UTC-IC LM339L-S14-T

UNISONIC TECHNOLOGIES CO., LTD
LM339
LINEAR INTEGRATED CIRCUIT
QUAD DIFFERENTIAL
COMPARATOR
SOP-14
DESCRIPTION
The UTC LM339 consists of four independent voltage
comparators, designed specifically to operate from a single
power supply over a wide voltage range.
TSSOP-14
FEATURES
*Signal or dual supply operation.
*Wide operating supply range (Vcc=2V~36V).
*Input common-mode voltage includes ground.
*Low supply current drain IF=0.8mA (Typical).
*Open collector outputs for wired and connection.
*Low input bias current IBIAS=25nA (Typical).
*Low output saturation voltage.
*Output compatible with TTL, DTL, and CMOS logic system.
DIP-14
*Pb-free plating product number: LM339L
ORDERING INFORMATION
Order Number
Normal
Lead free
LM339–S14-R
LM339L –S14-R
LM339–S14-T
LM339L –S14-T
LM339–P14-R
LM339L –P14-R
LM339–P14-T
LM339L –P14-T
LM339–D14-T
LM339L –D14-T
www.unisonic.com.tw
Copyright © 2005 Unisonic Technologies Co., LTD
Package
Packing
SOP-14 Tape & Reel
SOP-14
Tube
TSSOP-14 Tape & Reel
TSSOP-14
Tube
DIP-14
Tube
1
QW-R104-001.D
LM339
LINEAR INTEGRATED CIRCUIT
PIN CONFIGURATION
OUT 2
1
14
OUT 3
OUT 1
2
13
OUT 4
Vcc
3
12
GND
IN 1(-)
4
11
IN 4(+)
IN 1(+)
5
10
IN 4(-)
IN 2(-)
6
9
IN 3(+)
IN 2(+)
7
8
IN 3(-)
BLOCK DIAGRAM
Vcc
Only one section
T9
T11
D2
IN (-)
T10
D3
D1
R2
D4
T2
T3
T4
T1
OUT
T8
IN (+)
T12
D5
T7
T5
T6
UNISONIC TECHNOLOGIES CO., LTD
www.unisonic.com.tw
R1
D6
GND
2
QW-R104-001.D
LM339
LINEAR INTEGRATED CIRCUIT
ABSOLUTE MAXIMUM RATINGS (Ta=25°C)
PARAMETER
SYMBOL
RATINGS
UNIT
Supply Voltage
Vcc
+- 18 or 36
V
Differential input Voltage
VI(DIFF)
36
V
Input Voltage
VIN
-0.3~36
V
Power Dissipation
PD
570
mW
Junction Temperature
TJ
125
°C
Operating Temperature
TOPR
0 ~ +70
°C
Storage Temperature
TSTG
-40 ~ 150
°C
Note 1. Absolute maximum ratings are those values beyond which the device could be permanently damaged.
Absolute maximum ratings are stress ratings only and functional device operation is not implied.
2. The device is guaranteed to meet performance specification within 0℃ ~ 70℃ operating temperature range
and assured by design from –20℃ ~ +85℃.
ELECTRICAL CHARACTERISTICS
(Vcc=5.0V, Ta=25°C, All voltage referenced to GND unless otherwise specified)
PARAMETER
SYMBOL
TEST CONDITIONS
VCM=0 ~ Vcc-1.5
Input Offset Voltage
VI(OFF)
VOUT(p)=1.4V, Rs=0
Input Offset Current
II(OFF)
Input Bias Current
IBIAS
Input Common-Mode Voltage
VIN(R)
Range
RL=∞
Supply Current
Icc
Large Signal Voltage Gain
GV
Vcc=15V, RL>15kΩ
VIN=TTL logic wing
Large Signal Response Time
tres
VREF=1.4V, VRL=5V, RL=5.1kΩ
Response Time
tres
VRL=5V, RL=5.1kΩ
Output Sink Current
ISINK
VIN (-)>1V, VIN (+)=0V, VOUT(p)<1.5V
Output Saturation Voltage
VSAT
VIN (-)>1V, VIN (+)=0V, ISINK=4mA
VIN (+)=1V,VIN (-)=0
Output Leakage Current
ILEAK VOUT(p)= 5V
VOUT (p)=30V
Differential Input Voltage
VIN(DIFF)
UNISONIC TECHNOLOGIES CO., LTD
www.unisonic.com.tw
MIN
TYP.
