UNISONIC TECHNOLOGIES CO., LTD UM5237

UNISONIC TECHNOLOGIES CO., LTD
UM5237
Preliminary
LINEAR INTEGRATED CIRCUIT
3-TERMINAL ADJUSTABLE
REGULATOR

DESCRIPTION
The UTC UM5237 is a 3-terminal adjustable regulator. It’s
used as a variable output voltage regulator.
The UTC UM5237 has a less power dissipation and more
exact loading voltage regulation .it‘s suitable for driver circuit,
differential amplifier and reference voltage generator circuit, etc.

1
SOT-89
FEATURES
* Wide Input/Output voltage range
* Low Dropout Voltage
* Over current protect
* External circuit can adjust the output voltage

ORDERING INFORMATION
Ordering Number
Lead Free
Halogen Free
UM5237L-AB3-R
UM5237G-AB3-R
Note: Pin Assignment: O: OUTPUT G: GROUND I: INPUT
UM5237G-AB3-R

Package
SOT-89
Pin Assignment
1
2
3
O
G
I
(1)Packing Type
(1) R: Tape Reel
(2)Package Type
(2) AB3: SOT-89
(3)Halogen Free
(3) G: Halogen Free, L: Lead Free
Packing
Tape Reel
MARKING INFORMATION
www.unisonic.com.tw
Copyright © 2013 Unisonic Technologies Co., Ltd
1 of 6
QW-R101-040.c
UM5237

Preliminary
LINEAR INTEGRATED CIRCUIT
BLOCK DIAGRAM
UNISONIC TECHNOLOGIES CO., LTD
www.unisonic.com.tw
2 of 6
QW-R101-040.c
UM5237

Preliminary
LINEAR INTEGRATED CIRCUIT
ABSOLUTE MAXIMUM RATING (TA=25°C, unless otherwise noted)
PARAMETER
SYMBOL
RATINGS
UNIT
Input Voltage
VIN
30
V
Drive Current
ID
30
mA
Input/Output Voltage Difference
VIN -VOUT
28
V
Internal Power Dissipation
PD
500
mW
Operating Temperature
TOPR
-20~+75
°C
Storage Temperature
TSTG
-55~+150
°C
Note: Absolute maximum ratings are those values beyond which the device could be permanently damaged.
Absolute maximum ratings are stress ratings only and functional device operation is not implied.

RECOMMENDED OPERATING CONDITIONS
PARAMETER
Supply Voltage Range
Output Voltage Range

SYMBOL
VIN
VOUT
RATINGS
3.5~30
1.5~25
UNIT
V
V
ELECTRICAL CHARACTERISTICS
Test circuit (a) is used with TA=25°C, VI=15V, VO=12V, IL=200mA, CREF=1μA, R1=4.3KΩ
PARAMETER
SYMBOL
TEST CONDITIONS
Input Voltage
VIN
Between Pin 1 and Pin 2
Output Voltage
VOUT
R2≈0.82~108KΩ
Minimum Input/Output Voltage
VIN -VOUT
Difference
Reference Voltage
VREF
Between Pin 2 and Pin 3
Input Voltage Regulation
Reg-in
VI=15~20V
Loading Voltage Regulation
Reg-L
IL=10~200mA
IL=0 (disregarding the current in
Bias Current
IB
resistors R1, R2)
Output Voltage Thermal Coefficient
TCVO
TA=0~75°C
f=120Hz
Ripple Rejection
RR
measured with circuit (b)
Output Noise Voltage
VNO
f=20Hz~100KHZ
UNISONIC TECHNOLOGIES CO., LTD
www.unisonic.com.tw
MIN
3.5
1.5
TYP
MAX
30
28
0.2
1.2
UNIT
V
V
V
1.26
0.02
0.02
1.32
0.1
0.1
V
%/V
%
1.7
3.0
mA
0.02
%/°C
68
dB
25
μVrms
3 of 6
QW-R101-040.c
UM5237

Preliminary
LINEAR INTEGRATED CIRCUIT
TEST CIRCUIT
(a) Standard test circuit
 R 
R 

VO=VREF  1  2   1.26   1  2  (V)
R
4.3


1 

 V

 V

R2=R1  O  1  4.3   O  1 (KΩ)
 1.26 
 VREF

(R1=4.3KΩ, VRER≈1.26V)
(b) Ripple rejection test circuit
f=120Hz, ei=0.1Vrms
2SB1314
+
R2
VI
220
C
0.33µF
1
UTC
UM5237
3
+
CREF
+
C
e
RR=20 log e i (dB)
o
C RL
47µ
IL
VV eo
R1
4.3K
2
UNISONIC TECHNOLOGIES CO., LTD
www.unisonic.com.tw
4 of 6
QW-R101-040.c
UM5237

Preliminary
LINEAR INTEGRATED CIRCUIT
TYPICAL APPLICATION CIRCUIT
1. Standard Application Circuit
R2 36.6KΩ
VI=12.2V
VO=12V
+
2SB1314
RI
220Ω
R1
CREF
4.3KΩ
1000pF
100µF
2
3
1
0.33µF

R
VO=VREF  1  2
R1


 V , VREF=1.26V


2. Maximum Drive Current Controller Application Circuit
R2 36.6KΩ
VI=12.2V
VO=12V
2SB1314
RI
220Ω
+
100µF
RIN
470Ω
R1
CREF
4.3KΩ
1000pF
3
2
1
0.33µF
3. Output Voltage ON/OFF Controller
Set control circuit resistor R so that voltage of point A is more than 1.5V and less than 5V
UNISONIC TECHNOLOGIES CO., LTD
www.unisonic.com.tw
5 of 6
QW-R101-040.c
UM5237
Preliminary
LINEAR INTEGRATED CIRCUIT
UTC assumes no responsibility for equipment failures that result from using products at values that
exceed, even momentarily, rated values (such as maximum ratings, operating condition ranges, or
other parameters) listed in products specifications of any and all UTC products described or contained
herein. UTC products are not designed for use in life support appliances, devices or systems where
malfunction of these products can be reasonably expected to result in personal injury. Reproduction in
whole or in part is prohibited without the prior written consent of the copyright owner. The information
presented in this document does not form part of any quotation or contract, is believed to be accurate
and reliable and may be changed without notice.
UNISONIC TECHNOLOGIES CO., LTD
www.unisonic.com.tw
6 of 6
QW-R101-040.c