UNISONIC TECHNOLOGIES CO., LTD DTA144T PNP SILICON TRANSISITOR PNP DIGITAL TRANSISTOR (BUILT-IN RESISTOR) FEATURES * Built-in bias resistors that implies easy ON/OFF applications. * The bias resistors are thin-film resistors with complete isolation to allow positive input. EQUIVALENT CIRCUIT ORDERING INFORMATION Ordering Number Lead Free Halogen Free DTA144TL-AE3-R DTA144TG-AE3-R Note: Pin Assignment: B: Base C: Collector E: Emitter Package SOT-23 Pin Assignment 1 2 3 E B C Packing Tape Reel MARKING www.unisonic.com.tw Copyright © 2011 Unisonic Technologies Co., Ltd 1 of 3 QW-R206-065.C DTA144T PNP SILICON TRANSISITOR ABSOLUTE MAXIMUM RATINGS (TA=25℃) PARAMETER SYMBOL RATINGS UNIT Collector-Base Voltage VCBO -50 V Collector-Emitter Voltage VCEO -50 V Emitter-Base Voltage VEBO -5 V Collector Current IC -100 mA Collector Power Dissipation Pc 200 mW Junction Temperature TJ 150 °С Storage Temperature TSTG -55~+150 °С Note: Absolute maximum ratings are those values beyond which the device could be permanently damaged. Absolute maximum ratings are stress ratings only and functional device operation is not implied. ELECTRICAL CHARACTERISTICS (TA =25°C, unless otherwise specified) PARAMETER Collector-Base Breakdown Voltage Collector-Emitter Breakdown Voltage Emitter-Base Breakdown Voltage Collector Cutoff Current Emitter Cutoff Current Collector-Emitter Saturation Voltage DC Current Transfer Ratio Transition Frequency (Note) Input Resistance SYMBOL BVCBO BVCEO BVEBO ICBO IEBO VCE(SAT) hFE fT R1 TEST CONDITIONS IC=-50μA IC=-1mA IE=-50μA VCB=-50V VEB=-4V IC =-5mA, IB= -0.5mA VCE =-5V, IC= -1mA VCE=-10V, IE=5mA, f=100MHz MIN -50 -50 -5 TYP 100 250 250 47 32.9 MAX UNIT V V V -0.5 μA -0.5 μA -0.3 V 600 MHz 61.1 kΩ Note: Transition frequency of the device UNISONIC TECHNOLOGIES CO., LTD www.unisonic.com.tw 2 of 3 QW-R206-065.C DTA144T PNP SILICON TRANSISITOR TYPICAL CHARACTERISTICS UTC assumes no responsibility for equipment failures that result from using products at values that exceed, even momentarily, rated values (such as maximum ratings, operating condition ranges, or other parameters) listed in products specifications of any and all UTC products described or contained herein. UTC products are not designed for use in life support appliances, devices or systems where malfunction of these products can be reasonably expected to result in personal injury. Reproduction in whole or in part is prohibited without the prior written consent of the copyright owner. The information presented in this document does not form part of any quotation or contract, is believed to be accurate and reliable and may be changed without notice. UNISONIC TECHNOLOGIES CO., LTD www.unisonic.com.tw 3 of 3 QW-R206-065.C