRIVER DESCRIPTION The UTC BA6208 is monolithic ICs used for driving reversible motors. They allow control of reversible motors in cassette players and other electrical equipment by using TTL-level logic signals. The ICs contain a logic section, which controls forward and reverse rotations as well as forced stop, and an output power section, which can supply an output current of up to 100mA (typical) according to the logic control. SIP-9 FEATURES *Motor driving power transistors are built in (100mA typically). *Brake is applied when stopping the motor (when in- puts A and B are both HIGH level). *Built-in diode to absorb surge currents. *Very low standby circuit current when inputs A and B are both LOW level. *Wide range of operating supply voltage (4.5 ~ 15.0V) *Direct control with the TTL logic. SOP-8 ABSOLUTE MAXIMUM RATING (Ta=25°C) SYMBOL VALUE Power Supply Voltage PARAMETER Vcc 18 UNIT V Power Dissipation Pd 700 (SIP9) [note 1] mW 450 (SOP8) [note 2] mW Operating Temperature Topr -20 to +60 °C Storage Temperature Tstg -55 to +125 °C Maximum Output Current Iout 500 mA Note 1: Reduced by 7mW for each increase in Ta of 1°C over 25°C. Note 2: Reduced by 4.5mW for each increase in Ta of 1°C over 25°C. RECOMMENDED OPERATING CONDITIONS (Ta=25°C) PARAMETER Power Supply Voltage UTC SYMBOL MIN Vcc 4.5 TYP UNISONIC TECHNOLOGIES MAX UNIT 15 V CO., LTD. 1 QW-R109-004,A UTC BA6208 LINEAR INTEGRATED CIRCUIT INPUT TRUTH TABLE 3pin (Ain) 2pin (Bin) 8pin (Aout) H L H 7pin (Bout) L L H L H H H L L L L OPEN OPEN Note: HIGH level input is 2.0V or more. LOW level input is 0.8V or less. ELECTRICAL CHARACTERISTICS (Ta=25°C, VCC=9V, unless otherwise specified) PARAMETER SYMBOL Output Current TEST CONDITIONS IO Output Saturation Voltage VCE Input High Level Voltage VIH Input Low Level Voltage VIL Standby Supply Current IST MIN TYP MAX UNIT 200 Io=100mA mA 1.6 V 0.8 V 0.4 mA 400 µA 2.0 When inputs A and B are V both Low level Input High Level Current IIH VIH =4.5V Note: A diode that absorbs at least 500mA is built in to give protection against surge currents with a pulse width of 10 ms and a duty ratio of 10% or less. UTC UNISONIC TECHNOLOGIES CO., LTD. 2 QW-R109-004,A UTC BA6208 LINEAR INTEGRATED CIRCUIT TEST CIRCUIT UTC UNISONIC TECHNOLOGIES CO., LTD. 3 QW-R109-004,A