STEVAL-CCA037V1 Amplifier based on the TS4990IQT Data brief Features ■ Operating from VCC = 2.2 V to 5.5 V ■ Active low standby mode ■ 1.2 W output power @ VCC = 5 V, THD = 1%, F = 1 kHz, with 8 Ω load ■ Ultra low power consumption in standby mode (10 nA) ■ 62dB PSRR @ 217 Hz in grounded mode (Av = 2 V/V) ■ Near zero pop and click ■ Ultra low distortion (0.1%) ■ Module gain set at 2 V/V ■ Thermal and short-circuit protection ■ RoHS compliant Description The STEVAL-CCA037V1 demonstration board is designed to evaluate the TS4990IQT low power audio amplifier. The micro package DFN8 (dual flat non-leaded 8 pins) allows space saving and good thermal dissipation. The BTL gain is set at 2 V/V and can be adapted if necessary with a modification of two (R1 or R2) resistor values. It is possible to modify the input configuration from single ended to differential of the STEVALCCA037V1 demonstration board. More information regarding component calculations is available in the TS4990 datasheet. April 2012 Doc ID 023151 Rev 1 For further information contact your local STMicroelectronics sales office. 1/4 www.st.com 4 2/4 Doc ID 023151 Rev 1 'ND .EG)NPUT 'ND 0OS)NPUT 'ND *0 *0 #. #. *0 6CC NF6 # .# # K 2 .# 2 2 UF6 # # 2 6IN 6IN "YPASS K .# 34 6OUT 6CC 'ND 3TANDBY 6OUT 5 # UF6 # NF6 6CC 'ND 6CC *0 6OUT 6OUT *0 #. #. Figure 1. 1 *UMP* 6CC #. Schematic diagram STEVAL-CCA037V1 Schematic diagram Schematic diagram !-V STEVAL-CCA037V1 2 Revision history Revision history Table 1. Document revision history Date Revision 27-Apr-2012 1 Changes Initial release. Doc ID 023151 Rev 1 3/4 STEVAL-CCA037V1 Please Read Carefully: Information in this document is provided solely in connection with ST products. STMicroelectronics NV and its subsidiaries (“ST”) reserve the right to make changes, corrections, modifications or improvements, to this document, and the products and services described herein at any time, without notice. All ST products are sold pursuant to ST’s terms and conditions of sale. Purchasers are solely responsible for the choice, selection and use of the ST products and services described herein, and ST assumes no liability whatsoever relating to the choice, selection or use of the ST products and services described herein. No license, express or implied, by estoppel or otherwise, to any intellectual property rights is granted under this document. If any part of this document refers to any third party products or services it shall not be deemed a license grant by ST for the use of such third party products or services, or any intellectual property contained therein or considered as a warranty covering the use in any manner whatsoever of such third party products or services or any intellectual property contained therein. UNLESS OTHERWISE SET FORTH IN ST’S TERMS AND CONDITIONS OF SALE ST DISCLAIMS ANY EXPRESS OR IMPLIED WARRANTY WITH RESPECT TO THE USE AND/OR SALE OF ST PRODUCTS INCLUDING WITHOUT LIMITATION IMPLIED WARRANTIES OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE (AND THEIR EQUIVALENTS UNDER THE LAWS OF ANY JURISDICTION), OR INFRINGEMENT OF ANY PATENT, COPYRIGHT OR OTHER INTELLECTUAL PROPERTY RIGHT. UNLESS EXPRESSLY APPROVED IN WRITING BY TWO AUTHORIZED ST REPRESENTATIVES, ST PRODUCTS ARE NOT RECOMMENDED, AUTHORIZED OR WARRANTED FOR USE IN MILITARY, AIR CRAFT, SPACE, LIFE SAVING, OR LIFE SUSTAINING APPLICATIONS, NOR IN PRODUCTS OR SYSTEMS WHERE FAILURE OR MALFUNCTION MAY RESULT IN PERSONAL INJURY, DEATH, OR SEVERE PROPERTY OR ENVIRONMENTAL DAMAGE. ST PRODUCTS WHICH ARE NOT SPECIFIED AS "AUTOMOTIVE GRADE" MAY ONLY BE USED IN AUTOMOTIVE APPLICATIONS AT USER’S OWN RISK. Resale of ST products with provisions different from the statements and/or technical features set forth in this document shall immediately void any warranty granted by ST for the ST product or service described herein and shall not create or extend in any manner whatsoever, any liability of ST. ST and the ST logo are trademarks or registered trademarks of ST in various countries. Information in this document supersedes and replaces all information previously supplied. The ST logo is a registered trademark of STMicroelectronics. All other names are the property of their respective owners. © 2012 STMicroelectronics - All rights reserved STMicroelectronics group of companies Australia - Belgium - Brazil - Canada - China - Czech Republic - Finland - France - Germany - Hong Kong - India - Israel - Italy - Japan Malaysia - Malta - Morocco - Philippines - Singapore - Spain - Sweden - Switzerland - United Kingdom - United States of America www.st.com 4/4 Doc ID 023151 Rev 1