TOCOS RAT30YGL15FA100K

TOCOS
®
RA30 Series
PA N E L C O N T R O L S
30mm Diameter, Single-Turn, Wirewound Industrial Panel Controls
RA30YME
RA30YD
RA30Y
Features
30mm diameter, single-turn industrial panel controls Wirewound element Linear or audio tapers
Single, tandem and triple units, single shaft; dual unit, dual shaft SPST or SPDT switch with 1A or 3A rating
Shaft lock and center tap models Metal shaft and bushing Temperature range of 10C or 30C, up to 100C
Panel mount only 6mm diameter shafts in slot, flat or round end styles Standard 15mm or 20mm shaft length
Specifications
Electrical
Environmental
Standard Resistance Range . . . . . . . . . . . B = 5Ω to 20kΩ
A,C = 100Ω to 5kΩ
Resistance Tolerance . . . . . . . . . . . . . . . . . 10% standard
(5%,2% or 1% special order )
End Resistance . . . . . . . . . . . . . . . . . . R ! 500Ω = 1Ω max.
R 0 500Ω = 0.2% max.
Resistance Taper . . . . B = linear; A = CW audio (logarithm);
C = CCW audio (logarithm)
Power Rating . . . B = 2.5 watts; A,C = 1.25 watts, at 40C
Insulation Resistance . . . . . . . 100MΩ minimum at 500VDC
Dielectric Strength . . . . . . . . . . . . . . . . . . 500VAC, 1 minute
Theoretical Resolution
Temperature Range . . . . . . . . . . . . . . Y = 10C to 100C
or X = 30C to 100C
Resistance ( Ω )
5
10
20
50
100
200
Resolution ( % )
1.62
0.81
0.67
0.45
0.44
0.32
Resistance ( Ω )
500
1,000
2,000
5,000
10,000
20,000
Resolution ( % )
0.23
0.19
0.15
0.14
0.12
0.10
Mechanical
Mechanical Travel . . . . . . . . . . . . . . . . . . . . . . . . . . 3005
Shaft Torque
Single Unit . . . . . 70.1 to 306 gf • cm (0.972 to 4.242 oz • in)
Tandem Unit . . . . . . 70 to 701 gf • cm (0.97 to 9.718 oz • in)
Other Units . . . . . . . 70 to 450 gf • cm (0.97 to 6.238 oz • in)
Stop Strength . . . . . . . . . . . . 10.2 kgf • cm (141.4 oz • in) max.
Mounting Nut Torque . . . . . . 15 kgf • cm (207.94 oz • in) max.
Solderability . . . . . . . . . . . . . . . . . . . . . . . 235C, 3 seconds
Marking . . . . . . . . . . Taper, resistance, resistance tolerance,
terminal identification, date code
Temperature Characteristics . . . . . . . . . . .85C, 5 hours
without load
∆T/R )5%
Low Temperature Exposure . . . . . . . 10C ( Y ),30C ( X )
1 hour without load
∆T/R )3%
Load Life . . . . . . . . . . . . 40C, 1,000 hours with rated load
∆T/R )3%
Moisture and Load Life . . . . . . . . . . . .40C, 90-95%RH,
500 hours with 1/10 rated load
∆T/R )5%
Vibration . . . . . . . . . . . . . . . . . . .10-55Hz, 1.5mm amplitude,
2 directions, 2 hours each
∆T/R )1%
Soldering Heat Resistance . . . . . . . . . 350C, 3.5 seconds;
∆T/R )2%
Rotational Life . . . . 15,000 cycles (500 cycles for shaft lock
models only) with 1/2 rated load
∆T/R )3%
Standard Rotary Switches
Switch Rating . . . . . . . . . . 110VAC, 1A or 3A, SPDT or SPST
Contact Resistance . . . . . . . . . . . . . . . . . . . . . . 0.05Ω max.
Operating Torque . . . . . . . . 1,500 gf • cm (20.79 oz • in) max.
Operating Life . . . . . . . . . . . . . . . 10,000 cycles without load
R = Total Resistance Value; ∆T/R = Total Resistance Change
TOCOS AMERICA, INC.
1177 East Tower Road, Schaumburg, IL 60173
Tel: 847-884-6664
Fax: 847-884-6665
63
E-mail: [email protected]
www.tocos.com
RA30 Series
Dimensions
RA30Y & RA30X
Unit: mm
Panel Mount, Single Unit, Single Shaft
Right Angle Ear-Lug Terminals
Recommended
Panel Mounting Holes
RA30YL & RA30XL
Panel Mount, Single Unit, Single Shaft with Shaft Lock
Right Angle Ear-Lug Terminals
Recommended
Panel Mounting Holes
RA30YME, RA30YMF, RA30YSE, RA30YSF
RA30XME, RA30XMF, RA30XSE, RA30XSF
Panel Mount, Single Unit with Switch, Single Shaft
Right Angle Ear-Lug Terminals, Rear Exit Lug Terminals for 1A or 3A SPST or SPDT Switch
Recommended
Panel Mounting Holes
TOCOS AMERICA, INC.
