UNISONIC TECHNOLOGIES CO., LTD U74HC4060 CMOS IC 14-STAGE ASYNCHRONOUS BINARY COUNTERS AND OSCILLATORS SOP-16 DESCRIPTION The U74HC4060 are high-speed Si-gate CMOS device. The U74HC4060 devices consist of an oscillator section and 14 ripple-carry binary counter stages. The oscillator configuration allows design of erther RC or crystal oscillator circuits with three oscillator terminals (CLKI, CLKO, CLKO) , ten buffered outputs (QD to QJ and QL to QM) and an overriding asynchronous master reset (CLR) . The oscillator may be replaced by an esternal clock signal at input CLKI. In this case keep the other oscillator pins (CLKO, CLKO) floating. The counter advances on the negative-going transition of CLKI. A high level at the clear (CLR) input disables the oscillator and resets the counter to zero (all Q output low). TSSOP-16 FEATURES * Operate from 2.0V to 6.0V * Low Input Current:1.0uA * Outputs Can Drive Up To 10 LSTTL Loads * Low Power Consumption ,80uA Max ICC * 4mA Output Drive at 5V * Typical tPD=14ns * Allow Design of Either RC or Crystal Oscillator Circuits ORDERING INFORMATION Ordering Number Lead Free Halogen Free U74HC4060L-S16-R U74HC4060G-S16-R U74HC4060L-S16-T U74HC4060G-S16-T U74HC4060L-P16-R U74HC4060G-P16-R U74HC4060L-P16-T U74HC4060G-P16-T www.unisonic.com.tw Copyright © 2012 Unisonic Technologies Co., Ltd Package Packing SOP-16 SOP-16 TSSOP-16 TSSOP-16 Tape Reel Tube Tape Reel Tube 1 of 6 QW-R502-831.A U74HC4060 PIN CONFIGURATION QL 1 16 VCC QM 2 15 QJ QN 3 14 QH QF 4 13 QI QE 5 12 CLR QG 6 11 CLKI QD 7 10 CLKO 8 CMOS IC 9 CLKO GND FUNCTION TABLE INPUTS FUNCTION CLK CLR ↑ L No change ↓ L Advance to next stage X H All outputs L Note: H: HIGH voltage level L: LOW voltage level X: Don’t care.High impedance OFF-state ↑: Low-to-High CP transition ↓: High-to-Low CP transition LOGIC SYMBOL 10 CLKO 11 12 CLKI CLR UNISONIC TECHNOLOGIES CO., LTD www.unisonic.com.tw 9 CLKO QD QE QF QG QH QI QJ QL QM QN 7 5 4 6 14 13 15 1 2 3 2 of 6 QW-R502-831.A U74HC4060 CMOS IC LOGIC DIAGRAM CLKO CLKO DFFA CLKI DFFD CP CP CLR Q DFFM DFFL CP Q CLR DFFG CP CP CLR Q Q CLR DFFN CP CLR Q CLR Q TIMING DIAGRAM 1 2 4 8 16 32 64 128 256 512 1024 2048 4096 8192 16384 CLKI CLR QD QE QF QG QH QI QJ QL QM QN UNISONIC TECHNOLOGIES CO., LTD www.unisonic.com.tw 3 of 6 QW-R502-831.A U74HC4060 CMOS IC ABSOLUTE MAXIMUM RATING PARAMETER Supply Voltage Input Clamp Current (VI<0 or VI>VCC) SYMBOL VCC IIK RATINGS -0.5 ~ 7.0 ±20 UNIT V mA IOK ±20 mA Output Clamp Current (VO<0 or VO>VCC) VCC or GND Current ICC ±50 mA Continuous Output Current(VO=0 to VCC) IOUT ±25 mA Storage Temperature TSTG -65 ~ + 150 °C Note: Absolute maximum ratings are those values beyond which the device could be permanently damaged. Absolute maximum ratings are stress ratings only and functional device operation is not implied. RECOMMENDED OPERATING CONDITIONS PARAMETER Supply Voltage Input Voltage Output Voltage Operating Temperature Input Rise or Fall Times ELECTRICAL SYMBOL VCC VIN VOUT TA tR, tF TEST CONDITIONS Operating MIN 2.0 0 0 -40 VCC=2.0V VCC=4.5V VCC=6.0V TYP MAX UNIT 6.0 V VCC V VCC V +85 °C 1000 500 ns 400 CHARACTERISTICS (TA =25°C , unless otherwise specified) PARAMETER SYMBOL High-Level