THE CONNOR-WINFIELD CORP. 2111 COMPREHENSIVE DRIVE. AURORA, IL 60505. FAX (630) 851-5040. PHONE (630) 851-4722. WWW.CONWIN.COM PRODUCT DATA SHEET CRYSTAL CONTROLLED OSCILLATORS 14 PIN DIP 3.3V LVMOS STRATUM 3 OCVCXO CW 0643 AGOV3S3G 12.8M ABSOLU TE MAXI MUM RAT INGS PARAMETER TABLE 1.0 UNITS MINIMUM NOMINAL MAXIMUM UNITS -40 - 85 °C Storage Temperature NOTE AGOV3S3G Supply Voltage (Vcc) -0.5 - 4.5 Vdc Control Voltage (Vc) -0.5 - 4.5 Vdc NOMINAL MAXIMUM UNITS (Fo) MINIMUM 1.544 - 20.0 1.5 MHz ppm 1 -0.25 -30 -2.5 -4.6 0 - 0.25 30 2.5 4.6 70 ppm ppb ppm ppm °C 2 3 Vdc OPERATING SPECIFICATIO NS TABLE 2.0 PARAMETER Center Frequency Frequency Calibration, Vc=1.48 Vdc -1.5 Frequency Stability Aging (Daily) Aging (20 Years) Total Frequency Tolerance Operating Temperature Range 4 Supply Voltage (Vcc) 3.135 3.3 3.465 Supply Current (Icc) - - 450 mA Phase Jitter (BW=12KHz to 20MHz) - - 1 ps rms Phase Jitter (BW=10Hz to 20MHz) - - 3 ps rms Period Jitter SSB Phase Noise at 10Hz offset SSB Phase Noise at 10KHz offset Start Up Time: Oscillator Warm Up Time TDEV @ 1.0 Sec. TDEV @ 4.0 Sec. - -90 -135 - 5 35 5 1 2 ps rms dBc/Hz dBc/Hz mS Minutes nS nS MINIMUM NOMINAL MAXIMUM UNITS 0.3 -22.5 13.5 5 100k 1.48 - 3.0 -13.5 22.5 - Vdc ppm ppm ppm/V Ohm INPUT CHARACTERISTICS PARAMETER Control Voltage Range Frequency at Vc=0.3 Vdc Frequency at Vc=3.0 Vdc Slope of Frequency Adjust Input Impedance (Vc) LVMOS OUTPUT CHARACT ERISTICS (Voh) (Vol) MINIMUM 2.6 - Current (Ioh) -4 (Ioh) 45 - (High) (Low) Duty Cycle at 50% of Vcc Rise / Fall Time 10% to 90% NOMINAL - MAXIMUM 15 0.4 UNITS pf Vdc Vdc - mA 4 55 6 mA % nS 50 - TABLE 3.0 NOTE 6 6 FEATURES 3.3V OPERATION VOLTAGE CONTROLLED FREQUENCY ADJUST LOW JITTER <1pS RMS FREQUENCY STABILITY ±0.25ppm NOTE OVERALL FREQUENCY TOLERANCE: ±4.6ppm OVER TWENTY YEARS TEMPERATURE RANGE: 0 to 70°C HERMETICALLY SEALED 14 PIN PACKAGE RoHS COMPLIANT / LEAD FREE 14 pin DIP, hermetically sealed, grounded case, welded package Notes: 1) 2) 3) 4) Initial calibration @ 25°C, Vc=1.48 Vdc. Frequency vs. temperature stability At the time of shipment after48 hours of opera tion. Inclusive of calibration, operating temperature range, supply voltage change, load change, shock and vibration, 20 years aging, Vc=1.48 Vdc. 5) Measured @ 25°C, within 5 minutes, the unit will be within +/-0.1ppm of its reference frequency, measured after 30 minutes of continuous operation at a stable 25°C 6) Referenced to Fo @ 25°C, positive transfer characteristic. DATA SHEET #: The Connor-Winfield AGOV3S3G is a hermetically sealed 14 Pin DIP 3.3V Oven Controlled Voltage controlled Crystal Oscillator (OCVCXO) with an LVMOS output. The AGOV3S3G is designed for Stratum 3 applications requiring low jitter and tight frequency TABLE 5.0 PACKAG E CHARACTERISTICS Package 5 TABLE 4.0 PARAMETER LOAD Voltage (High) (Low) DESCRIPTION NOTE Cx106 PAGE 1 OF 2 REV: 00 DATE: 10/23/06 ORDERING INFORMATION AGOV3S3G OCXO SERIES - 12.800MHz CENTER FREQUENCY Specifications subject to change without notice. aCopyright 2001 Connor-Winfield all rights reserved. THE CONNOR-WINFIELD CORP. 2111 COMPREHENSIVE DRIVE. AURORA, IL 60505. FAX (630) 851-5040. PHONE (630) 851-4722. HTTP://WWW.CONWIN.COM PRODUCT D ATA SHEET CRYSTAL CONTROLLED OSCILLATORS ENVIRONMENTAL CHARACTERISTICS Temperature Cycle: Per MIL-STD-883, Method 1010, Condition B. -55°C to 125°C, 10 cycles, 10 minute dwell, 1minute transition. Gross Leak Test: Per MIL-STD-202, Method 112, Condition D. No Bubbles in flourinert (FC-43) at 125°C ±5°C for 20 seconds. SOLDERING Pin Solderabilit y: Per MIL-STD-883, Method 200. 8 hour steam age prior to 254°C ±5°C Solder pot dip, 95% Coverage. Resistance to Solder Heat: Per MIL-STD-202, Method 210, Condition C. Wave: Topside boardmount product, 260°C ±5°C for 20 seconds. MECHANICAL CHARACTERISTICS Vibration: Per MIL-STD-202, Method 204, Condition A . 10G’s peak, 10Hz to 500H z, 15 minute cycles 12 times each perpendicu lar axis. Shock: Per MIL-STD-202, Method 213, Condition F. 1500G’s, 0.5ms, half sine, 3 shocks per direction. Moisture Resistance: Per MIL-STD-202, Method 106. 95% RH @ 65° C, 10 cycles 10°C to 65°C. SOLDER PROFILE PACKAGE OUTLINE Temperature 260°C 260°C 220°C 180°C 150°C 120°C CONTROL VOLTAGE 0 120 S Max. Time 10 S 60 S Max. 360 Sec. Max. TEST DIAGRAM 3.0Vdc 3.3Vdc 14 8 1 7 Specifications subject to change without notice. DATA SHEET #: Cx106 PAGE 2 OF 2 REV: 00 DATE: 10/23/06 aCopyright 2001 Connor-Winfield all rights reserved.