64
1177 East Tower Road, Schaumburg, IL 60173
Tel: 847-884-6664
Fax: 847-884-6665
E-mail: [email protected]
www.tocos.com
RA30 Series
Dimensions
RAT30Y
Unit: mm
Panel Mount, Single Unit with Center Tap, Single Shaft
Right Angle Ear-Lug Terminals, Tap Lug Terminal 105 from Terminal #1
Recommended
Panel Mounting Holes
RA30YG
Panel Mount, Ganged Tandem Unit, Single Shaft
Right Angle Ear-Lug Terminals on Each Unit
Recommended
Panel Mounting Holes
RA30YGL
Panel Mount, Ganged Tandem Unit, Single Shaft with Shaft Lock
Right Angle Ear-Lug Terminals on Each Unit
Recommended
Panel Mounting Holes
TOCOS AMERICA, INC.
1177 East Tower Road, Schaumburg, IL 60173
Tel: 847-884-6664
Fax: 847-884-6665
65
E-mail: [email protected]
www.tocos.com
RA30 Series
Dimensions
RAT30YG
Unit: mm
Panel Mount, Ganged Tandem Unit with Center Tap, Single Shaft
Right Angle Ear-Lug Terminals, Tap Lug Terminal 105 from Terminal #1
Recommended
Panel Mounting Holes
RA30YT
Panel Mount, Triple Unit, Single Shaft
Right Angle Ear-Lug Terminals on Each Unit
Recommended
Panel Mounting Holes
RA30YD
Panel Mount, Dual Unit, Dual Concentric Shaft
Right Angle Ear-Lug Terminals on Each Unit
Recommended
Panel Mounting Holes
TOCOS AMERICA, INC.
66
1177 East Tower Road, Schaumburg, IL 60173
Tel: 847-884-6664
Fax: 847-884-6665
E-mail: [email protected]
www.tocos.com
RA30 Series
Part Numbering System
RA T 30 Y L ME 20 S
B 102 K
NOTE: FMS = From Mounting Surface
Resistance Tolerance: K = 10% (standard).
J = 5%; G = 2%; or F = 1% (special order ).
Resistance Code: Expressed in ohms. A three digit code where the first
two digits are significant figures, and the third digit indicates the number
of zeros that follow these figures. R indicates decimal point for resistance
less than 10Ω (i.e., 5R0 = 5Ω; 100 = 10Ω; 101 = 100Ω; 102 = 1,000Ω;
103 = 10,000Ω ). See table for standard resistance values.
For Single Unit: Specify taper and resistance code as shown.
For Ganged Tandem Unit or Dual Unit:
Specify a taper code and resistance code for each unit starting with
the front unit followed by the rear unit. If both units have the same taper
and resistance codes, add “X2” suffix per example below.
Examples: B102A503 or if both units are the same: B102X2
For Triple Unit:
Specify a taper code and resistance code for each unit starting with
the front unit followed by the middle and rear units. If all units have the
same taper and resistance codes, add “X3” suffix per example below.
Examples: B102A503B104 or if all units are the same: B102X3
Resistance Taper: B = Linear; A = CW Audio (logarithm);
C = CCW Audio (logarithm).
Shaft End Style: S = Slotted; F = Flatted; R = Round.
For Single Shaft:
Specify the shaft length (FMS) and shaft end style as shown.
For Dual Concentric Shaft:
Specify the shaft length (FMS) and shaft end style for the inner shaft
followed by the shaft length (FMS) and shaft end style for the outer
shaft. Use a dash (-) to separate the code groups for the inner and
outer shaft specifications. Example: 30R-20R
Standard Shaft Length: 15 = 15 mm FMS; 20 = 20mm FMS.
Up to 50mm shaft length available (special order ).
Switch Type: ME = SPDT, 110VAC, 1A, Rear Exit Lug Terminals.
MF = SPDT, 110VAC, 3A, Rear Exit Lug Terminals.
SE = SPST, 110VAC, 1A, Rear Exit Lug Terminals.
SF = SPST, 110VAC, 3A, Rear Exit Lug Terminals.
Blank = No Switch.
Style: Blank = Panel Mount, Single Unit, Single Shaft, Right Angle Ear-Lug
Terminals.
L = Panel Mount, Single Unit, Single Shaft with Shaft Lock,
Right Angle Ear-Lug Terminals.
G = Panel Mount, Ganged Tandem Unit, Single Shaft, Right Angle
Ear-Lug Terminals on Each Unit.
GL = Panel Mount, Ganged Tandem Unit, Single Shaft with Shaft
Lock, Right Angle Ear-Lug Terminals on Each Unit.
T = Panel Mount, Triple Unit, Single Shaft, Right Angle Ear-Lug
Terminals on Each Unit.
D = Panel Mount, Dual Unit, Dual Concentric Shaft, Right Angle
Ear-Lug Terminals on Each Unit.
Operating Temperature Range: Y = 10C to 100C.
X = 30C to 100C.
Size: 30 = 30mm Diameter.
Center Tap: T = With Tap; Blank = Without Tap.
TOCOS Series Name: RA = Wirewound Element.
Standard Resistance Values and Part Numbering Codes
Standard Nominal Total Resistance Values and Part Numbering Codes
Resistance ( Ω )
Code
Resistance ( Ω )
Code
Resistance ( Ω )
Code
Resistance ( Ω )
Code
05
10
20
50
5R0
100
200
500
100
200
500
101
201
501
1,000
2,000
5,000
102
202
502
10,000
20,000
103
203
Refer to Shaft End Styles Specifications and Hardware Specifications for details and availability.
For additional information, refer to Guidelines and Precautions for Using Panel Controls.
TOCOS AMERICA, INC.
1177 East Tower Road, Schaumburg, IL 60173
Tel: 847-884-6664
Fax: 847-884-6665
67
E-mail: [email protected]
www.tocos.com