Input Voltage VIH Low-Lever Input Voltage VIL High-Level Output Voltage VOH Low-Level Output Voltage VOL TEST CONDITIONS VCC=2V VCC=4.5V VCC=6V VCC=2V VCC=4.5V VCC=6V VCC=2V, IOH=-20μA VCC=4.5V, IOH=-20μA VCC=6V, IOH=-20μA VCC=4.5V, IOH=-4.0mA VCC=6V, IOH=-5.2mA VCC=2V, IOL=20μA VCC=4.5V, IOL=20μA VCC=6V, IOL=20μA VCC=4.5V, IOH=4mA VCC=6V, IOL=5.2mA Input Leakage Current Quiescent Supply Current II(LEAK) Icc VCC=6V, VIN= VCC or GND VCC=6V, VIN=VCC or GND, IOUT=0 UNISONIC TECHNOLOGIES CO., LTD www.unisonic.com.tw MIN TYP MAX UNIT 1.5 V 3.15 V 4.2 V 0.5 V 1.35 V 1.8 V 1.9 1.998 V 4.4 4.499 V 5.9 5.999 V 3.98 4.3 V 5.48 5.8 V 0.002 0.1 V 0.001 0.1 V 0.001 0.1 V 0.17 0.26 V 0.15 0.26 V ±100 8 nA μA 4 of 6 QW-R502-831.A U74HC4060 CMOS IC TIMING REQUIREMENTS (over recommended operating free-air temperature range, unless otherwise noted) TEST CONDITIONS PARAMETER VCC=2V FCOLCK Clock Frequency VCC=4.5V VCC=6V VCC=2V CLKI high or low VCC=4.5V VCC=6V tW Pulse Duration VCC=2v CLR high VCC=4.5V VCC=6V VCC=2V tsu, Setup time, CLR Inactive Before CLKI High To Low VCC=4.5V VCC=6V 115 23 20 115 23 20 200 40 34 TYP MAX UNIT 4.3 22 MHz 25 ns ns SWITCHING CHARACTERISTICS (over recommended operating free-air temperature range, CL=50pF, unless otherwise noted) PARAMETER SYMBOL TEST CONDITIONS VCC=2V Propagation delay from CLKI to QD tPD VCC=4.5V VCC=6V VCC=2V Propagation delay from CLKI to Any Q tPHL VCC=4.5V VCC=6V VCC=2V Output rise or fall time tt VCC=4.5V VCC=6V VCC=2V Maxinum Clock Pulse Frequency fmax VCC=4.5V VCC=6V MIN MIN TYP MAX UNIT 240 490 58 98 ns 42 83 66 140 18 28 ns 24 24 28 75 8 15 ns 6 13 5.5 10 28 45 MHz 33 53 OPERATING CHARACTERISTICS PARAMETER Power Dissipation Capacitance SYMBOL CPD UNISONIC TECHNOLOGIES CO., LTD www.unisonic.com.tw TEST CONDITIONS No load MIN TYP MAX UNIT 88 pF 5 of 6 QW-R502-831.A U74HC4060 CMOS IC TEST CIRCUIT AND WAVEFORMS High-Level Pulse Vcc 50% 50% 0V tw Low-Level Pulse Vcc 50% 50% 0V Vcc Input 50% 50% 0V tpHL tpLH Output 90% 50% 10% tr Output Vcc 90% 50% 10% tf tpHL tpLH 90% 50% 10% tf 90% 50% 10% tr 0V Vcc 0V Note: A. CL =50pF ,CL includes probe and jig capacitance. B. All input pulses are supplied by generators having the following characteristics : PRR ≤1MHz, Zo = 50Ω, tr ≤6ns, tf ≤6ns. C. For clock inputs ,fmax is measured when the input duty cycle is 50%. D. tpLH and tpHL are the same as tpd. UTC assumes no responsibility for equipment failures that result from using products at values that exceed, even momentarily, rated values (such as maximum ratings, operating condition ranges, or other parameters) listed in products specifications of any and all UTC products described or contained herein. UTC products are not designed for use in life support appliances, devices or systems where m alfunction of these products can be reasonably expected to result in personal injury. Reproduction in whole or in part is prohibited without the prior written consent of the copyright owner. The information presented in this document does not form part of any quotation or contract, is believed to be accurate and reliable and may be changed without notice. UNISONIC TECHNOLOGIES CO., LTD www.unisonic.com.tw 6 of 6 QW-R502-831.A