MAX
UNIT
+-1.5
+-5.0
mV
+-2.3
57
+-50
250
nA
nA
Vcc-1.5
V
2.0
mA
V/mV
0
50
6
1.1
200
350
ns
1400
18
140
400
ns
mA
mV
1.0
36
nA
µA
V
0.1
3
QW-R104-001.D
LM339
LINEAR INTEGRATED CIRCUIT
TYPICAL
CHARACTERISTICS
Fig.1 Supply Current
Fig.2 Input Current
2.2
110
Ta=-40℃
1.8
Ta=-25℃
1.6
1.4
Ta=25℃
1.2
1.0
Ta=70℃
0.8
Ta=-40℃
100
90
Input Current (mA)
Supply Current (mA)
2.0
Ta=-25℃
80
70
Ta=25℃
60
50
Ta=70℃
40
0.6
30
RL=∞
0.4
Vcm=0VDC
Rcm=1GΩ
20
0.2
10
0
5
10
15
20
25
30
35
40
0
5
10
Supply Voltage (V)
25
30
35
40
Input Voltage
(mV)
1
1
Ta=25℃
0
-100
-1
10
Output Voltage
(V)
Saturation Voltage(V)
20
Fig.4 Reponse Time For Various Input
Overdrive Negative Transition
Fig.3 Output Saturation Voltage
10
15
Supply Current (V)
Ta=85℃
-2
10
Ta=-40℃
Ta=25℃
-3
10
Input Overdrive
6.0
4.0
50mV
2.0
20mV
5.0mV
0
-2
10
-1
10
1
10
1
10
2
0
0.4
0.8
1.2
1.6
Time ( µs)
Output Sink Current (mA)
Output Voltage (V)
Input Voltage (mV)
Fig.5 Reponse Time For Various Input
Overdrive Positive Transition
Ta=25℃
100
0
6.0
4.0
Input Overdrive
50mV
20mV 5.0mV
2.0
0
0
0.4
0.8
1.2
1.6
Time ( µs)
UNISONIC TECHNOLOGIES CO., LTD
www.unisonic.com.tw
4
QW-R104-001.D
LM339
LINEAR INTEGRATED CIRCUIT
TYPICAL
CHARACTERISTICS(cont.)
Fig.7 Voltage Follower Pulse Response
(Small Signal)
Fig.6
3
RL=2kΩ
Vcc=15V
2
Output Voltgae (V)
Input Voltage (V)
450
1
Output Voltage (V)
0
3
400
350
2
300
1
0
0
20
30
Time ( µs)
10
275
40
50
0
1
3
2
4
5
6
7
8
9
Time ( µs)
Fig.9 Output Characteristics
Current Sourcing
Fig.8 Large Signal Frequency Response
8
Output Swing (Vp-p)
15
100k
Output Refference Vcc (V)
7
+15V
1k
Vi
2k
+7V
10
5
Ta=25℃
6
Vcc
Vcc/2
5
Vo
Io
4
3
2
0
1
10
3
10
4
10
5
10
6
-3
10
-2
-1
10
10
1
10
10
2
Output Source Current (mA)
Frequency (Hz)
Fig.10 Output Characteristics Current Sinking
Fig.11 Current Limiting
10
Output Current (mA)
Output Voltage (V)
60
1
40
Vcc=+5V
Vcc=+15V
-1
Vcc
10
Vcc/2
Vcc=+30V
20
Vo
Io
-3
10
-2
10
-1
10
1
10
10
2
Output Sink Current (mA)
UNISONIC TECHNOLOGIES CO., LTD
www.unisonic.com.tw
0
-50
-25
0
25
50
75
100
Temperature (℃)
5
QW-R104-001.D
LM339
LINEAR INTEGRATED CIRCUIT
UTC assumes no responsibility for equipment failures that result from using products at values that
exceed, even momentarily, rated values (such as maximum ratings, operating condition ranges, or
other parameters) listed in products specifications of any and all UTC products described or contained
herein. UTC products are not designed for use in life support appliances, devices or systems where
malfunction of these products can be reasonably expected to result in personal injury. Reproduction in
whole or in part is prohibited without the prior written consent of the copyright owner. The information
presented in this document does not form part of any quotation or contract, is believed to be accurate
and reliable and may be changed without notice.
UNISONIC TECHNOLOGIES CO., LTD
www.unisonic.com.tw
6
QW-R104-001.D