Catalog 1308242 Issued 3-03 (PDF Revised 8-06) Sensitive, Low Profile, Hi-Current Relay Designed to Meet International Standards P&B T75 series 10 Amp, PC Board Miniature Relay File E29244 File No. 3919 Users should thoroughly review the technical data before selecting a product part number. It is recommended that user also seek out the pertinent approvals files of the agencies/ laboratories and review them to ensure the product meets the requirements for a given application. Features Initial Dielectric Strength • High sensitivity – nominal coil power requirement is as low as 212mW. • Low profile, .591 in. (15mm) tall case uses only .465 in2 (3cm2) of area on the printed circuit board, permitting high density circuit design. • Power switching capability – contacts rated 10 amps in 1 Form A (SPST-NO) or 1 Form C (SPDT) arrangements. • Designed to meet UL, CSA, VDE, SEMKO and SEV requirements. • Designed to meet VDE 8mm spacing, 4kV dielectric, coil to contacts. • Designed to meet 3 mm creepage between contacts. • Conforms to: VDE 0110 – Insulation Group C (250V) VDE 435 Part 201 – High current applications VDE 0804 – Telecommunications equipment VDE 0631 – Temperature controllers and limiters VDE 0700 – Household appliances VDE 0805/5.90 – Office machines • Wash tight (washable). • Well suited for a broad range of applications e.g. HVAC, appliances, security and industrial control. Between Open Contacts: 1,000V rms. Between Contacts and Coil: 4,000V rms, 8mm. Coil Data Voltage: 3 to 60VDC. Maximum Power @ 23°C: 1W. Nominal Power @ 23°C: 230mW, typ. Temperature Rise: 85C° per Watt. Duty Cycle: Continuous. Coil Data Nominal Voltage Contact Ratings @ 25° C with relay properly vented. Remove vent nib after soldering and cleaning. Arrangements: 1 Form A (SPST-NO) and 1 Form C (SPDT). Material: Silver-cadmium oxide. Expected Mechanical Life: 10 million operations. Expected Electrical Life: 100,000 operations at 8 amps, 240VAC. 50,000 operations at 14 amps NO / 5 amps NC, 120VAC Res. 30,000 operations at 7.2 FLA, 45 LRA, 120VAC. 10,000 operations at 5 FLA, 30 LRA, 240VAC. 30,000 operations at B300 pilot duty (360VA, 240VAC; 470VA, 120VAC). Contact Ratings (See Figure 1): Maximum Switched Voltage: 380VAC. Maximum Switched Current: 14/5 (N.O./N.C.) amps, AC resistive; 8 amps DC (see Fig. 1) Maximum Switched Power: 200W, DC; 2,000VA, AC. Minimum Required Contact Load: 12V, 100mA. VDE Contact Ratings: 8 amps, 250VAC. UL Contact Ratings: 10 amps, 240VAC; 8 amps 24VDC; 1/3 HP, 120VAC; 1/2 HP, 240VAC. Figure 1 - DC Switching Load Limit Curve DC Coils 3 5 6 9 12 18 24 36 48 60 DC Resistance in Ohms ±10% 40 118 165 365 650 1,455 2,270 5,460 8,790 15,265 Must Operate Voltage 2.1 3.4 4.1 6.1 8.2 12.3 16.3 24.5 32.6 40.8 Nominal Coil Current (mA) 75.0 42.4 36.4 24.7 18.5 12.4 10.6 6.4 5.5 3.9 Operate Data @ 23°C Must Operate Voltage: 70% of nom. voltage or less. Must Release Voltage: 10% of nom. voltage or more. Operate Time (Excluding Bounce): 6 ms, typ., at nom. voltage. Release Time (Excluding Bounce): 2.5 ms, typ., at nom. voltage. Maximum Switching Rate: 20 operations/second. Maximum Continuous Operating Voltage: 225% of nom. voltage. 300 ENVIRONMENTAL DATA Switching Voltage (VDC) 200 Temperature Range 100 Storage: -40°C to +130°C. Operating: -40°C to +85°C. 50 40 30 25 20 W 50 W 10 0 W 20 Mechanical Data 0W 10 .1 1 10 Switching Current (Amps DC) Dimensions are shown for 414 reference purposes only. Dimensions are in inches over (millimeters) unless otherwise specified. 100 Termination: Printed circuit terminals. Enclosures: Wash tight (washable) case. Weight: 0.39 oz. (11.0g) approximately. Specifications and availability subject to change. www.tycoelectronics.com Technical support: Refer to inside back cover. Catalog 1308242 Issued 3-03 (PDF Revised 8-06) P&B Ordering Information Typical Part Number B T75 S 5 D 1 1 2 -12 1. Basic Series: T75 = Low profile, printed circuit board relay. 2. Enclosure: S = Wash tight (washable). 3. Contact Arrangement: 1 = 1 Form A (SPST-NO) 5 = 1 Form C (SPDT) 4. Coil Input: D = DC voltage 5. Coil Configuration: 1 = Single coil, non-latching (monostable) 6. Mounting and Terminals: 1 = Printed circuit terminals 7. Contact Material: 2 = Silver-cadmium oxide (AgCdO) 8. Coil Voltage: 03 = 3VDC 05 = 5VDC 06 = 6VDC 09 = 9VDC 12 = 12VDC 18 = 18VDC 24 = 24VDC 36 = 36VDC 48 = 48VDC 60 = 60VDC NOTE: All part numbers are RoHS compliant. Our authorized distributors are more likely to maintain the following items in stock for immediate delivery. T75S5D112-05 T75S5D112-12 T75S5D112-24 Outline Dimensions FORM A 1.126 MAX. (28.6) Wiring Diagram (Bottom View) FORM C 1.181 MAX. (30) .591 (15) .150 (3.8) .394 (10) * *ON SINGLE THROW MODELS, ONLY NECESSARY TERMINALS ARE PRESENT. CONTACT TERMINALS: .023 x .040 (.58 x 1.02) REF. COIL TERMINALS: .024 (.61) DIA. REF. PC Board Layouts (Bottom Views) 1 Form C 1 Form A .051 DIA. TYP. (1.3) .051 DIA. TYP. (1.3) .300 (7.6) .126 (3.2) .126 (3.2) Dimensions are shown for reference purposes only. .110 (2.8) .300 (7.6) .197 (5) .748 (19) .110 (2.8) .748 (19) Dimensions are in inches over (millimeters) unless otherwise specified. Specifications and availability subject to change. www.tycoelectronics.com Technical support: 415 Refer to inside back cover.