UNISONIC TECHNOLOGIES CO., LTD TL1093 LINEAR INTEGRATED CIRCUIT PROGRAMMABLE PRECISION REFERENCE DESCRIPTION The UTC TL1093 is a three-terminal adjustable regulator with a guaranteed thermal stability over applicable temperature ranges. The output voltage may be set to any value between VREF (approximately 2.5V) and 36 V with two external resistors. It provides very wide applications, including shunt regulator, series regulator, switching regulator, voltage reference and others. FEATURES *Programmable output Voltage to 36V. *Low dynamic output impedance 0.2Ω. *Sink current capability of 1.0 to 100mA. *Equivalent full-range temperature coefficient of 50ppm/ °C typical for operation over full rated operating temperature range. 1 SOT-89 Lead-free: TL1093L Halogen-free:TL1093G ORDERING INFORMATION Ordering Number Normal Lead Free TL1093-AB3-R TL1093L-AB3-R Note: Pin Code: K: Cathode A: Anode TL1093L-AB3-R Halogen Free TL1093G-AB3-R R: Reference Package SOT-89 Pin Assignment 1 2 3 K A R Packing Tape Reel (1)Packing Type (1) R: Tape Reel (2)Package Type (2) AB3: SOT-89 (3)Lead Plating (3) G: Halogen Free, L: Lead Free Plating, Blank: Pb/Sn www.unisonic.com.tw Copyright © 2009 Unisonic Technologies Co., Ltd 1 of 5 QW-R103-045.A TL1093 LINEAR INTEGRATED CIRCUIT BLOCK DIAGRAM CATHODE REFERENCE CATHODE (K) REFERENCE (R) 2.5V VREF ANODE(A) ANODE UNISONIC TECHNOLOGIES CO., LTD www.unisonic.com.tw 2 of 5 QW-R103-045.A TL1093 LINEAR INTEGRATED CIRCUIT ABSOLUTE MAXIMUM RATINGS (Operating temperature range applies unless otherwise specified) PARAMETER SYMBOL RATINGS UNIT Cathode Voltage VKA 37 V Cathode Current Range(Continuous) IKA -100 ~ +150 mA Reference Input Current Range IREF -0.05 ~ +10 mA Power Dissipation PD 800 mW Operating Junction Temperature TJ +150 °C Operating Ambient Temperature TOPR -40 ~ +85 °C Storage Temperature TSTG -65 ~ +150 °C Absolute maximum ratings are those values beyond which the device could be permanently damaged. Note: Absolute maximum ratings are stress ratings only and functional device operation is not implied. RECOMMENDED OPERATING CONDITIONS PARAMETER Cathode Voltage Cathode Current SYMBOL VKA IKA MIN TYP MAX UNIT VREF 36 V 1 100 mA ELECTRICAL CHARACTERISTICS (TC= 25°C, unless otherwise specified.) PARAMETER SYMBOL TEST CONDITIONS Reference Input Voltage VREF VKA=VREF,IKA=10mA Deviation of reference Input Voltage Over ΔVREF VKA=VREF,IKA=10mA ΔT temperature 0°C≤Ta≤70°C ΔVREF Ratio of Change in Reference Input ΔVKA=10V~VREF IKA=10mA Voltage to the Change in Cathode Voltage ΔVKA ΔVKA=36V~10V Reference Input Current IREF IKA=10mA, R1=10kΩ, R2=∞ Deviation of Reference Input Current Over ΔIREF IKA=10mA, R1=10kΩ, R2=∞ ΔT Full Temperature Range Ta =full Temperature Minimum Cathode Current for Regulation IKA(MIN) VKA=VREF Off-State Cathode Current IKA(OFF) VKA=36V, VREF=0 VKA=VREF, IKA=1 to 100mA Dynamic Impedance ZKA f≤1.0kHz UNISONIC TECHNOLOGIES CO., LTD www.unisonic.com.tw MIN TYP MAX UNIT 2.470 2.495 2.520 V 4.5 17 mV -1.0 -0.5 1.5 -2.7 mV/V -2.0 mV/V 4 µA 0.4 1.2 µA 0.19 0.05 0.5 1.0 mA µA 0.15 0.5 Ω 3 of 5 QW-R103-045.A TL1093 LINEAR INTEGRATED CIRCUIT ■ TYPICAL CHARACTERISTICS Cathode Current vs. Cathode Voltage Cathode Current vs. Cathode Voltage 150 800 Ta=25°C 125 V =V KA REF 600 Cathode Current (μA) Cathode Current (mA) 100 Ta=25°C VKA=VREF 75 50 25 0 -25 -50 400 IKA(MIN) 200 0 -75 -100 -2 -1 0 1 2 -200 -2 3 -1 0 Cathode Voltage (V) Change in Reference Input Voltage vs. Cathode Voltage IKA=100mA Ta=25°C -5 3 Ta=25°C 6 -10 -15 -20 -25 -30 -35 -40 2 Pulse Response 7 Input and Output Voltage (V) Change In Reference Input Voltage (mV) 0 1 Cathode Voltage (V) 5 4 3 2 1 0 0 5 10 15 20 25 30 35 40 Cathode Voltage (V) UNISONIC TECHNOLOGIES CO., LTD www.unisonic.com.tw -1 -1 0 1 2 3 4 5 6 7 Time (µs) 4 of 5 QW-R103-045.A TL1093 LINEAR INTEGRATED CIRCUIT TEST CIRCUIT VKA INPUT VKA INPUT IKA IKA(OFF) UTC TL1093 UTC TL1093 VREF VKA=VREF×(1+R1/R2)+IREF×R1 For VKA≥VREF For VKA=VREF For IKA(OFF) APPLICATION CIRCUIT VIN IN UTC7805 VOUT OUT COMMON R1 VREF R2 UTC TL1093 Output Control of a Three -Terminal Fixed Regulator Shutdown Regulator VOUT VIN VIN IOUT VOUT R1 VREF R2 UTC TL1093 VOUT=(1+R1/R2)×VREF Minimum VOUT=VREF+5V VOUT=(1+R1/R2)×VREF VIN VOUT=(1+R1/R2)×VREF Higher-current Shunt Regulator IOUT VOUT RCL RS RS UTC TL1093 UTC TL1093 IOUT=VREF/RS RS=VREF/RCL Constant-current Sink Current Limiting or Current Source UTC assumes no responsibility for equipment failures that result from using products at values that exceed, even momentarily, rated values (such as maximum ratings, operating condition ranges, or other parameters) listed in products specifications of any and all UTC products described or contained herein. UTC products are not designed for use in life support appliances, devices or systems where malfunction of these products can be reasonably expected to result in personal injury. Reproduction in whole or in part is prohibited without the prior written consent of the copyright owner. The information presented in this document does not form part of any quotation or contract, is believed to be accurate and reliable and may be changed without notice. UNISONIC TECHNOLOGIES CO., LTD www.unisonic.com.tw 5 of 5 QW-R103-045.A