THE CONNOR-WINFIELD CORP. 2111 COMPREHENSIVE DRIVE. AURORA, IL 60505. FAX (630) 851-5040. PHONE (630) 851-4722. www.conwin.com PRODUCT D ATA SHEET CRYSTAL CONTROLLED OSCILLATORS 14 PIN DIP 5.0V STRATUM 3 HCMOS OCXO CW 0107 AGOF5S3 12.800M ABSOLUTE MAXIMUM RATINGS PARAMETER TABLE 1.0 UNITS MINIMUM NOMINAL MAXIMUM UNITS -40 - 85 °C (Vcc) -0.5 - 7.0 Vdc NOMINAL MAXIMUM UNITS (Fo) MINIMUM 1.544 - 20.0 1.5 MHz Storage Temperature Supply Voltage NOTE AGOF5S3 OPERATING SPECIFICATIONS TABLE 2.0 PARAMETER Center Frequency Frequency Calibration Frequency Stability Aging (Daily) Aging (20 Years) Total Frequency Tolerance Operating Temperature Range -1.5 -0.25 -30 -2.5 -4.6 0 - 0.25 30 2.5 4.6 70 ppm ppm ppb ppm ppm °C Vdc NOTE (Vcc) 4.75 5.0 5.25 Supply Current (Icc) - - 300 mA Phase Jitter (BW=12KHz to 20MHz) - - 1 ps rms Phase Jitter (BW=10Hz to 20MHz) - - 3 ps rms Period Jitter SSB Phase Noise at 10Hz offset SSB Phase Noise at 10KHz offset Start Up Time: Oscillator Warm Up Time TDEV @ 1.0 Sec. TDEV @ 4.0 Sec. - -90 -135 - 3 10 5 1 2 ps rms dBc/Hz dBc/Hz mS Minutes nS nS TABLE 3.0 (Voh) (Vol) (High) (Low) Duty Cycle at 50% of Vcc Rise / Fall Time 10% to 90% MINIMUM 4.5 - (Ioh) (Ioh) -4 45 - NOMINAL - MAXIMUM 15 0.4 UNITS pf Vdc Vdc 50 - 4 55 6 mA mA % nS NOTE 5.0V OPERATION FIXED FREQUENCY LOW JITTER <1pS RMS FREQUENCY STABILITY ±0.25ppm OVERALL FREQUENCY TOLERANCE OF ±4.6ppm OVER TWENTY YEARS TABLE 4.0 PACKAGE CHARACTERISTICS Package 5 FEATURES HCMOS OUTPUT CHARACTERISTICS Current The Connor-Winfield AGOF5S3 is a hermetically sealed 14 Pin DIP, 5.0V Oven Controlled Crystal Oscillator (OCXO) HCMOS/TTL compatible output. The AGOF5S3 is designed for higher stability Stratum 3 applications requiring low jitter and tight frequency stability. 4 Supply Voltage PARAMETER LOAD Voltage (High) (Low) DESCRIPTION 1 2 3 14 pin DIP, hermetically sealed, grounded case, welded package TEMPERATURE RANGE: 0 to 70°C Notes: 1) 2) 3) 4) Initial calibration @ 25°C Frequency vs. temperature stability At the time of shipment after 48 hours of operation. Inclusive of calibration, operating temperature range, supply voltage change, load change, shock and vibration, 20 years aging. 5) Measured @ 25°C, within 5 minutes, the unit will be within +/-0.1ppm of its reference frequency, measured after 30 minutes of continuous operation at a stable 25 °C ORDERING INFORMATION AGOF5S3 OCXO SERIES - 12.800MHz CENTER FREQUENCY Specifications subject to change without notice. DATA SHEET #: Cx017 PAGE 1 OF 2 REV: 02 DATE: 7/22/03 aCopyright 2001 Connor-Winfield all rights reserved. THE CONNOR-WINFIELD CORP. 2111 COMPREHENSIVE DRIVE. AURORA, IL 60505. FAX (630) 851-5040. PHONE (630) 851-4722. www.conwin.com PRODUCT D ATA SHEET CRYSTAL CONTROLLED OSCILLATORS ENVIRONMENTAL CHARACTERISTICS Temperature Cycle: Per MIL-STD-883, Method 1010, Condition B. -55°C to 125°C, 20 cycles,10 minute dwell, 1m inute transition. Gross Leak Test: Per MIL-STD-202, Method 112, Condition D. No bubbles in flourinert (FC-43) at 125°C ±5°C for 20 seconds. SOLDERING Pin Solderability: Per MIL-STD-883, Method 200. 8 hour steam age prior to 254°C ±5°C Solder pot dip, 95% Coverage. Resistance to Solder Heat: Per MIL-STD-202, Method 210, Condition C. Wave: Topside board -mount product, 260°C ±5°C for 20 Seconds. MECHANICAL CHARACTERISTICS Vibration: Per MIL-STD-202, Method 204, Condition A. 10G’s peak, 10Hz to 500Hz, 15mi nute cycles 12 times each perpendicular axis. Shock: Per MIL-STD-202, Method 213, Condition D. 500G’s, 1ms, half sine, 3 shocks per direction. Moisture Resistance: Per MIL-STD-202, Method 106. 95% RH @ 65°C, 10 cycles 10°C to 65°C. +5.0Vdc Specifications subject to change without notice. DATA SHEET #: Cx017 PAGE 2 OF 2 REV: 02 DATE: 7/22/03 aCopyright 2001 Connor-Winfield all rights reserved.